arXiv subjects

S. Obata

Publications and source records attributed to S. Obata.

4 recordsLinked to original sources

arXiv2017

The SeaQuest Spectrometer at Fermilab

The SeaQuest spectrometer at Fermilab was designed to detect oppositely-charged pairs of muons (dimuons) produced by interactions between a 120 GeV proton beam and liquid hydrogen, liquid deuterium and solid nuclear targets. The primary physics program uses the Drell-Yan process to probe antiquark distributions in the target nucleon. The spectrometer consists of a target system, two dipole magnets and four detector stations. The upstream magnet is a closed-aperture solid iron magnet which also serves as the beam dump, while the second magnet is an open aperture magnet. Each of the detector stations consists of scintillator hodoscopes and a high-resolution tracking device. The FPGA-based trigger compares the hodoscope signals to a set of pre-programmed roads to determine if the event contains oppositely-signed, high-mass muon pairs.

physics.ins-det↗

arXiv2006

Phase Transition of Extrinsic Curvature Surface Model on a Disk

An extrinsic curvature surface model is investigated by Monte Carlo simulations on a disk. We found that the model undergoes a first-order transition separating the smooth phase from the collapsed phase. The results in this paper together with the previous ones suggest that the order of the transition is independent of whether the surface is compact (closed) or non-compact (open).

cond-mat.stat-mech↗

arXiv2006

Phase transitions of an intrinsic curvature model on dynamically triangulated spherical surfaces with point boundaries

An intrinsic curvature model is investigated using the canonical Monte Carlo simulations on dynamically triangulated spherical surfaces of size upto N=4842 with two fixed-vertices separated by the distance 2L. We found a first-order transition at finite curvature coefficient α, and moreover that the order of the transition remains unchanged even when L is enlarged such that the surfaces become sufficiently oblong. This is in sharp contrast to the known results of the same model on tethered surfaces, where the transition weakens to a second-order one as L is increased. The phase transition of the model in this paper separates the smooth phase from the crumpled phase. The surfaces become string-like between two point-boundaries in the crumpled phase. On the contrary, we can see a spherical lump on the oblong surfaces in the smooth phase. The string tension was calculated and was found to have a jump at the transition point. The value of σis independent of L in the smooth phase, while it increases with increasing L in the crumpled phase. This behavior of σis consistent with the observed scaling relation σ\sim (2L/N)^ν, where ν\simeq 0 in the smooth phase, and ν=0.93\pm 0.14 in the crumpled phase. We should note that a possibility of a continuous transition is not completely eliminated.

cond-mat.stat-mech↗

arXiv2006

Phase transition of triangulated spherical surfaces supported by elastic chains with rigid junctions

A surface model with skeletons is investigated by using the canonical Monte Carlo simulations. The skeleton is composed of linear chains, which are joined to each other at the rigid junctions. A one-dimensional bending energy is defined on the linear chains, and no two-dimensional curvature energy is assumed on the surface. The model undergoes a first-order transition between the smooth phase and the crumpled phase. We conclude that the first-order transition of the surface model with skeletons is independent of whether the junctions are elastic or rigid.

cond-mat.stat-mech↗