arXiv subjects

Hiroyuki Awano

Publications and source records attributed to Hiroyuki Awano.

13 recordsLinked to original sources

arXiv2026

Ternary-composition tuning of the anomalous Nernst effect in amorphous-like Gd-Co-Pt films

We report composition tuning of the anomalous Nernst effect in amorphous-like Gd-Co-Pt ternary films. Pt incorporation into Gd-Co films modifies the anomalous Nernst coefficient and induces a sign reversal of S_ANE, whereas Gd incorporation into Co-Pt films suppresses S_ANE but reduces thermal conductivity. Owing to the balance between transverse thermoelectric response and thermal transport, the heat-flux sensitivity reaches approximately 0.24 {\mu}m/A. Composition maps reveal that the magnitude and heat-flux sensitivity of the anomalous Nernst effect can be systematically tuned in the Gd-Co-Pt ternary composition space. This work extends ANE material design from binary-alloy optimization to ternary-composition engineering.

cond-mat.mtrl-sci↗

arXiv2025

Anomalous Nernst effect in amorphous Tb-Fe-Co thin films

We conducted a comprehensive study on the compositional dependence of the anomalous Nernst effect (ANE) in amorphous (amo.) Tb-Fe-Co thin films. The anomalous Nernst coefficient strongly depends not only on the Tb composition but also on the transition metal composition, reaching a maximum of 1.8 uV/K for amo. Tb11.0(Fe50.0Co50.0) 89.0. By evaluating the electrical and thermoelectric properties, it was clarified that this maximum is achieved by the superposition of two large contributions: S_1 arising from direct transverse electron conduction due to a temperature gradient, and S_2 resulting from the combined Seebeck and anomalous Hall effects. We discovered that the anomalous Nernst conductivity, which is attributed to Berry curvature, varied significantly with the transition metal, even in an amorphous material lacking long-range crystalline order. Our research indicates that it is possible to control the electronic states that influence thermoelectric properties, even in the amorphous state.

cond-mat.mtrl-sci↗

arXiv2025

Efficient spin-orbit torque driven magnetization switching of GdFe using phosphorus-implanted platinum layers

The capability of the spin-orbit torque (SOT) generated via phenomena such as the spin Hall effect in heavy metals, in switching the magnetization of an adjacent magnetic material, has been studied extensively over the last decade. The efficiency of SOT generation is commonly quantified in terms of the spin Hall angle {\theta}_SH. In this work, we demonstrate experimentally that implanting platinum (Pt) with phosphorus (P), resulting in Pt (P) d, where d denotes the implantation dose, increases {\theta}_SH by a factor of 7, from 0.06 (d = 0) to 0.43 (d = 10*10^16 ions/cm^2). The enhanced {\theta}_SH, along with factors such as perpendicular magnetic anisotropy and resistivity, lead to reduction of the critical current density for switching the perpendicular magnetization of ferrimagnetic rare earth-transition metal alloy Gd26Fe74, by a factor of nearly 27, from 4.0*1011 A/m^2 (d = 0) to 1.5*10^10 A/m^2 (d = 10*10^16 ions/cm^2). Further, the switching current density at zero thermal fluctuations and thermal stability factor were evaluated and found to be 2.0*10^10 A/m^2 and 61.4 (d = 10*10^16 ions/cm^2), with the latter being sufficiently above the required threshold for commercial memory applications. Our results suggest that Pt (P) could be a strong candidate in realizing efficient SOT driven magnetization switching leading to the development of improved memory and logic devices in the future.

cond-mat.mtrl-sci↗

arXiv2024

Machine learning-based determination of magnetic parameters from magnetic images with different imaging scales

The determination of material parameters is significantly important in material science, which is often a challenging task. Recently, advancements have shown that magnetic parameters, such as the Dzyaloshinskii-Moriya interaction (DMI), can be estimated from a magnetic domain image using machine learning (ML). This development suggests a potential shift in how magnetic parameters are determined, moving away from traditional measurement techniques to more innovative methods involving image-based inputs processed by ML. In previous studies, the test images used for estimation always matched the training images in size. However, since image size is contingent on the microscopy technique used, the ability to accurately estimate parameters from images of varying sizes is essential. Here, we investigated the feasibility of estimating the DMI constant and saturation magnetization from magnetic domain images of different sizes using ML. We successfully demonstrated that it is possible to estimate these parameters even when the imaging sizes differ between training and test datasets. Additionally, our comparison of the estimation accuracy for the DMI constant and saturation magnetization revealed that the tolerance for differences in image size varies depending on the specific parameter being estimated. These findings could have a significant impact on the future methods of determining magnetic parameters.

cond-mat.mtrl-sci↗

arXiv2024

Significant improvement in sensitivity of an anomalous Nernst heat flux sensor by composite structure

