arXiv subjects

S. Gallorini

Publications and source records attributed to S. Gallorini.

8 recordsLinked to original sources

arXiv2021

Characterisation of signal-induced noise in Hamamatsu R11265 Multianode Photomultiplier Tubes

Signal-induced noise is observed in Hamamatsu R11265 Multianode Photomultiplier Tubes, manifesting up to several microseconds after the single photoelectron response signal and localised in specific anodes. The mean number of noise pulses varies between devices, and shows significant dependence on the applied high-voltage. The characterisation of this noise and the mitigation strategies to perform optimal single-photon counting at 40 MHz, as required by the LHCb Ring-Imaging Cherenkov detectors, are reported.

physics.ins-det↗

arXiv2018

Search for $K^{+}\rightarrowπ^{+}ν\overlineν$ at NA62

$K^{+}\rightarrowπ^{+}ν\overlineν$ is one of the theoretically cleanest meson decay where to look for indirect effects of new physics complementary to LHC searches. The NA62 experiment at CERN SPS is designed to measure the branching ratio of this decay with 10\% precision. NA62 took data in pilot runs in 2014 and 2015 reaching the final designed beam intensity. The quality of 2015 data acquired, in view of the final measurement, will be presented.

hep-ex↗

arXiv2016

ChPT tests at the NA48 and NA62 experiments at CERN

The NA48/2 Collaboration at CERN has accumulated unprecedented statistics of rare kaon decays in the Ke4 modes: Ke4(+-) ($K^\pm \to π^+ π^- e^\pm ν$) and Ke4(00) ($K^\pm \to π^0 π^0 e^\pm ν$) with nearly one percent background contamination. The detailed study of form factors and branching rates, based on these data, has been completed recently. The results brings new inputs to low energy strong interactions description and tests of Chiral Perturbation Theory (ChPT) and lattice QCD calculations. In particular, new data support the ChPT prediction for a cusp in the $π^0π^0$ invariant mass spectrum at the two charged pions threshold for Ke4(00) decay. New final results from an analysis of about 400 $K^\pm \to π^\pm γγ$ rare decay candidates collected by the NA48/2 and NA62 experiments at CERN during low intensity runs with minimum bias trigger configurations are presented. The results include a model-independent decay rate measurement and fits to ChPT description.

hep-ex↗

arXiv2014

Prospects for $K^+ \to π^+ ν\bar{ ν}$ at CERN in NA62

The NA62 experiment will begin taking data in 2015. Its primary purpose is a 10% measurement of the branching ratio of the ultrarare kaon decay $K^+ \to π^+ ν\bar{ ν}$, using the decay in flight of kaons in an unseparated beam with momentum 75 GeV/c.The detector and analysis technique are described here.

hep-ex↗

arXiv2014

Recent NA48/2 and NA62 results

The NA48/2 Collaboration at CERN has accumulated and analysed unprecedented statistics of rare kaon decays in the $K_{e4}$ modes: $K_{e4}(+-)$ ($K^\pm \to π^+ π^- e^\pm ν$) and $K_{e4}(00)$ ($K^\pm \to π^0 π^0 e^\pm ν$) with nearly one percent background contamination. It leads to the improved measurement of branching fractions and detailed form factor studies. New final results from the analysis of 381 $K^\pm \to π^\pm γγ$ rare decay candidates collected by the NA48/2 and NA62 experiments at CERN are presented. The results include a decay rate measurement and fits to Chiral Perturbation Theory (ChPT) description.

hep-ex↗

arXiv2012

The large-angle photon veto system for the NA62 experiment at the CERN SPS

The branching ratio (BR) for the decay K^+ \to π^+ν\barν is a sensitive probe for new physics. The NA62 experiment at the CERN SPS will measure this BR to within about 10%. To reject the background from dominant kaon decays with final state photons, the large-angle photon vetoes (LAVs) must detect photons of energy as low as 200 MeV with an inefficiency of less than 10^{-4}. The LAV detectors make use of lead glass blocks recycled from the OPAL electromagnetic calorimeter barrel. We describe the mechanical design and challenges faced during construction, the characterization of the lead glass blocks and solutions adopted for monitoring their performance, and the development of front-end electronics to allow simultaneous time and energy measurements over an extended dynamic range using the time over-threshold technique. Our results are based on test-beam data and are reproduced by a detailed Monte Carlo simulation that includes the readout chain.

physics.ins-det↗

arXiv2011

The NA62 LAV front-end electronics

The branching ratio for the decay $K^+ \to π^+ν\barν$ is sensitive to new physics; the NA62 experiment will measure it to within about 10%. To reject the dominant background from channels with final state photons, the large-angle vetoes (LAVs) must detect particles with better than 1 ns time resolution and 10% energy resolution over a very large energy range. Our custom readout board uses a time-over-threshold discriminator coupled to a TDC as a straightforward solution to satisfy these requirements. A prototype of the readout system was extensively tested together with the ANTI-A2 large angle veto module at CERN in summer 2010.

physics.ins-det↗

arXiv2011

The Large-Angle Photon Veto System for the NA62 Experiment at CERN

The branching ratio (BR) for the decay K^+ \rightarrow π^+ ν\barν is a sensitive probe for new physics. The NA62 experiment at the CERN SPS will measure this BR to within about 10%. To reject the dominant background from channels with final state photons, the large-angle vetoes (LAVs) must detect photons of energy as low as 200 MeV with an inefficiency of less than 10^-4, as well as provide energy and time measurements with resolutions of 10% and 1 ns for 1 GeV photons. The LAV detectors make creative reuse of lead glass blocks recycled from the OPAL electromagnetic calorimeter barrel. We describe the mechanical design and challenges faced during construction, the characterization of the lead glass blocks and solutions adopted for monitoring their performance, and the development of front-end electronics to allow simultaneous time and energy measurements over an extended dynamic range using the time-over-threshold technique. Our results are based on test-beam data and are reproduced by a detailed Monte Carlo simulation that includes the readout chain.

physics.ins-det↗