arXiv Science⌕ Search

arXiv subjects

Petr Varak

Publications and source records attributed to Petr Varak.

3 recordsLinked to original sources

Thulium- and Holmium-Doped Silica Fibres for 2 μm High-Power and Highly-Efficient Lasers

Silica optical fibres, originally developed as a low-loss transmission medium for telecommunications, have evolved into a versatile platform for compact and efficient high-power lasers. This review discusses recent progress in thulium- and holmium-doped active fibres emitting within the 2 μm spectral band, with an emphasis on material and waveguide approaches that address power scaling through thermal-load mitigation and enhanced laser efficiency. In particular, the temperature dependence of absorption and emission cross-sections are reviewed, and their implications for spectral gain, amplified spontaneous emission and high-power laser operation are discussed. Structured-core thulium fibres are then considered as a route to combining the high local Tm3+ concentration required for efficient two for- one cross-relaxation with a reduced average dopant concentration, lower longitudinal heat load, and a pedestal-free waveguide design. Finally, recent results on holmium-doped silica fibres prepared by nanoparticle-assisted modified chemical vapour deposition are summarised. Crucially, the Al/Ho ratio is identified as a key compositional parameter governing laser efficiency, while a high absolute alumina content supports a long fluorescence lifetime and enables high Ho3+ concentrations without excessive clustering. These advances have enabled core-pumped holmium fibre lasers with slope efficiencies reaching 84% and output powers approaching 100W. Collectively, these development illustrate how control of spectroscopy, composition, and transverse dopant distribution can extend the performance of silica fibre lasers across the 1.7-2.2 μm spectral region.

physics.optics↗

Judd-Ofelt analysis of holmium-doped alumino-silicate optical glass prepared by MCVD combined with nanoparticle doping

We present a detailed Judd--Ofelt (JO) analysis of Ho$^{3+}$-doped alumino-silicate optical fiber preforms in a wide range of compositions and prepared by both the standard solution doping method as well as the more advanced nanoparticle doping. The absorption spectra were measured, the absorption cross sections were calculated for each observed transition, and the Judd--Ofelt analysis was conducted. The preforms exhibited the values of JO parameters of $Ω_2 = (7.2--10.6) \times 10^{-20}\,\mathrm{cm}^2$, depending on the Al$_2$O$_3$ content, and $Ω_4$ and $Ω_6$ around $2.5$ and $1.2 \times 10^{-20}\,\mathrm{cm}^2$, respectively. The radiative transition parameters, such as transition probabilities, branching ratios, and radiative lifetimes, were calculated. The radiative lifetime of the ${}^5I_7 \rightarrow {}^5I_8$ transition, in the $16.1--17.2\,\mathrm{ms}$ range, combined with a measured value in the $0.9--1.9\,\mathrm{ms}$ range, was used to calculate the quantum efficiency, which was in the $5--11\,\%$ range. The preforms prepared by nanoparticle doping containing high Al$_2$O$_3$ contents above $8\,\mathrm{mol.}\,\%$ exhibited superior values of measured lifetime (above $1.5\,\mathrm{ms}$) and quantum efficiency (above $8\,\%$) compared to the standard solution-doped samples. To the best of our knowledge, this work is the first comprehensive report on the JO analysis of Ho$^{3+}$-doped alumino-silicate glass. The calculated parameters may be used in various calculations, simulations, and modelling of holmium-doped fiber lasers and other devices.

physics.optics↗

Structured Ytterbium and Erbium -doped Silica Fiber for Dual Wavelength Laser Operation

We report on a novel type of dual-wavelength fiber laser with a structured-core design inside silica glass, forming a spatial separation of the several core areas doped with ytterbium and erbium ions. We have optimised the key parameters of the fiber core, such as the concentration of rare earth elements, and the optimal length of active fiber to operate simultaneously at two different wavelengths. Using the Modified Chemical Vapor Deposition method to obtain initial optical fiber preforms, and using the stack and draw technique, we have fabricated two types of active fibers, one with 7 and one with 19 rare-earth-doped rods (elements) forming the fiber core. We characterized the drawn fibers by investigating their structure by scanning electron microscopy, confirming the spatial separation of the elements within the core. Measuring absorption shows that concentration ratios Nt Yb: Nt Er were approximately 52: 48 for 7 core fibers and 56:44 for 19 core fibers. Lifetimes for both active fibers were 0.84 ms for Yb3+ ion and 10.30 ms for Er3+ ion. The performance of fiber lasers was determined, proving that fibers are capable of laser emission simultaneously at 1042 nm and 1550 nm. We have shown experimentally that the output power ratio between both lasing wavelengths can be controlled by the length of the fiber.

physics.optics↗