arXiv subjects

Nicolas Thomae

Publications and source records attributed to Nicolas Thomae.

3 recordsLinked to original sources

arXiv2026

Ultrafast Tracking of the Spallation Layer in Bulk Gold, Aluminum, and Steel

Extreme manufacturing with ultrashort-pulse (USP) lasers at the physical limit of precision and efficiency requires understanding ablation dynamics on the picosecond-to-nanosecond timescale. Pump-probe reflectometry (PPR) provides direct access to photomechanical spallation through Newton ring (NR) interference, but this signature vanishes when the spallation layer becomes optically opaque or the ablated material strongly attenuates the probe. Here, we combine PPR with phase-sensitive interferometric pump-probe (PPI) measurements to track the spallation layer in bulk steel, aluminum, and gold. PPI resolves the propagating layer even when the reflected probe signal is suppressed by >95%. Joint PPR/PPI analysis with transfer-matrix modelling (TMM) yields spallation layer thickness, vapor layer absorption, and the layer disintegration times. These quantities are key determinants of the energy coupling of subsequent pulses in GHz burst processing.

physics.optics↗

arXiv2026

Breakdown of spallation in multi-pulse ultrafast laser ablation

Ultrashort-pulse laser ablation of metals near damage threshold is governed by homogeneous spallation, in which tensile unloading releases a nanometre-thin liquid film whose optical signatures are temporally evolving concentric Newton rings in pump--probe experiments. This well-established picture rests almost exclusively on single-pulse results obtained on ideally flat surfaces, yet application-oriented processing invariably operates in a multi-pulse regime in which each pulse irradiates a surface progressively modified by preceding pulses. Whether homogeneous spallation persists under these conditions has remained an open question. Here we resolve this question using time-resolved pump-probe interferometry applied pulse by pulse to austenitic stainless steel. We show that homogeneous spallation dominates the first pulse, while its contribution is strongly reduced for the second pulse. By the third pulse, Newton rings vanish and sustained surface bulging collapses, with the optical transients fully saturating into a phase-explosion-like signature by the fourth pulse. Fourier-domain coherence analysis rules out roughness-induced decoherence as an optical artefact. Four independent observables, spanning time-resolved and final-state measurements, converge on the same transition after three to four pulses. Spallation-layer formation, widely invoked to explain ultrashort-pulse ablation of metals, is thus a single-pulse phenomenon rather than a multi-pulse ablation mechanism.

physics.optics↗

arXiv2025

From surface roughness to crater formation in a 2D multi-scale simulation of ultrashort pulse laser ablation

Surface roughness plays a critical role in ultrashort pulse laser ablation, particularly for industrial applications using burst mode operations, multi-pulse laser processing, and the generation of laser-induced periodic surface structures. Hence, we address the impact of surface roughness on the resulting laser ablation topography predicted by a simulation model and compared to experimental results. We present a comprehensive multi-scale simulation framework that first employs finite-difference-time-domain simulations for calculating the surface fluence distribution on a rough surface measured by an atomic-force-microscope followed by the two-temperature model coupled with hydrodynamic/solid mechanics simulation for the initial material heating. Lastly, a computational fluid dynamics model for material relaxation and fluid flow is developed and employed. Final state results of aluminum and AISI 304 stainless steel simulations demonstrated alignment with established ablation models and crater dimension prediction. Notably, Al exhibited significant optical scattering effects due to initial surface roughness of 15 nm - being 70 times below the laser wavelength, leading to localized, selective ablation processes and substantially altered crater topography compared to idealized conditions. Contrary, AISI 304 with RMS roughness of 2 nm showed no difference. Hence, we highlight the necessity of incorporating realistic, material-specific surface roughness values into large-scale ablation simulations. Furthermore, the induced local fluence variations demonstrated the inadequacy of neglecting lateral heat transport effects in this context.

hep-ex↗