arXiv subjects

Muhammad Sarwar

Publications and source records attributed to Muhammad Sarwar.

13 recordsLinked to original sources

arXiv2026

Trajectory-Based Nonlinear Indices for Real-Time Monitoring and Quantification of Short-Term Voltage Stability

Existing short term voltage stability (STVS) methods typically address either voltage oscillations or delayed voltage recovery; however, the coexistence of both phenomena has not been adequately covered in the literature. Moreover, existing real-time STVS assessment methods often provide only binary stability classifications. This paper proposes novel indices that enable early detection and quantify the degree of stability. The proposed method decomposes post-fault voltage trajectories using Empirical Mode Decomposition (EMD) into residual and oscillatory components. It then employs Lyapunov Exponents (LEs) to characterize the dynamic behavior of each component and evaluates the stability degree using Kullback Leibler (KL) divergence by comparing the LEs of each component with those of a predefined critical signal. The proposed indices assess oscillatory stability significantly faster than the traditional LE method applied directly to the original signal. Specifically, they detect stability within 0.6 seconds after a fault, compared to approximately 10 seconds for the conventional LE approach. In addition, the delayed-recovery index can identify generator trips caused by over-excitation limits within 3 seconds, well before the actual trip occurs at approximately 20 seconds, thereby providing operators and controllers sufficient time to take preventive actions. Furthermore, thresholds are derived to distinguish between stable and unstable cases, offering a graded measure of the stability margin. Simulation studies on the Nordic test system under varying load conditions demonstrate the effectiveness of the proposed indices.

eess.SY↗

arXiv2025

Large Language Models for Power System Applications: A Comprehensive Literature Survey

This comprehensive literature review examines the emerging applications of Large Language Models (LLMs) in power system engineering. Through a systematic analysis of recent research published between 2020 and 2025, we explore how LLMs are being integrated into various aspects of power system operations, planning, and management. The review covers key application areas including fault diagnosis, load forecasting, cybersecurity, control and optimization, system planning, simulation, and knowledge management. Our findings indicate that while LLMs show promising potential in enhancing power system operations through their advanced natural language processing and reasoning capabilities, significant challenges remain in their practical implementation. These challenges include limited domain-specific training data, concerns about reliability and safety in critical infrastructure, and the need for enhanced explainability. The review also highlights emerging trends such as the development of power system-specific LLMs and hybrid approaches combining LLMs with traditional power engineering methods. We identify crucial research directions for advancing the field, including the development of specialized architectures, improved security frameworks, and enhanced integration with existing power system tools. This survey provides power system researchers and practitioners with a comprehensive overview of the current state of LLM applications in the field and outlines future pathways for research and development.

eess.SY↗

arXiv2025

Novel Data-Driven Indices for Early Detection and Quantification of Short-Term Voltage Instability from Voltage Trajectories

This paper presents a novel Short-Term Voltage Stability Index (STVSI), which leverages Lyapunov Exponent-based detection to assess and quantify short-term stability triggered by Over Excitation Limiters (OELs) or undamped oscillations in voltage. The proposed method is measurement-based and decomposes the voltage trajectory into two key components using Empirical Mode Decomposition (EMD): a residual part, which indicates delayed voltage recovery, and an oscillatory part, which captures oscillations. The residual component is critical, as it can detect activation of OELs in synchronous generators or Low Voltage Ride-Through (LVRT) relays in inverter-based resources, potentially leading to instability within the quasisteady-state time frame. Meanwhile, the oscillatory component may indicate either a stable or unstable state in the short term. To accurately assess stability, STVSI employs an entropy-based metric to measure the proximity of the system to instability, with specific indices for short-term voltage stability based on oscillations and recovery. Simulations on the Nordic power system demonstrate that STVSI effectively identifies and categorizes voltage stability issues. Moreover, STVSI not only detects voltage stability conditions but also qualitatively assesses the extent of stability, providing a nuanced measure of stability.

