arXiv Science⌕ Search

arXiv subjects

Michael Peter

Publications and source records attributed to Michael Peter.

14 recordsLinked to original sources
arXiv2026

Characterization of Helicopter Rotor Blade Modulation in UHF and Microwave Bands

This paper presents metrics and measurement methods for the experimental characterization of helicopter rotor blade modulation of the wireless propagation channel. Broadband bistatic channel measurements were conducted at three widely separated carrier frequencies (302 MHz in the UHF band, 4.9 GHz in the C-band, and 27.1 GHz in the Ka-band) for three military helicopters (CH-53, Tiger, and UMAT) at the Bundeswehr Technical and Airworthiness Center for Aircraft in Manching, Germany. The time-variant channel was analyzed in terms of the Doppler Power Spectrum and the RMS Doppler spread, the Doppler spectrogram, and the Power Time Profile. The RMS Doppler spread values were found to be moderate (up to 106 Hz), which is attributable to the predominantly lateral blade motion relative to the line-of-sight path. The Power Time Profiles revealed periodic blockage attenuations of up to 15 dB at Ka-band, increasing significantly with the carrier frequency; at 302 MHz, the blockage attenuation does not exceed 2.3 dB and the RMS Doppler spread stays below 10 Hz. The measured blockage attenuation was modeled using the double knife-edge diffraction model, showing good agreement with the measurements. The distinct micro-Doppler signatures visible in the spectrograms are identified as a potential resource for helicopter classification and passive radar applications.

eess.SP↗
arXiv2024

Demonstration of a Real-Time Testbed for D-Band Integrated Sensing and Communication

The D-band, spanning 110 GHz to 170 GHz, has emerged as a relevant frequency range for future mobile communications and radar sensing applications, particularly in the context of 6G technologies. This demonstration presents a high-bandwidth, real-time integrated sensing and communication (ISAC) platform operating in the upper D-band at 160 GHz. The platform comprises a software-defined intermediate frequency transceiver and a D-band radio frequency module. Its flexible software design allows for rapid integration of signal processing algorithms. Highlighting its potential for advanced research in ISAC systems, the platforms's efficacy is showcased through a live demonstration with an algorithm implementing human target tracking and activity classification.

eess.SP↗
arXiv2024

Reconfigurable Intelligent Surfaces for 6G Mobile Networks: An Industry R&D Perspective

The reconfigurable intelligent surface (RIS) technology is a potential solution to enhance network capacity and coverage without significant investment in additional infrastructure in 6G networks. This work highlights the interest of the mobile communication industry in RIS, and discusses the development of liquid crystal-based RIS for improved energy efficiency and coverage in the millimeter-wave band. Furthermore, the paper discusses perspectives and insights from an industry R&D point of view, addressing relevant use cases, technical requirements, implementation challenges, and practical considerations for RIS deployment optimization in the context of 6G networks. A hardware design of an RIS with liquid crystal at 28 GHz is presented. A propagation model for RIS as a new part of the system architecture is discussed, with approaches of semi-empirical models, geometric models, and their combination through the application of artificial intelligence/machine learning. Finally, a channel model for deployment optimization and dimensioning is presented, with the findings that a rather large RIS is favorable for coverage improvement, as well as greater attenuation at higher frequencies combined with a smaller RIS size.

eess.SP↗
arXiv2022

Little or no equalization is needed in energy-efficient sub-THz mobile access

By trading coverage and hardware complexity for abundance of spectrum, sub-THz mobile access networks are expected to operate under highly directive and relatively spectrally inefficient transmission regimes, while still offering enormous capacity gains over current sub-6GHz alternatives. Building on this assumption, and supported by extensive indoor directional channel measurements at 160 GHz, this study advocates the use of very simple modulation and equalization techniques for sub-THz mobile access. Specifically, we demonstrate that, under the aforementioned transmission regimes, little or no equalization is needed for scoring significant capacity gain targets. In particular, we show that single-carrier or low-number-of-subcarriers modulations are very attractive competitors to the dramatically more complex and energy inefficient traditional multi-carrier designs.

