arXiv subjects

Patrick See

Publications and source records attributed to Patrick See.

12 recordsLinked to original sources

arXiv2025

Hydrogen Passivation Effects on Spatially Resolved Charge Trap Densities in Si(100)-SiO$_2$

As silicon-based devices continue to shrink to the nanoscale, traps at the Si-SiO$_2$ interface pose increasing challenges to device performance. These traps reduce channel carrier mobility and shift threshold voltages in integrated circuits, and introduce charge noise in quantum systems, reducing their coherence times. Knowledge of the precise location of such traps aids in understanding their influence on device performance. In this work, we demonstrate that frequency-modulated atomic force microscopy (fm-AFM) allows the detection of individual traps. We use this to study how sample preparation, specifically the introduction of a buried hydrogen termination layer, and post-processing annealing in forming gas (N$_2$+H$_2$), affects the density of donor-like traps in Si(100)-SiO$_2$ systems. We spatially map and quantify traps in both conventionally prepared ("pristine") silicon samples and those processed under ultra-high vacuum for hydrogen resist lithography (HRL). We confirm previous studies demonstrating hydrogen passivation of traps and find that hydrogen termination further reduces the donor-like trap density. We also observe a significant reduction in two-level donor-like traps in the hydrogen-terminated samples compared to pristine silicon samples. These findings suggest that HRL-prepared silicon may offer advantages for high-performance nanoscale and atomic-scale devices due to reduced trap densities.

cond-mat.mtrl-sci↗

arXiv2024

Needle in a haystack: efficiently finding atomically defined quantum dots for electrostatic force microscopy

The ongoing development of single electron, nano and atomic scale semiconductor devices would benefit greatly from a characterization tool capable of detecting single electron charging events with high spatial resolution, at low temperature. In this work, we introduce a novel Atomic Force Microscope (AFM) instrument capable of measuring critical device dimensions, surface roughness, electrical surface potential, and ultimately the energy levels of quantum dots and single electron transistors in ultra miniaturized semiconductor devices. Characterization of nanofabricated devices with this type of instrument presents a challenge: finding the device. We therefore also present a process to efficiently find a nanometre size quantum dot buried in a $10 \times 10~\text{mm}^2$ silicon sample using a combination of optical positioning, capacitive sensors and AFM topography in vacuum.

cond-mat.mes-hall↗

arXiv2020

Demonstration of electron focusing using electronic lenses in low-dimensional system

We report an all-electric integrable electron focusing lens in n-type GaAs. It is shown that a pronounced focusing peak takes place when the focal point aligns with an on-chip detector. The intensity and full width half maximum (FWHM) of the focusing peak are associated with the collimation of injected electrons. To demonstrate the reported focusing lens can be a useful tool, we investigate characteristic of an asymmetrically gate biased quantum point contact with the assistance of focusing lens. A correlation between the occurrence of conductance anomaly in low conductance regime and increase in FWHM of focusing peak is observed. The correlation is likely due to the electron-electron interaction. The reported electron focusing lens is essential for a more advanced electron optics device.

cond-mat.mes-hall↗

arXiv2019

Thermoelectric property of a one dimensional channel in the presence of a transverse magnetic field

We studied the thermal conduction through a quantum point contact (QPC), defined in GaAs-AlGaAs heterostructure, in the presence of a transverse magnetic field. A shift in the position of thermo-voltage peak is observed with increasing field. The position of the thermo-voltage peak follows the Cutler-Mott relation in the small field regime (B < 0.5 T); it starts diverging from the Cutler-Mott relation in the moderate field regime, where a cubic magnetic field term dominates over the trivial quadratic term; eventually the shift saturates in the large field regime (B > 3.0 T). Our results suggest that additional calibration is necessary when using QPC as thermometry, especially when the transverse magnetic field is applied.

cond-mat.mes-hall↗

arXiv2018

Magnetoresistance in an electronic cavity coupled to one-dimensional systems

In this work, we performed magnetoresistance measurement in a hybrid system consisting of an arc-shaped quantum point contact (QPC) and a flat, rectangular QPC, both of which together form an electronic cavity between them. The results highlight a transition between collimation-induced resistance dip to a magnetoresistance peak as the strength of coupling between the QPC and the electronic cavity was increased. The initial results show the promise of hybrid quantum system for future quantum technologies.

cond-mat.mes-hall↗

arXiv2018

Incipient singlet-triplet states in a hybrid mesoscopic system

In the present work we provide an easily accessible way to achieve the singlet-triplet Kondo effect in a hybrid system consisting of a quantum point contact (QPC) coupled to an electronic cavity. We show that by activating the coupling between the QPC and cavity, a zero-bias anomaly occurs in a low conductance regime, a coexistence of zero-bias and finite-bias anomaly (FBA) in a medium conductance regime, and a FBA-only anomaly in a high conductance regime. The latter two observations are due to the singlet-triplet Kondo effect.

