arXiv subjects

Robin Neuder

Publications and source records attributed to Robin Neuder.

9 recordsLinked to original sources

arXiv2026

Wideband Illumination with Liquid Crystal Reconfigurable Intelligent Surfaces: Modeling, Design, and Experimental Tests

Liquid crystal (LC) is a promising hardware solution for implementing large RISs, as it is cost-effective, energy efficient, scalable, and capable of providing continuous phase shifts with low power consumption. However, the phase shift response of LC-based RISs is inherently frequency dependent. If unaddressed, this characteristic leads to performance degradation, particularly in wideband scenarios. This issue is especially critical in secure communication applications, where minor phase shift variations across elements can result in considerable information leakage. This paper addresses these frequency-induced variations by developing a physics-based model for an LC unit cell across varying frequencies and proposing a novel phase shift design framework that maximizes secure communication across all subcarriers. Given the large number of elements in millimeter wave (mmWave) LC-RISs, acquiring full channel state information (CSI) is often impractical. Therefore, we optimize the phase shifts based solely on the locations of the legitimate mobile users (MUs) and potential eavesdroppers. Rather than targeting a single user point, the RIS is designed to illuminate a broader area. This approach enhances communication reliability for the MUs and mitigates performance degradation caused by location estimation errors. To solve the problem, we introduce both a semi-definite programming (SDP)-based solution and a low complexity heuristic method. While the SDP-based approach yields superior performance, it incurs higher computational complexity. Conversely, the scalable method exhibits a much slower scaling of complexity, which makes it highly suitable for extremely large RISs. Simulation results demonstrate that both algorithms improve the secrecy rate compared to baseline methods. Finally, the proposed design is validated through experimental evaluations on an LC RIS setup.

eess.SP↗

arXiv2026

Scalable mm-Wave Liquid Crystal Reconfigurable Intelligent Surfaces based on the Delay Line Architecture

This paper presents the design, fabrication, and characterization of broadband liquid crystal (LC) reconfigurable intelligent surfaces (RIS) operating around 60 GHz and scaling up to 750 radiating elements. The RISs employ a delay line architecture (DLA) that decouples the phase shifting and radiating layer, enabling wide bandwidth, continuous phase control exceeding 360{\deg}, and fast response times with a micrometer-thin LC layer of 4.6 micrometer. Two prototypes with 120 and 750 elements are realized using identical unit cells and column-wise biasing. Measurements demonstrate beam steering over +-60{\deg} and -3 dB bandwidths exceeding 9% for both apertures, confirming the scalability of the proposed architecture. On top of a measured nanowatt power consumption per unit cell, aperture efficiencies above 20% are predicted by simulations. While the measured efficiencies are reduced to 9.2% and 2.6%, a detailed analysis verifies that this reduction can be attributed to technological challenges in a laboratory environment. Finally, a comprehensive comparison between the applied DLA-based LC-RIS and a conventional approach highlights the superior potential of applied architecture.

eess.SP↗

arXiv2025

Learning-Based Phase Shift Optimization of Liquid Crystal RIS in Dynamic mmWave Networks

To enhance coverage and signal quality in millimeter-wave (mmWave) frequencies, reconfigurable intelligent surfaces (RISs) have emerged as a game-changing solution to manipulate the wireless environment. Traditional semiconductor-based RISs face scalability issues due to high power consumption. Meanwhile, liquid crystal-based RISs (LC-RISs) offer energy-efficient and cost-effective operation even for large arrays. However, this promise has a caveat. LC-RISs suffer from long reconfiguration times, on the order of tens of milliseconds, which limits their applicability in dynamic scenarios. To date, prior works have focused on hardware design aspects or static scenarios to address this limitation, but little attention has been paid to optimization solutions for dynamic settings. Our paper fills this gap by proposing a reinforcement learning-based optimization framework to dynamically control the phase shifts of LC-RISs and maximize the data rate of a moving user. Specifically, we propose a Deep Deterministic Policy Gradient (DDPG) algorithm that adapts the LC-RIS phase shifts without requiring perfect channel state information and balances the tradeoff between signal-to-noise ratio (SNR) and configuration time. We validate our approach through high-fidelity ray tracing simulations, leveraging measurement data from an LC-RIS prototype. Our results demonstrate the potential of our solution to bring adaptive control to dynamic LC-RIS-assisted mmWave systems.

eess.SP↗

arXiv2025

Liquid Crystal-Based RIS Loss-Trade-Off Analysis

Liquid crystal (LC) technology has emerged as a promising solution for large reconfigurable intelligent surfaces (RISs) at millimeter wave (mmWave) bands, offering advantages such as low power consumption, scalability, and continuously tunable phase shifts. For LC-RIS based on the delay-line architecture, i.e., with dedicated phase shifters, there exists a trade-off between the maximum achievable phase-shift range and the corresponding insertion loss, which has not been studied for LC-RIS-assisted wireless systems yet. In this paper, we investigate this trade-off where a base station (BS) and an RIS are configured to minimize the transmit power while satisfying a given quality of service (QoS) for a number of users. Simulation results reveal a fundamental trade-off between the total transmit power and the achievable data rate as a function of the LC phase-shift range.

eess.SP↗

arXiv2025

Near-field Liquid Crystal RIS Phase-Shift Design for Secure Wideband Illumination

