RF-Resolved RIN Engineering of High-Power CW Yb Fiber Laser Architectures Using Seed Topology, Seed Power, Pumping Geometry and Cavity FSR
We report, to the best of our knowledge, the first controlled, like-for-like experimental mapping of how four practical design parameters--seed-cavity topology, seed power, amplifier pumping geometry, and seed-cavity free spectral range (FSR)--jointly shape the radio-frequency (RF)-resolved relative intensity noise (RIN) of high-power continuous-wave (CW) Yb-doped fiber lasers. We compare a standalone bidirectional fiber Bragg grating (FBG) oscillator, an FBG-seeded master-oscillator power amplifier (MOPA), and unidirectional ring-seeded MOPAs with FSRs of approximately 11.5 and 5 MHz, all near 1064 nm at a common 72 W output, with RIN measured from 10 kHz to 1 GHz. Across all settings, the low-frequency RIN is technical-noise limited and nearly architecture-independent, whereas RIN above 160 kHz is governed by the seed-cavity topology and its transfer through the amplifier. Higher seed power suppresses the mid- and high-frequency RIN, but the seed-alone and amplified-output comparison reveals opposite transfer for the two topologies: for FBG seeding the 2 MHz-1 GHz RMS RIN increases through amplification (3.66 percent to 4.14 percent at 15 W seed), whereas for ring seeding it decreases (1.47 percent to 1.35 percent). Forward pumping gives the best power-scaling/noise trade-off, while reducing the ring FSR from approximately 11.5 to 5 MHz preserves the high-frequency RIN advantage, confirming it is not a mode-spacing effect. At matched conditions, ring seeding lowers the integrated RMS RIN by 2-3 times (160 kHz-2 MHz) and approximately 3 times (2 MHz-1 GHz, approximately 9-10 dB to near -127.4 dBc/Hz). These results yield band-resolved design rules linking each band to its dominant lever. The unidirectional ring-seeded MOPA thus offers a simple, scalable route to broadband pump-RIN suppression for nonlinear and frequency-conversion photonics.