Heat flux sensors (HFS) have attracted significant interest for their potential in managing waste heat efficiently. A recently proposed HFS, that works on the basis of the anomalous Nernst effect (ANE), offers several advantages in its simple structure leading to easy fabrication, low cost, and reduced thermal resistance. However, enhancing sensitivity through traditional material selection is now challenging due to a small number of materials satisfying the required coexistence of a large transverse Seebeck coefficient and low thermal conductivity. In this study, by utilizing composite structures and optimizing the device geometry, we have achieved a substantial improvement in the sensitivity of an ANE-based HFS. We developed composite structures comprised of a plastic substrate with an uneven surface and three-dimensional (3D) uneven TbCo films, fabricated using nanoimprint techniques and sputtering. This approach resulted in a sensitivity that is approximately four times greater than that observed in previous studies. Importantly, this method is independent of the material properties and can significantly enhance the sensitivity. Our findings could lead to the development of highly sensitive HFS devices and open new avenues for the fabrication of 3D devices.

cond-mat.mes-hall↗

arXiv2024

Maximizing bipolar sensitivity for anomalous Nernst thermopiles in heat flux sensing in amorphous GdCo alloys

A Heat Flux Sensor (HFS) facilitates the visualization of heat flow, unlike a temperature sensor, and is anticipated to be a key technology in managing waste heat. Recently, an HFS utilizing the Anomalous Nernst Effect (ANE) has been proposed garnering significant interest in enhancing the transverse Seebeck coefficient. However, ideal materials for HFS not only require a large transverse Seebeck coefficient but also meet several criteria including low thermal conductivity and a bipolar nature of the transverse Seebeck coefficient, especially a negative coefficient. In this study, we have investigated ANE in amorphous ferrimagnetic GdCo alloys, revealing their numerous advantages as HFS materials. These include a large transverse Seebeck coefficient, extremely low thermal conductivity, large negative sensitivity, unparalleled bipolar sensitivity, versatility for deposition on various substrates, and a small longitudinal Seebeck coefficient. These qualities position GdCo films as promising candidates for the advancement of HFS technology.

cond-mat.mtrl-sci↗

arXiv2024

Coexistence of large anomalous Nernst effect and large coercive force in amorphous ferrimagnetic TbCo alloy films

The Anomalous Nernst Effect (ANE) has garnered significant interest for practical applications, particularly in energy harvesting and heat flux sensing. For these applications, it is crucial for the module to operate without an external magnetic field, necessitating a combination of a large ANE and a substantial coercive force. However, most materials exhibiting a large ANE typically have a relatively small coercive force. In our research, we have explored the ANE in amorphous ferrimagnetic TbCo alloy films, noting that the coercive force peaks at the magnetization compensation point (MCP). We observed that transverse Seebeck coefficients are amplified with Tb doping, reaching more than 1.0 uV/K over a wide composition range near the MCP, which is three times greater than that of pure Co. Our findings indicate that this enhancement is primarily due to direct conversion, a product of the transverse thermoelectric component and electrical resistivity. TbCo films present several significant advantages for practical use: a large ANE, the capability to exhibit both positive and negative ANE, the flexibility to be deposited on any substrate due to their amorphous nature, a low thermal conductivity, and a large coercive force. These attributes make TbCo films a promising material for advancing ANE-based technologies.

cond-mat.mes-hall↗

arXiv2023

Observation of anisotropic magneto-inductance effect

We have discovered a new phenomenon that inductance oscillates as a function of the angle between an in-plane magnetic field and an electric current direction in permalloy films, which we have named "the anisotropic magneto-inductance (AML) effect". We have investigated the dependences of the AML effect on the size and voltage. The length, frequency, and amplitude dependences suggest that the AML effect should be evaluated in terms of "inductivity". Inductors based on this AML effect have the potential to be variable, on-chip, and one billion times smaller than the small commercial inductor.

cond-mat.mes-hall↗

arXiv2020

Observation of spin-motive force in ferrimagnetic GdFeCo alloy films

Non-uniform magnetic structures produce emergent electromagnetic phenomena such as the topological Hall effect and the spin-motive force (SMF). The experimental reports on the SMF, however, are very few and the relationship between the SMF and material parameters is still unclear. In this study, we investigated the SMF in ferrimagnetic GdFeCo alloy films using the spin-torque-induced ferromagnetic resonance method and clarified the relationship. The amplitude of the detected SMF becomes larger than that of the transition metal alloy FeCo by the Gd doping and reaches the maximum near a Gd composition of the boundary between in-plane and perpendicularly magnetized films. According to the analytical calculation, the enhancement is related to the trajectory of the magnetization precession. Moreover, we find that the SMF induced by the magnetic resonance is inversely proportional to the square of the damping constant.