cs.IT↗
arXiv2022

Observations on the Angular Statistics of the Indoor Sub-THz Radio Channel at 158 GHz

This paper presents selected results from a channel measurement campaign conducted in a shopping mall scenario at 158 GHz. The focus is on the statistical analysis of the collected measurement data in terms of directional channel gain. Although most power is received from the line-of-sight (LOS) direction, significant multipaths arrive from all measured azimuth directions. The median of the sorted directional channel gain can be approximated by a linear curve showing an offset of about 10 dB with respect to the LOS direction.

eess.SP↗
arXiv2020

On the Dynamic Range of Digital Correlative Time Domain Radio Channel Measurements

For the concise characterization of radio channel measurement setups, different performance metrics like dynamic range and maximum measurable path loss have been proposed. This work further elaborates on these metrics and discusses practical bounds for the class of digital correlative time domain channel sounders. From a general instrumentation model, relevant nonidealities and the resulting effects on measurement performance are identified. These considerations yield the tools to select appropriate measurement parameters for a given scenario and assess the overall performance of a particular measurement setup. The findings are further illustrated with data acquired from an instrument-based measurement setup.

eess.SP↗
arXiv2020

Measurement and Characterization of an Indoor Industrial Environment at 3.7 and 28 GHz

Fifth generation (5G) mobile networks are expected to play an increasing role in industrial communication with private mobile communication networks deployed on company premises. For planning, standardization and product development, it is crucial to to thoroughly understand the radio channel characteristics of such environments. Frequencies around 3.7 GHz were already reserved by regulation authorities and to meet the increasing demand for higher bandwidths, spectrum in the millimeter wave range around 28 GHz is targeted. This paper presents a wideband channel measurement campaign at both 3.7 and 28 GHz with direction-of-arrival information at 28 GHz. The results are compared to the 3GPP TR 38.901 Indoor Factory model and to two other recent papers. Evaluation of path loss and RMS delay and angle spread show the unique nature of industrial indoor environments.

eess.SP↗
arXiv2020

THz Channel Sounding: Design and Validation of a High Performance Channel Sounder at 300 GHz

In this paper, a novel instrument-based time-domain THz channel sounder for the 300 GHz band is introduced. The performance is characterized by conducted measurements and verified by over-the-air measurements, which confirm the sensitivity and highlight the temporal resolution of the setup. Dynamic range, maximum measurable path loss and phase stability are evaluated. The results show that the performance in terms of dynamic range and maximum measurable path loss is, to the best knowledge of the authors, unprecedented in this frequency range.

eess.SP↗
arXiv2019

Directional Wideband Channel Measurements at 28 GHz in an Industrial Environment

With the expected adoption of millimeter wave technologies for industrial communication, it is fundamentally important to properly understand the radio channel characteristics of such environments. This paper presents the setup, scenario and results of a measurement campaign at 28 GHz in a machine hall. The radio channel was measured with a bandwidth of 2 GHz and both large scale parameters and directional information were extracted. Evaluation of the power delay profiles shows that the channel contains dense multipath components. A path loss model is parameterized and blockage losses, RMS delay and angle spreads are evaluated. Comparison with the 3GPP TR 38.901 channel model shows that none of the currently defined scenarios is a fit for industrial settings. This emphasizes the need for a newly defined scenario with an industry specific parameter set.

eess.SP↗
arXiv2018

Minimizing Event-Handling Latencies in Secure Virtual Machines

Virtualization, after having found widespread adoption in the server and desktop arena, is poised to change the architecture of embedded systems as well. The benefits afforded by virtualization - enhanced isolation, manageability, flexibility, and security - could be instrumental for developers of embedded systems as an answer to the rampant increase in complexity. While mature desktop and server solutions exist, they cannot be easily reused on embedded systems because of markedly different requirements. Unfortunately, optimizations aimed at throughput, important for servers, often compromise on aspects like predictable real-time behavior, which are crucial to many embedded systems. In a similar vein, the requirements for small trusted computing bases, lightweight inter-VM communication, and small footprints are often not accommodated. This observation suggests that virtual machines for embedded systems should be constructed from scratch with particular attention paid to the specific requirements. In this paper, we set out with a virtual machine designed for security-conscious workloads and describe the steps necessary to achieve good event-handling latencies. That evolution is possible because the underlying microkernel is well suited to satisfy real-time requirements. As the guest system we chose Linux with the PREEMPT_RT configuration, which itself was developed in an effort to bring down event-handling latencies in a general purpose system. Our results indicate that the increase of event-handling latencies of a guest running in a virtual machine does not, compared to native execution, exceed a factor of two.

