arXiv subjects

Zhu Jin

Publications and source records attributed to Zhu Jin.

6 recordsLinked to original sources

arXiv2026

SuperSuit: An Isomorphic Bimodal Interface for Scalable Mobile Manipulation

High-quality, long-horizon demonstrations are essential for embodied AI, yet acquiring such data for tightly coupled wheeled mobile manipulators remains a fundamental bottleneck. Unlike fixed-base systems, mobile manipulators require continuous coordination between $SE(2)$ locomotion and precise manipulation, exposing limitations in existing teleoperation and wearable interfaces. We present \textbf{SuperSuit}, a bimodal data acquisition framework that supports both robot-in-the-loop teleoperation and active demonstration under a shared kinematic interface. Both modalities produce structurally identical joint-space trajectories, enabling direct data mixing without modifying downstream policies. For locomotion, SuperSuit maps natural human stepping to continuous planar base velocities, eliminating discrete command switches. For manipulation, it employs a strictly isomorphic wearable arm in both modes, while policy training is formulated in a shift-invariant delta-joint representation to mitigate calibration offsets and structural compliance without inverse kinematics. Real-world experiments on long-horizon mobile manipulation tasks show 2.6$\times$ higher demonstration throughput in active mode compared to a teleoperation baseline, comparable policy performance when substituting teleoperation data with active demonstrations at fixed dataset size, and monotonic performance improvement as active data volume increases. These results indicate that consistent kinematic representations across collection modalities enable scalable data acquisition for long-horizon mobile manipulation.

cs.RO↗

arXiv2024

Highly coherent grain boundaries induced by local pseudo-mirror symmetry in $\beta$-Ga2O3

Grain boundaries have extensive influence on the performance of crystal materials. However, the atomic-scale structure and its relation with local and crystallographic symmetries remain elusive in low-symmetry crystals. Herein, we find that the local pseudo-mirror-symmetric atomic layer is the common physical origin of a series of highly coherent grain boundaries in the low-symmetry $\beta$-Ga2O3 crystal. These include the (100) twin boundary and an emerging series of $(h-1'0'2)/(h+1'0'\bar{2})$ coherent asymmetric grain boundaries (CAGBs). Owing to the local pseudo-mirror symmetry and the special geometric relation of the $\beta$-Ga2O3 conventional cell, these CAGBs place 80% of the boundary atoms in pseudo-coincident sites, exhibiting high coherence under the coincident-site lattice model. With a combination of density functional theory calculations, Czochralski growth experiment, and atomic-scale characterizations, the structure and stability of the $(002)/(20\bar{2})$-A CAGB are confirmed, with a boundary energy density as low as 0.36 J/m2. This CAGB is responsible for the spontaneous formation of a twinned defect facet at the surface steps during the epitaxy growth of $\beta$-Ga2O3, warranting a substrate orientation selection rule for $\beta$-Ga2O3. Through this study, we provide insights into the grain boundary physics in the low-symmetry $\beta$-Ga2O3 crystal while emphasizing the importance of the local pseudo-symmetries in the low-symmetry crystals.

cond-mat.mtrl-sci↗

arXiv2021

P3FA: Unified Unicast/Multicast Forwarding with Low Egress Diversities

Multicast is an efficient way to realize one-to-many group communications in large-scale networks such as the Internet. However, the deployment of IP multicast services over the Internet has not been as rapid as expected and needed. Excepting the fatal defects in designing IPv4 address structure. Another main reason that contributes to this slow deployment is the lack of carrier-grade multicast-enabled switches and routers that can be as to scale as their unicast counterparts. Implementing a high-performance switch/router relies on a polynomial-time group membership query algorithm within the Packet Forwarding Engines (PFEs) to determine whether or not a packet is forwarded through an egress. Among these, Bloom filter (BF)-based and Residue Number System (RNS)-based are being considered as two representations of the membership query algorithms. However, both approaches suffer from some fatal weaknesses such as space and time inefficiencies, especially for a carrier-grade PFE with high port-density features. According to similar properties of the prime theorem, we propose a simplified forwarding scheme in this paper, named Per-Port Prime Filter Array (P3FA). The simulation results indicate that the P3FA can significantly improve space efficiencies under specific lower egress-diversities conditions. Under the same space constraints, compared with the SVRF, the multicast time efficiencies, the unicast time efficiency of the P3FA are respectively increased by 12x-17234x and 19x-2038x at a range of port-densities 16-1024, but at the expense of hardware cost, which increased by \r{ho}/2x. A PFE designer that attempts to adopt P3FA should trade-off between required performance and cost.

cs.NI↗

arXiv2021

Robotic Electrospinning Actuated by Non-Circular Joint Continuum Manipulator for Endoluminal Therapy

Electrospinning has exhibited excellent benefits to treat the trauma for tissue engineering due to its produced micro/nano fibrous structure. It can effectively adhere to the tissue surface for long-term continuous therapy. This paper develops a robotic electrospinning platform for endoluminal therapy. The platform consists of a continuum manipulator, the electrospinning device, and the actuation unit. The continuum manipulator has two bending sections to facilitate the steering of the tip needle for a controllable spinning direction. Non-circular joint profile is carefully designed to enable a constant length of the centreline of a continuum manipulator for stable fluid transmission inside it. Experiments are performed on a bronchus phantom, and the steering ability and bending limitation in each direction are also investigated. The endoluminal electrospinning is also fulfilled by a trajectory following and points targeting experiments. The effective adhesive area of the produced fibre is also illustrated. The proposed robotic electrospinning shows its feasibility to precisely spread more therapeutic drug to construct fibrous structure for potential endoluminal treatment.

cs.RO↗

arXiv2020

FBG-Based Triaxial Force Sensor Integrated with an Eccentrically Configured Imaging Probe for Endoluminal Optical Biopsy

Accurate force sensing is important for endoluminal intervention in terms of both safety and lesion targeting. This paper develops an FBG-based force sensor for robotic bronchoscopy by configuring three FBG sensors at the lateral side of a conical substrate. It allows a large and eccentric inner lumen for the interventional instrument, enabling a flexible imaging probe inside to perform optical biopsy. The force sensor is embodied with a laser-profiled continuum robot and thermo drift is fully compensated by three temperature sensors integrated on the circumference surface of the sensor substrate. Different decoupling approaches are investigated, and nonlinear decoupling is adopted based on the cross-validation SVM and a Gaussian kernel function, achieving an accuracy of 10.58 mN, 14.57 mN and 26.32 mN along X, Y and Z axis, respectively. The tissue test is also investigated to further demonstrate the feasibility of the developed triaxial force sensor

physics.app-ph↗

arXiv2013

High-quality Image Restoration from Partial Mixed Adaptive-Random Measurements

A novel framework to construct an efficient sensing (measurement) matrix, called mixed adaptive-random (MAR) matrix, is introduced for directly acquiring a compressed image representation. The mixed sampling (sensing) procedure hybridizes adaptive edge measurements extracted from a low-resolution image with uniform random measurements predefined for the high-resolution image to be recovered. The mixed sensing matrix seamlessly captures important information of an image, and meanwhile approximately satisfies the restricted isometry property. To recover the high-resolution image from MAR measurements, the total variation algorithm based on the compressive sensing theory is employed for solving the Lagrangian regularization problem. Both peak signal-to-noise ratio and structural similarity results demonstrate the MAR sensing framework shows much better recovery performance than the completely random sensing one. The work is particularly helpful for high-performance and lost-cost data acquisition.

cs.IT↗