arXiv subjects

V. Puill

Publications and source records attributed to V. Puill.

6 recordsLinked to original sources

arXiv2026

Operation and performance of the Probe for Luminosity Measurement at LHCb

The Probe for LUminosity MEasurement (PLUME) detector is a dedicated luminosity monitor at the LHCb interaction point. It is a hodoscope comprising 48 Hamamatsu R760 photomultiplier tubes that detect Cherenkov light produced by particles travelling in the direction opposite to the LHCb spectrometer acceptance. PLUME provides real-time, bunch-by-bunch luminosity measurements during LHCb data taking and serves as the primary detector for controlling the luminosity levelling process at LHCb. In addition, its data are used offline, together with other dedicated counters from LHCb sub-systems, to determine the integrated luminosity delivered to the experiment. This paper reports on the detector's operational performance during the 2024-2026 data-taking period of Run 3. The integrated luminosity recorded by the LHCb experiment in $pp$ collisions at $\sqrt{s} = 13.6$ TeV during this period, as measured by the PLUME online luminosity counters for detector performance monitoring, amounts to $\mathcal{L} = (26.71 \pm 1.07)$ fb$^{-1}$. The luminosity values used in physics analyses are determined separately through dedicated offline calibrations based on van der Meer scans and Beam Gas Imaging techniques, and will be reported in a dedicated publication, as they are beyond the scope of this paper.

hep-ex↗

arXiv2026

Performance characterisation of the Hamamatsu R760 photomultiplier tube for the PLUME detector

The Probe for Luminosity Measurement detector is a novel luminometer designed to monitor the luminosity and beam conditions of the Large Hadron Collider at the interaction point of the LHCb experiment, starting from Run 3. The detector is based on a hodoscope composed of 48 Hamamatsu R760 photomultiplier tubes, which detect the Cherenkov light produced by charged particles originating from the interaction region. The accurate and stable operation of these sensors is essential to ensure reliable luminosity measurements throughout the full data-taking period. This paper presents a detailed characterisation of the photomultiplier tubes currently installed in the detector. In particular, their absolute gain, transit-time drift, linearity, dark current, and ageing behaviour are systematically studied under controlled laboratory conditions. The results provide a comprehensive assessment of the performance of the detection modules and establish the optimal operating conditions required to ensure stable and precise measurements throughout Run 3 and Run 4.

physics.ins-det↗

arXiv2022

Multiple scattering of channeled and non-channeled positively charged particles in bent monocrystalline silicon

We present the results of an experimental study of multiple scattering of positively charged high energy particles in bent samples of monocrystalline silicon. This work confirms the recently discovered effect of a strong reduction in the rms multiple scattering angle of particles channeled in the silicon (111) plane. The effect is observed in the plane orthogonal to the bending plane. We show in detail the influence of angular constraints on the magnitude of the effect. Comparison of the multiple scattering process at different energies indicates a violation of the law of inverse proportionality of the rms angle of channeled particles with energy. By increasing the statistics, we have improved the results of multiple scattering measurements for particles moving, but not channeled, in silicon crystals.

physics.acc-ph↗

arXiv2021

Double-crystal measurements at the CERN SPS

The UA9 setup, installed in the Super Proton Synchrotron (SPS) at CERN, was exploited for a proof of principle of the double-crystal scenario, proposed to measure the electric and the magnetic moments of short-lived baryons in a high-energy hadron collider, such as the Large Hadron Collider (LHC). Linear and angular actuators were used to position the crystals and establish the required beam configuration. Timepix detectors and high-sensitivity Beam Loss Monitors were exploited to observe the deflected beams. Linear and angular scans allowed exploring the particle interactions with the two crystals and recording their efficiency. The measured values of the beam trajectories, profiles and of the channeling efficiency agree with the results of a Monte-Carlo simulation.

physics.acc-ph↗

arXiv2019

Double-crystal setup measurements at the CERN SPS

In this paper, we discuss an experimental layout for the two-crystals scenario at the Super Proton Synchrotron (SPS) accelerator. The research focuses on a fixed target setup at the circulating machine in a frame of the Physics Beyond Colliders (PBC) project at CERN. The UA9 experiment at the SPS serves as a testbench for the proof of concept, which is planning to be projected onto the Large Hadron Collider (LHC) scale. The presented in the text configuration was used for the quantitative characterization of the deflected particle beam by a pair of bent silicon crystals. For the first time in the double-crystal configuration, a particle deflection efficiency by the second crystal of $0.188 \pm 3 \cdot 10^{-5}$ and $0.179 \pm 0.013$ was measured on the accelerator by means of the Timepix detector and Beam Loss Monitor (BLM) respectively. In this setup, a wide range angular scan allowed a possibility to \textit{in situ} investigate different crystal working regimes (channeling, volume reflection, etc.), and to measure a bent crystal torsion.

physics.acc-ph↗

arXiv2019

Commissioning and operation of the Cherenkov detector for proton Flux Measurement of the UA9 Experiment

The UA9 Experiment at CERN-SPS investigates channeling processes in bent silicon crystals with the aim to manipulate hadron beams. Monitoring and characterization of channeled beams in the high energy accelerators environment ideally requires in-vacuum and radiation hard detectors. For this purpose the Cherenkov detector for proton Flux Measurement (CpFM) was designed and developed. It is based on thin fused silica bars in the beam pipe vacuum which intercept charged particles and generate Cherenkov light. The first version of the CpFM is installed since 2015 in the crystal-assisted collimation setup of the UA9 experiment. In this paper the procedures to make the detector operational and fully integrated in the UA9 setup are described. The most important standard operations of the detector are presented. They have been used to commission and characterize the detector, providing moreover the measurement of the integrated channeled beam profile and several functionality tests as the determination of the crystal bending angle. The calibration has been performed with Lead (Pb) and Xenon (Xe) beams and the results are applied to the flux measurement discussed here in detail.

physics.ins-det↗