arXiv subjects

O. Duarte

Publications and source records attributed to O. Duarte.

4 recordsLinked to original sources

arXiv2026

Operation and performance of the Probe for Luminosity Measurement at LHCb

The Probe for LUminosity MEasurement (PLUME) detector is a dedicated luminosity monitor at the LHCb interaction point. It is a hodoscope comprising 48 Hamamatsu R760 photomultiplier tubes that detect Cherenkov light produced by particles travelling in the direction opposite to the LHCb spectrometer acceptance. PLUME provides real-time, bunch-by-bunch luminosity measurements during LHCb data taking and serves as the primary detector for controlling the luminosity levelling process at LHCb. In addition, its data are used offline, together with other dedicated counters from LHCb sub-systems, to determine the integrated luminosity delivered to the experiment. This paper reports on the detector's operational performance during the 2024-2026 data-taking period of Run 3. The integrated luminosity recorded by the LHCb experiment in $pp$ collisions at $\sqrt{s} = 13.6$ TeV during this period, as measured by the PLUME online luminosity counters for detector performance monitoring, amounts to $\mathcal{L} = (26.71 \pm 1.07)$ fb$^{-1}$. The luminosity values used in physics analyses are determined separately through dedicated offline calibrations based on van der Meer scans and Beam Gas Imaging techniques, and will be reported in a dedicated publication, as they are beyond the scope of this paper.

hep-ex↗

arXiv2025

Beam-test evaluation of pre-production Low Gain Avalanche Detectors for the ATLAS High Granularity Timing Detector

The High Granularity Timing Detector (HGTD) will be installed in the ATLAS experiment as part of the Phase-II upgrade for the High Luminosity-Large Hadron Collider (HL-LHC). It will mitigate pile-up effects in the forward region, and measure per bunch luminosity. The design of HGTD is based on Low Gain Avalanche Detector (LGAD) sensors. This paper presents the results of beam-test campaigns conducted at CERN and DESY in 2023 and 2024 on single LGADs from HGTD pre-production test structures, before and after neutron irradiation up to fluences of $2.5 \times 10^{15}~\mathrm{n_{eq}/cm^2}$. The tested LGADs can meet HGTD requirements in terms of charge collection, time resolution, and hit efficiency, even under HL-LHC end-of-life conditions, supporting their deployment in the final detector.

physics.ins-det↗

arXiv2025

Thermal Cycling Reliability of Hybrid Pixel Sensor Modules for The ATLAS High Granularity Timing Detector

The reliability of bump connection structures has become a critical aspect of future silicon detectors for particle physics. The High Granularity Timing Detector (HGTD) for the ATLAS experiment at the High-Luminosity Large Hadron Collider will require 8032 hybrid pixel sensor modules, composed of two Low Gain Avalanche Diode sensors bump-bonded to two readout ASICs and glued to a passive PCB. The detector will operate at low temperature (-30 degrees Celsius) to mitigate the impact of irradiation. The thermomechanical reliability of flip-chip bump connections in HGTD modules is a critical concern, particularly due to their characteristically lower bump density (pixel pitch dimensions of 1.3 mm by 1.3 mm). This paper elaborates on the challenges arising from this design characteristic. Finite element analysis and experimental testing were employed to investigate failure modes in the flip-chip bump structures under thermal cycling from -45 degrees Celsius to 40 degrees Celsius and to guide the module redesign. The optimized design demonstrates significantly enhanced robustness and is projected to fulfill the full lifetime requirements of the HGTD.

physics.ins-det↗

arXiv2020

Calibration and performance of the LHCb calorimeters in Run 1 and 2 at the LHC

The calibration and performance of the LHCb Calorimeter system in Run 1 and 2 at the LHC are described. After a brief description of the sub-detectors and of their role in the trigger, the calibration methods used for each part of the system are reviewed. The changes which occurred with the increase of beam energy in Run 2 are explained. The performances of the calorimetry for $\gamma$ and $\pi^0$ are detailed. A few results from collisions recorded at $\sqrt {s}$ = 7, 8 and 13 TeV are shown.

physics.ins-det↗