Design and Operation of a 3-Crystal Multi-Volume Reflection Array for Loss Reduction in CERN SPS Slow Extraction

Abstract

The flux of protons slow-extracted from the CERN Super Proton Synchrotron (SPS) to the North Area experiments is limited by the induced radioactivity of the beam lost on the electrostatic septum during the third-integer resonant extraction. Crystal shadowing, in which a thin bent silicon crystal deflects the portion of beam that would otherwise impinge on the septum wires, has been in operation at the SPS since 2021, and a single crystal at a non-local position halved the extraction losses, short of the fourfold reduction that the activation budget of the future high-intensity operation calls for. In this paper, the design, deployment and operation of a 3-crystal Multi-Volume Reflection Array (MVRA) at the non-local position in the fourth long straight section (LSS4) are presented. The array geometry was designed by Multi-Fidelity Bayesian Optimization (MFBO), combining a multilayer-perceptron surrogate with full particle tracking, which predicts a fourfold loss reduction with three crystals and up to tenfold with an ideally aligned array of four to five. Measurements with beam confirm the prediction: at its optimum the as-built array reduces the losses by the predicted factor of four, and beam dynamics simulations matched to the measured position and angle scans reproduce them to a few per cent. The array has since been used in physics production, held on its operating plateau by an extremum-seeking controller, with a median loss reduction by a factor of 3.6 over 0.1 million extraction cycles relative to the pre-shadowing baseline. The remaining margin to the target, the limitations of the present installation and the upgrade to a 4- or 5-crystal array are discussed.