arXiv Science⌕ Search

arXiv · 2609.31534

Generation of 10-TW Attosecond X-Ray Pulses in a Free Electron Laser

Abstract

Attosecond pulses provide direct access to electron dynamics in atoms, molecules, and solids on their natural timescales. While table-top sources have achieved attosecond pulse durations at moderate intensities, extending attosecond science to high peak powers in the x-ray regime requires free-electron lasers (FELs). Here we report the generation of soft-x-ray pulses with a duration of $\sim\!100$ as and peak power on the order of 10 TW at the European XFEL. The unprecedented combination of pulse duration and peak power is enabled by operation of a soft-x-ray undulator at high electron energy together with five-stage bunch compression, producing ultrahigh peak currents. These millijoule-level attosecond x-ray pulses establish a new regime for attosecond science.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

E. A. Schneidmiller, S. Serkez, I. Zagorodnov, N. Gerasimova, M. Scholz, N. Golubeva, M. Guetg, G. Geloni, S. Karabekyan, F. Sottocorona, A. Trebushinin, G. Perosa, S. Tomin, F. Mayet, Th. Maltezopoulos, J. Gruenert, J. Laksman, H. Ahmadi Rashtabadi, T. M. Baumann, R. Boll, F. Calegari, G. Catacchio, S. Dold, D. E. Ferreira de Lima, L. Funke, W. Helml, M. Ilchen, T. Mazza, M. Meyer, T. Mullins, M. Robinson, S. Savio, K. Scharei, Ph. Schmidt, A. Thiel, S. Usenko, L. Wuelfing, W. Decking. 2026-09-25. Generation of 10-TW Attosecond X-Ray Pulses in a Free Electron Laser. https://arxiv.org/abs/2609.31534

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

Noninvasive ion fraction quantification of dual-species beams in synchrotrons

The ion composition of dual-species beams in synchrotrons is typically inferred from invasive measurements performed after beam extraction. This paper introduces a complementary noninvasive method to determine the ion composition of such beams directly inside the synchrotron. The approach is applicable to low- and medium-energy ion synchrotrons and to small relative mass-to-charge ratio offsets, typically at the 1e-4 level. The method exploits dispersive orbit offsets between the two species and corresponding frequency corrections applied by the synchrotron RF radial regulation loop. This capability is of particular interest for ongoing research on online monitoring in carbon ion beam therapy using mixed 4He2+ and 12C6+ beams, which feature a relative mass-to-charge ratio offset of 0.065%. The proposed method is analytically derived and tested with particle tracking simulations using Xsuite. Its applicability under realistic experimental conditions is demonstrated at the MedAustron facility using mixed 4He2+ and 12C6+ beams. The results show good agreement with independent post-extraction measurements.

physics.acc-ph↗

Design and Operation of a 3-Crystal Multi-Volume Reflection Array for Loss Reduction in CERN SPS Slow Extraction

The flux of protons slow-extracted from the CERN Super Proton Synchrotron (SPS) to the North Area experiments is limited by the induced radioactivity of the beam lost on the electrostatic septum during the third-integer resonant extraction. Crystal shadowing, in which a thin bent silicon crystal deflects the portion of beam that would otherwise impinge on the septum wires, has been in operation at the SPS since 2021, and a single crystal at a non-local position halved the extraction losses, short of the fourfold reduction that the activation budget of the future high-intensity operation calls for. In this paper, the design, deployment and operation of a 3-crystal Multi-Volume Reflection Array (MVRA) at the non-local position in the fourth long straight section (LSS4) are presented. The array geometry was designed by Multi-Fidelity Bayesian Optimization (MFBO), combining a multilayer-perceptron surrogate with full particle tracking, which predicts a fourfold loss reduction with three crystals and up to tenfold with an ideally aligned array of four to five. Measurements with beam confirm the prediction: at its optimum the as-built array reduces the losses by the predicted factor of four, and beam dynamics simulations matched to the measured position and angle scans reproduce them to a few per cent. The array has since been used in physics production, held on its operating plateau by an extremum-seeking controller, with a median loss reduction by a factor of 3.6 over 0.1 million extraction cycles relative to the pre-shadowing baseline. The remaining margin to the target, the limitations of the present installation and the upgrade to a 4- or 5-crystal array are discussed.

physics.acc-ph↗

Vector Potential-based Beam Current Sensors: Applications for Mu2e, and Picosecond Bunch Substructure

We report on a new beam current monitor system based on work originally done to develop timing planes for future collider detectors. In contrast to sensors based on wall currents or toroid inductance, we make use of electric field induced by the electromagnetic vector potential of the beam current as it passes near or through a transmission line (TL), arranged with its dominant TEM or TE10 fields aligned with the current, thus directly coupling to TL modes. For resonantly extracted proton pulses currently being commissioned at the Fermilab Delivery Ring, we utilized a TEM parallel-plate TL geometry, since the requirements included measuring the structure of the bunch over $\sim{}200~\rm{ns}$ time scales. We present the design and results of simulated and realized sensors now deployed at Fermilab for future use as pulse-to-pulse proton intensity monitors at the Mu2e experiment. In addition, inspired by this and prior work, we investigate the use of broadband mm-wave dual-ridge waveguides as a means of measuring substructure of nanosecond bunches down to the tens of picosecond level for future use at the Long Baseline Neutrino Facility (LBNF).

physics.acc-ph↗