cs.OS↗
arXiv2017

On the Frequency Dependency of Radio Channel's Delay Spread: Analyses and Findings From mmMAGIC Multi-frequency Channel Sounding

This paper analyzes the frequency dependency of the radio propagation channel's root mean square (rms) delay spread (DS), based on the multi-frequency measurement campaigns in the mmMAGIC project. The campaigns cover indoor, outdoor, and outdoor-to-indoor (O2I) scenarios and a wide frequency range from 2 to 86 GHz. Several requirements have been identified that define the parameters which need to be aligned in order to make a reasonable comparison among the different channel sounders employed for this study. A new modelling approach enabling the evaluation of the statistical significance of the model parameters from different measurements and the establishment of a unified model is proposed. After careful analysis, the conclusion is that any frequency trend of the DS is small considering its confidence intervals. There is statistically significant difference from the 3GPP New Radio (NR) model TR 38.901, except for the O2I scenario.

cs.IT↗
arXiv2017

Challenges & Solutions for above 6 GHz Radio Access Network Integration for Future Mobile Communication Systems

Mobile communication technology has been rapidly evolving ever since its first introduction in the late 1980s. The development witnessed is not just in the refinement of the radio access techniques, but also in the progression towards offering sophisticated features and services to the mobile phone users. To fulfill this ever-growing user demand and market trends, frequency ranges in millimeter wave bands are envisioned for wireless radio transmission. To respond to this trends, the EU-funded mmMAGIC project has been launched and its main objective is to design and develop radio access techniques operating in 6-100 GHz bands. When it comes to developing technologies for systems operating these frequency ranges, a major challenge encountered will be in terms of its radio access network integration. Unquestionably, issues at various aspects of physical layer design, channel modelling, architecture, network functions and deployment will be encountered; problems in multi-node and multi-antenna transceiver designs will surface as well. The work carried in this project will address those challenges and propose solutions; but additionally, measure its efficiency against the project specific KPIs set to meet the requirements of the operational future 5G systems. The main intention of this paper is to outline some of the challenges, more specifically to highlight the network integration challenges, and discuss some of its technical solutions. The primary purpose here is to focus towards integrated 5G technology, thereby opening further research avenues for the exploration of new and alternate frequency bands in the electromagnetic spectrum.

cs.IT↗
arXiv2014

Singular spin-wave theory and scattering continua in the cone state of Cs_2CuCl_4

For temperatures below 0.6 K the geometrically frustrated layered quantum antiferromagnet Cs$_2$CuCl$_4$ in a magnetic field perpendicular to the layers orders magnetically in a so-called cone state, where the magnetic moments have a finite component in the field direction while their projection onto the layers forms a spiral. Modeling this system by a two-dimensional spatially anisotropic quantum Heisenberg antiferromagnet with Dzyaloshinskii-Moriya interaction, we find that even for vanishing temperature the usual spin-wave expansion is plagued by infrared divergencies which are due to the coupling between longitudinal and transverse spin fluctuations in the cone state. Similar divergencies appear also in the ground state of the interacting Bose gas in two and three dimensions. Using known results for the correlation functions of the interacting Bose gas, we present a non-perturbative expression for the dynamic structure factor in the cone state of Cs$_2$CuCl$_4$. We show that in this state the spectral line shape of spin fluctuations exhibits singular scattering continua which can be understood in terms of the well-known anomalous longitudinal fluctuations in the ground state of the two-dimensional Bose gas.

cond-mat.str-el↗