arXiv ScienceSearch

arXiv subjects

S. Dutt

Publications and source records attributed to S. Dutt.

2 recordsLinked to original sources

Coexisting single-particle excitations and octupole correlations in transitional nucleus $\mathbf{^{217}Ra}$

The level structure of the transitional nucleus $\mathrm{^{217}Ra}$ has been extended with the addition of around 20 new transitions. The discrepancies between the placements of several transitions reported in the earlier studies are resolved. The newly-established negative-parity sequence at low excitation energies hints at the expected parity-doublet structures in this nucleus. The properties of the observed simplex bands are compared with that of similar bands in neighboring nuclei. Since the presence of parity-doublet structures reflect octupole correlations, theoretical calculations using reflection-asymmetric triaxial particle rotor model (RAT-PRM) have been performed. A comparison of the observed features of the simplex bands with the predictions of the RAT-PRM calculations suggests that $\mathrm{^{217}Ra}$ exhibits an intermediate the behavior between the extremes of spherical and octupole-deformed nuclei. The termination of the simplex bands at intermediate energies and the structures lying above reflect the dominance of the single-particle excitations at higher excitation energies.

nucl-ex

Analysis of nanometre sized aligned conical pores using SAXS

Small angle X-ray scattering (SAXS) was used to quantitatively study the morphology of aligned, mono-disperse conical etched ion tracks in thin films of amorphous silicon dioxide with aspect ratios of around 6:1, and in polycarbonate foils with aspect ratios of around 1000:1. This paper presents the measurement procedure and methods developed for the analysis of the scattering images and shows results obtained for the two material systems. To enable accurate parameter extraction from the data collected from conical scattering objects a model fitting the 2-D detector images was developed. The analysis involved fitting images from a sequence of measurements with different sample tilts to minimise errors which may have been introduced due to the experimental set-up. The model was validated by the exploitation of the geometric relationship between the sample tilt angle and the cone opening angle, to an angle observed in the features of the SAXS images. We also demonstrate that a fitting procedure for 1-D data extracted from the scattering images using a hard cylinder model can also be used to extract the cone size. The application of these techniques enables us to reconstruct the cone morphologies with unprecedented precision.

physics.app-ph