Liquid crystal (LC) technology provides a low-power and scalable approach to implement a reconfigurable intelligent surface (RIS). However, the LC-based RIS's phase-shift response is inherently frequency-dependent, which can lead to performance degradation if not properly addressed. This issue becomes especially critical in secure communication systems, where such variations may result in considerable information leakage. To avoid the need for full channel state information (CSI) acquisition and frequent RIS reconfiguration, we design RIS for a wideband orthogonal frequency division multiplexing (OFDM) system to illuminate a desired area containing legitimate users while avoiding leakage to regions where potential eavesdroppers may be located. Our simulation results demonstrate that the proposed algorithm improves the secrecy rate compared to methods that neglect frequency-dependent effects. In the considered setup, the proposed method achieves a secrecy rate of about 2 bits/symbol over an 8 GHz bandwidth when the center frequency is 60 GHz.

eess.SP↗

arXiv2025

Fast Reconfiguration of Liquid Crystal-RISs: Modeling and Algorithm Design

LC technology is a promising hardware solution for realizing extremely large RISs due to its advantages in cost-effectiveness, scalability, energy efficiency, and continuous phase shift tunability. However, the slow response time of the LC cells, especially in comparison to the silicon-based alternatives like radio frequency switches and PIN diodes, limits the performance. This limitation becomes particularly relevant in TDMA applications where RIS must sequentially serve users in different locations, as the phase-shifting response time of LC cells can constrain system performance. This paper addresses the slow phase-shifting limitation of LC by developing a physics-based model for the time response of an LC unit cell and proposing a novel phase-shift design framework to reduce the transition time. Specifically, exploiting the fact that LC-RIS at milimeter wave bands have a large electric aperture, we optimize the LC phase shifts based on user locations, eliminating the need for full channel state information and minimizing reconfiguration overhead. Moreover, instead of focusing on a single point, the RIS phase shifters are designed to optimize coverage over an area. This enhances communication reliability for mobile users and mitigates performance degradation due to user location estimation errors. The proposed design minimizes the transition time between configurations, a critical requirement for TDMA schemes. Our analysis reveals that the impact of RIS reconfiguration time on system throughput becomes particularly significant when TDMA intervals are comparable to the reconfiguration time. In such scenarios, optimizing the phase-shift design helps mitigate performance degradation while ensuring specific QoS requirements. Moreover, the proposed algorithm has been tested through experimental evaluations, which demonstrate that it also performs effectively in practice.

eess.SP↗

arXiv2024

Fast-Reconfiguring Liquid-Crystal RIS for Pervasive Wireless Networks

Reconfigurable intelligent surfaces (RISs) have emerged as a key technology for dynamically reshaping wireless propagation, enhancing coverage and mitigating blockages to enable more pervasive network connectivity. However, implementing RISs at high frequencies remains challenging due to the cost and power demands of semiconductor-based components. To address these critical limitations, liquid crystals (LCs) technology has been identified as a promising low-cost and low-power alternative, giving rise to LC-RIS. The central challenge of this technology, however, lies in its limited responsiveness, as the slow molecular dynamics of LCs lead to long phase-shift reconfiguration times that restrict practicality. This paper presents LiquiRIS, a novel framework that enables substantially faster phase shifting in LC-RIS. By explicitly incorporating the physical dynamics of LC molecules into the phase-shift configuration process, LiquiRIS intelligently selects phase transitions that minimize the overall reconfiguration time. As a result, LiquiRIS achieves up to $ 71.61 \% $ reduction in overall reconfiguration time compared to conventional schemes, significantly improving the feasibility of LC-RIS deployment. The proposed framework is further validated through experiments on a mmWave LC-RIS prototype.

eess.SP↗

arXiv2024

Fast Transition-Aware Reconfiguration of Liquid Crystal-based RISs

Liquid crystal (LC) technology offers a cost-effective, scalable, energy-efficient, and continuous phase tunable realization of extremely large reconfigurable intelligent surfaces (RISs). However, LC response time to achieve a desired differential phase is significantly higher compared to competing silicon-based technologies (RF switches, PIN diodes, etc). The slow response time can be the performance bottleneck for applications where frequent reconfiguration of the RIS (e.g., to serve different users) is needed. In this paper, we develop an RIS phase-shift design that is aware of the transition behavior and aims to minimize the time to switch among multiple RIS configurations each serving a mobile user in a time-division multiple-access (TDMA) protocol. Our simulation results confirm that the proposed algorithm significantly reduces the time required for the users to achieve a threshold signal quality. This leads to a considerable improvement in the achievable throughput for applications, where the length of the TDMA time intervals is comparable with the RIS reconfiguration time.

eess.SP↗

arXiv2023

Reconfigurable Intelligent Surfaces with Liquid Crystal Technology: A Hardware Design and Communication Perspective

With the surge of theoretical work investigating Reconfigurable Intelligent Surfaces (RISs) for wireless communication and sensing, there exists an urgent need of hardware solutions for the evaluation of these theoretical results and further advancing the field. The most common solutions proposed in the literature are based on varactors, Positive Intrinsic-Negative (PIN) diodes, and Micro-Electro-Mechanical Systems (MEMS). This paper presents the use of Liquid Crystal (LC) technology for the realization of continuously tunable extremely large millimeter-wave RISs. We review the basic physical principles of LC theory, introduce two different realizations of LC-RISs, namely reflect-array and phased-array, and highlight their key properties that have an impact on the system design and RIS reconfiguration strategy. Moreover, the LC technology is compared with the competing technologies in terms of feasibility, cost, power consumption, reconfiguration speed, and bandwidth. Furthermore, several important open problems for both theoretical and experimental research on LC-RISs are presented.

cs.IT↗