eess.SY↗

arXiv2025

Enhanced Entropy-Based Metric for Characterization of Delayed Voltage Recovery

Ensuring accurate violation detection in power systems is paramount for operational reliability. This paper introduces an enhanced voltage recovery violation index (EVRVI), a comprehensive index designed to quantify fault-induced delayed voltage recovery (FIDVR). EVRVI enhances traditional entropy-based methods by leveraging Empirical Mode Decomposition (EMD) to extract key features from the voltage signal, which are then used to quantify over-voltage (OV) and under-voltage (UV) events. Our simulations on the Nordic system, involving over 245k scenarios, demonstrate EVRVI's superior ability to identify and categorize voltage recovery issues compared to the traditional entropy-based measure. EVRVI not only significantly reduces false negatives in violation detection but also provides a reliable framework for over-voltage detection, making it an invaluable tool for modern power system studies.

eess.SY↗

arXiv2019

High Impedance Fault Detection and Isolation in Power Distribution Networks using Support Vector Machines

This paper proposes an accurate High Impedance Fault (HIF) detection and isolation scheme in a power distribution network. The proposed schemes utilize the data available from voltage and current sensors. The technique employs multiple algorithms consisting of Principal Component Analysis, Fisher Discriminant Analysis, Binary and Multiclass Support Vector Machine for detection and identification of the high impedance fault. These data driven techniques have been tested on IEEE 13-node distribution network for detection and identification of high impedance faults with broken and unbroken conductor. Further, the robustness of machine learning techniques has also been analysed by examining their performance with variation in loads for different faults. Simulation results for different faults at various locations have shown that proposed methods are fast and accurate in diagnosing high impedance faults. Multiclass Support Vector Machine gives the best result to detect and locate High Impedance Fault accurately. It ensures reliability, security and dependability of the distribution network.

eess.SY↗

arXiv2019

Smart Switching and Control of a Distributed Generator Synchronized With National Grid

Distributed generation is widely being utilized, so the basic theme of this research is to have a hands-on experience to synchronize a Distributed Energy Resource (DER) to the Mains Grid. A control algorithm is implemented for energy supply from both sources i.e. DER and Mains Grid, according to the cost and availability of each source. When load changes, so that the synchronization does not lose. LabVIEW software is used for the implementation of the desired system. Validation is done by experimenting in the lab. In order to keep the system stable, the algorithm has been developed to shift the load from one bus to the other depending upon the load requirements. The project is a test bed and can be used for further experimentation and prove helpful in developing a basic understanding of Smart Switching using LabVIEW.

eess.SY↗

arXiv2019

Real Time Control and Performance Analysis of A Smart Multi-Machine System through Hardware-in-the-Loop Simulation

This paper presents an implementation of a smart power system using inter-device communication and supervisory control through Simulink integrated with the physical system. This control includes features of real-time control, load management, fault detection and self-healing. The prototype is designed in hardware which takes in required parameter via sensors to PC via RS-232 power meter interface and actuator interfaced with Arduino microcontroller board which is integrated with Simulink. Simulink simulates the model and predict control signals depending upon input parameters and it sends control signal back to Arduino which then control the hardware through hardware in the loop (HIL) simulation. In the case of a severe fault, these control techniques detect system variation and compensate for this variation or remove the faulty part by using relays, which represents the self-healing nature of the developed model.

eess.SY↗

arXiv2019

Design and Implementation of an Automatic Synchronizing and Protection Relay through Power-Hardware-in-the-Loop (PHIL) Simulation

This paper focuses on the design and implementation of an automatic synchronizing and protection relay to automate the synchronization process of a Distributed Energy Resource (DER) to the Main Grid. The proposed design utilize a cost-effective data acquisition using arduino in combination with LabVIEW software to implement the multi-purpose synchronizing relay. The proposed synchronizing relay is capable of synchronizing a Distributed Generator (DG) to the power grid from black-start and fulfills the requirements imposed by the utility. The synchronizing relay is implemented through voltage and frequency control of an actual lab-scale synchronous generator. In the synchronization process, frequency synchronization is done using speed control of the stepper motor as prime mover and voltage synchronization is accomplished using Excitation Control module through Power-Hardware-in-the-Loop (PHIL) simulation. In grid-connected mode, active and reactive power controls and protection schemes for the synchronous generator have also been implemented. The proposed multi-function relay has been deployed and tested on a lab-scale test bed to validate the proposed design and functionality.

