Low Distortion Fusion Bonding using Pneumatically Warped Wafers

Abstract

Backside power-delivery-network (BSPDN) schemes require wafer-to-wafer bonding steps that do not leave high order shape changes or localized stresses in the bonded stack to ensure that these don't get transferred to the thinned wafer for further lithographic exposure. However, bonding mechanics involve strong adhesive forces which can inherently create localized distortions that lithography tools must eventually compensate. Some contributors to grid distortion of the target wafer are, method of bond initiation, bond front velocity variations, and lack of symmetry between the wafers. In this work, we evaluate a low-distortion bonding approach in the SUSS XBA tool, where some of these contributors are tackled at the source, namely by initiating the bond without a localized external force, and keeping the wafers compliant & symmetric during bonding. Wafers are bonded with a slight pre-stress due to controlled gas pressure applied over the whole backside of the wafers throughout bonding. Wafer-shape measurements of the bonded stacks are used to perform gradient-based in-plane-displacements (IPD) modelling to estimate bonding-induced grid distortion. Dense scanner metrology is used on patterned-bonded wafers to confirm the location and severity of distortion predictions from patterned wafer geometry (PWG) measurements. On the PWG distortion maps and scanner grid readouts, we perform alignment and CPE modelling with different field layouts. Sub-10 nm levels of residual grid distortion are achievable with relatively low-order correction models, and less than or equal to 3 nm by using advanced CPE models. These results demonstrate that pneumatically warped bonding yields low-distortion bonded stacks, and that simple process tuning can decouple the dominant distortion source from edge-related variability.