cond-mat.mes-hall↗

arXiv2018

Existence of Shapiro Steps in the Dissipative Regime in Superconducting Weak Links

We present measurements of microwave-induced Shapiro steps in a superconducting nanobridge weak link in the dissipative branch of a hysteretic current-voltage characteristic. We demonstrate that Shapiro steps can be used to infer a reduced critical current and associated effective local temperature. Our observation of Shapiro steps in the dissipative branch hows that a finite Josephson coupling exists in the dissipative state and thus can be used to put an upper limit on the effective temperature and on the size of the region that can be heated above the critical temperature. This work provides evidence that Josephson behaviour can still exist in thermally-hysteretic weak link devices and will allow extension of the temperature ranges that nanobridge based single flux quantum circuits, nanoSQUIDs and Josephson voltage standards can be used.

cond-mat.supr-con↗

arXiv2018

Coherent Spin Amplification Using a Beam Splitter

We report spin amplification using a capacitive beam splitter in n-type GaAs where the spin polarization is monitored via transverse electron focusing measurement. It is shown that partially spin-polarized current injected by the emitter can be precisely controlled and the spin polarization associated with it can be amplified by the beam splitter, such that a considerably high spin polarization of around 50% can be obtained. Additionally, the spin remains coherent as shown by the observation of quantum interference. Our results illustrate that spin polarization amplification can be achieved in materials without strong spin-orbit interaction.

cond-mat.mes-hall↗

arXiv2017

Temperature Dependence of Spin-Split Peaks in Transverse Electron Focusing

We present experimental results of transverse electron-focusing measurements performed using n-type GaAs. In the presence of a small transverse magnetic field (B), electrons are focused from the injector to detector leading to focusing peaks periodic in B. We show that the odd-focusing peaks exhibit a split, where each sub-peak represents a population of a particular spin branch emanating from the injector. The temperature dependence reveals that the peak splitting is well defined at low temperature whereas it smears out at high temperature indicating the exchange-driven spin polarisation in the injector is dominant at low temperatures.

cond-mat.mes-hall↗

arXiv2017

Interference Effects in a Tunable Quantum Point Contact Integrated with an Electronic Cavity

We show experimentally how quantum interference can be produced using an integrated quantum system comprising an arch-shaped short quantum wire (or quantum point contact, QPC) of 1D electrons and a reflector forming an electronic cavity. On tuning the coupling between the QPC and the electronic cavity, fine oscillations are observed when the arch QPC is operated in the quasi-1D regime. These oscillations correspond to interference between the 1D states and a state which is similar to the Fabry-Perot state and suppressed by a small transverse magnetic field of 60mT. Tuning the reflector, we find a peak in resistance which follows the behavior expected for a Fano resonance. We suggest that this is an interesting example of a Fano resonance in an open system which corresponds to interference at or near the Ohmic contacts due to a directly propagating, reflected discrete path and the continuum states of the cavity corresponding to multiple scattering. Remarkably, the Fano factor shows an oscillatory behavior taking peaks for each fine oscillation, thus, confirming coupling between the discrete and continuum states. The results indicate that such a simple quantum device can be used as building blocks to create more complex integrated quantum circuits for possible applications ranging from quantum-information processing to realizing the fundamentals of complex quantum systems.

cond-mat.mes-hall↗

arXiv2017

Direct observation of exchange-driven spin interactions in one-dimensional system

We present experimental results of transverse electron focusing measurements performed on an n-type GaAs based mesoscopic device consisting of one-dimensional (1D) quantum wires as injector and detector. We show that non-adiabatic injection of 1D electrons at a conductance of e$^2$/h results in a single first focusing peak, which on gradually increasing the injector conductance up to 2e$^2$/h , produces asymmetric two sub-peaks in the first focusing peak, each sub-peak representing the population of spin-state arising from the spatially separated spins in the injector. Further increasing the conductance flips the spin-states in the 1D channel thus reversing the asymmetry in the sub-peaks. On applying a source-drain bias, the spin-gap, so obtained, can be resolved thus providing evidence of exchange interaction induced spin polarisation in the 1D systems.

cond-mat.mes-hall↗

arXiv2017

Fano Resonance in a cavity-reflector hybrid system

We present the results of transport measurements in a hybrid system consisting of an arch-shaped quantum point contact (QPC) and a reflector; together, they form an electronic cavity in between them. On tuning the arch-QPC and the reflector, asymmetric resonance peak in resistance is observed at the one-dimension to two-dimension transition. Moreover, a dip in resistance near the pinch-off of the QPC is found to be strongly dependent on the reflector voltage. These two structures fit very well with the Fano line shape. The Fano resonance was found to get weakened on applying a transverse magnetic field, and it smeared out at 100 mT. In addition, the Fano like shape exhibited a strong temperature dependence and gradually smeared out when the temperature was increased from 1.5 to 20 K. The results might be useful in realising device for quantum information processing.

cond-mat.mes-hall↗