eess.SY↗

arXiv2019

An Accurate Fault Location Algorithm for Meshed Power Networks Utilizing Hybrid Sparse Voltage and Current Measurements

This paper proposes an accurate fault location algorithm technique based on hybrid synchronized sparse voltage and sparse current phasor measurements. The proposed algorithm addresses the performance limitation of fault location algorithms based on only synchronized sparse voltage measurements (SSVM) and on only synchronized sparse current measurements (SSCM). In the proposed method, bus voltage phasor of faulty line or close to the faulty line and branch current phasor of the adjacent line is utilized. The paper contributes to improve the accuracy of fault location and deter the effect of CT saturation by using hybrid voltage and current measurements. The proposed algorithm has been tested on four bus two area power system and IEEE 14 bus system with the typical features of an actual distribution system. The robustness of algorithm has been tested by variation in fault location, fault resistance, load switching. The simulation results demonstrate the accuracy of the proposed algorithm and ensure a reliable fault detection and location method.

eess.SP↗

arXiv2019

A Communication-less Protection Strategy to Ensure Protection Coordination of Distribution Networks with Embedded DG

Distributed Generation (DG) has emerged as best alternative to conventional energy sources in recent times. Decentralization of power generation, improvement in voltage profile and reduction of system losses are some of key benefits of DG integration into the grid. However, introduction of DG changes the radial nature of a distribution network (DN) and may affect both magnitude and direction of fault currents. This phenomenon may have severe repercussions for the reliability and safety of a DN including protection coordination failure. This paper investigates the impact of DG on protection coordination of a typical DN and proposes a scheme to restore the protection coordination in presence of DG. Moreover, impact of different DG sizes and locations on DN's voltage profile and losses has also been analyzed. The sample DN with embedded DG is modelled in ETAP environment and the simulation results presented show the effectiveness of the proposed protection strategy in restoring relay coordination of the network in both isolated and DG connected modes of operation.

eess.SP↗

arXiv2014

Some Unique Fixed Point Theorems in Multiplicative Metric Spaces

\"{O}zavsar and Cevikel(Fixed point of multiplicative contraction mappings on multiplicative metric space.arXiv:1205.5131v1 [math.GN] 23 may 2012)initiated the concept of the multiplicative metric space in such a way that the usual triangular inequality is replaced by "multiplicative triangle inequality $d(x,y)\leq d(x,z).d(z,y)$ for all $x,y,z\in X$". In this manuscript, we discussed some unique fixed point theorems in the context of multiplicative metric spaces. The established results carry some well known results from the literature to multiplicative metric space. We note that some fixed point theorems can be deduced in multiplicative metric space by using the established results. Appropriate examples are also given.

math.GM↗

arXiv2014

A Characterization of the Two-weight Inequality for Riesz Potentials on Cones of Radially Decreasing Functions

We establish necessary and sufficient conditions on a weight pair $(v,w)$ governing the boundedness of the Riesz potential operator $I_{\alpha}$ defined on a homogeneous group $G$ from $L^p_{dec,r}(w, G)$ to $L^q(v, G)$, where $L^p_{dec,r}(w, G)$ is the Lebesgue space defined for non-negative radially decreasing functions on $G$. The same problem is also studied for the potential operator with product kernels $I_{\alpha_1, \alpha_2}$ defined on a product of two homogeneous groups $G_1\times G_2$. In the latter case weights, in general, are not of product type. The derived results are new even for Euclidean spaces.

math.FA↗

arXiv2014

Riemann-Liouville and higher dimensional Harday operators for non-negative decreasing function in $L^{p(\cdot)}$ spaces

In this paper one-weight inequalities with general weights for Riemann-Liouville transform and $ n-$ dimensional fractional integral operator in variable exponent Lebesgue spaces defined on $\mathbb{R}^{n}$ are investigated. In particular, we derive necessary and sufficient conditions governing one-weight inequalities for these operators on the cone of non-negative decreasing functions in $L^{p(x)}$ spaces.

math.FA↗