cond-mat.mtrl-sci↗

arXiv2018

Long spin coherence length and bulk-like spin-orbit torque in ferrimagnetic multilayers

Ferromagnetic spintronics has been a main focus as it offers non-volatile memory and logic applications through current-induced spin-transfer torques. Enabling wider applications of such magnetic devices requires a lower switching current for a smaller cell while keeping the thermal stability of magnetic cells for non-volatility. As the cell size reduces, however, it becomes extremely difficult to meet this requirement with ferromagnets because spin-transfer torque for ferromagnets is a surface torque due to rapid spin dephasing, leading to the 1/ferromagnet-thickness dependence of the spin-torque efficiency. Requirement of a larger switching current for a thicker and thus more thermally stable ferromagnetic cell is the fundamental obstacle for high-density non-volatile applications with ferromagnets. Theories predicted that antiferromagnets have a long spin coherence length due to the staggered spin order on an atomic scale, thereby resolving the above fundamental limitation. Despite several spin-torque experiments on antiferromagnets and ferrimagnetic alloys, this prediction has remained unexplored. Here we report a long spin coherence length and associated bulk-like-torque characteristic in an antiferromagnetically coupled ferrimagnetic multilayer. We find that a transverse spin current can pass through > 10 nm-thick ferrimagnetic Co/Tb multilayers whereas it is entirely absorbed by 1 nm-thick ferromagnetic Co/Ni multilayer. We also find that the switching efficiency of Co/Tb multilayers partially reflects a bulk-like-torque characteristic as it increases with the ferrimagnet-thickness up to 8 nm and then decreases, in clear contrast to 1/thickness-dependence of Co/Ni multilayers. Our results on antiferromagnetically coupled systems will invigorate researches towards energy-efficient spintronic technologies.

cond-mat.mtrl-sci↗

arXiv2018

Interference induced enhancement of magneto-optical Kerr effect in ultrathin magnetic films

We have studied the magneto-optical spectra of ultrathin magnetic films deposited on Si substrates coated with an oxide layer (SiOx). We find that the Kerr rotation angle and the ellipticity of ~1 nm thick CoFeB thin films, almost transparent to visible light, show a strong dependence on the thickness of the SiOx layer. The Kerr signal from the 1 nm CoFeB thin film can be larger than that of ~100 nm thick CoFeB films for a given SiOx thickness and light wavelength. The enhancement of the Kerr signal occurs when optical interference takes place within the SiOx layer. Interestingly, under such resonance condition, the measured Kerr signal is in some cases larger than the estimation despite the good agreement of the measured and calculated reflection amplitude. We infer the discrepancy originates from interface states that are distinct from the bulk characteristics. These results show that optical interference effect can be utilized to study the magneto-optical properties of ultrathin films.

cond-mat.mes-hall↗

arXiv2012

CoB/Ni-Based Multilayer Nanowire with High-Speed Domain Wall Motion under Low Current Control

The spin-transfer torque motion of magnetic domain walls (DWs) in a CoB/Ni-based nanowire driven by a low current density of (1.12\pm0.8)\times10^{11} A m^{-2} has been observed indirectly by magnetotransport measurements. A high DW velocity of 85\pm4 m/s at zero field was measured at the threshold current density. Upon increasing the current density to 2.6\times10^{11} A m^{-2}, the DW velocity increases to 197\pm16 m/s before decreasing quickly in the high-current-density regime attributed to nonadiabatic spin-transfer torque at a low damping factor and weak pinning. The addition of B atoms to the Co layers decreased the magnitude of saturation magnetization, Gilbert damping factor, and density of pinning sites, making the CoB/Ni multilayer nanowire favorable for practical applications.

cond-mat.mtrl-sci↗

arXiv2011

Modulation of domain wall dynamics in TbFeCo single layer nanowire

We demonstrate the possibility to write and modulate the magnetic domain walls in a TbFeCo single layer nanowire (300 nm width, 150 $μ$m length). To realize this, a tiny magnetic domain was nucleated by an Oersted field produced by a 1.6 MHz pulse current (35 mA in amplitude, 5-40 ns in length) crossed the wire. To write the wall to the wire, a DC current was used to drive the nucleated domain (with two walls in two sides) to the wire in accordance with spin-transfer torque mechanism. A critical current density of $J_c = 3.5\times10^{10} Am^{-2}$ was required to control the motion of the walls in the wire. It was found that the size of the domain moving in the wire could be adjusted by either external field or the length of the nucleated pulse current. This could be considered as an important note for writing process in domain wall spin-torque devices, especially, memory elements.

cond-mat.mtrl-sci↗