arXiv subjects

Matthew Ware

Publications and source records attributed to Matthew Ware.

11 recordsLinked to original sources

arXiv2025

Parameter Analysis and Optimization of Layer Fidelity for Quantum Processor Benchmarking at Scale

With the continued scaling of quantum processors, holistic benchmarks are essential for extensively evaluating device performance. Layer fidelity is a benchmark well-suited to assessing processor performance at scale. Key advantages of this benchmark include its natural alignment with randomized benchmarking (RB) procedures, crosstalk awareness, fast measurements over large numbers of qubits, high signal-to-noise ratio, and fine-grained information. In this work, we extend the analysis of the original layer fidelity manuscript to optimize parameters of the benchmark and extract deeper insights of its application. We present a robust protocol for identifying optimal qubit chains of arbitrary length N, demonstrating that our method yields error per layered gate (EPLG) values 40% - 70% lower than randomly selected chains for N=100 qubits. We further establish layer fidelity as an effective performance monitoring tool, capturing both edge-localized and device-wide degradation by tracking optimal chains of length 50 and 100, and fixed chains of length 100. Additionally, we refine error analysis by proposing parameter bounds on the number of randomizations and Clifford lengths used in direct RB fits, minimizing fit uncertainties. Finally, we use layer fidelity to analyze the impact of varying gate durations on layered two-qubit (2Q) errors, showing that prolonged gate times leading to idling times significantly increase these quantities. These findings extend the applicability of the layer fidelity benchmark and provide practical guidelines for optimizing quantum processor evaluations.

quant-ph↗

arXiv2023

Femtosecond electronic and hydrogen structural dynamics in ammonia imaged with ultrafast electron diffraction

Directly imaging structural dynamics involving hydrogen atoms by ultrafast diffraction methods is complicated by their low scattering cross-sections. Here we demonstrate that megaelectronvolt ultrafast electron diffraction is sufficiently sensitive to follow hydrogen dynamics in isolated molecules. In a study of the photodissociation of gas phase ammonia, we simultaneously observe signatures of the nuclear and corresponding electronic structure changes resulting from the dissociation dynamics in the time-dependent diffraction. Both assignments are confirmed by ab initio simulations of the photochemical dynamics and the resulting diffraction observable. While the temporal resolution of the experiment is insufficient to resolve the dissociation in time, our results represent an important step towards the observation of proton dynamics in real space and time.

physics.chem-ph↗

arXiv2021

Miniaturizing transmon qubits using van der Waals materials

Quantum computers can potentially achieve an exponential speedup versus classical computers on certain computational tasks, as recently demonstrated in systems of superconducting qubits. However, these qubits have large footprints due to their large capacitor electrodes needed to suppress losses by avoiding dielectric materials. This tactic hinders scaling by increasing parasitic coupling among circuit components, degrading individual qubit addressability, and limiting the spatial density of qubits. Here, we take advantage of the unique properties of the van der Waals (vdW) materials to reduce the qubit area by a factor of $>1000$ while preserving the required capacitance without increasing substantial loss. Our qubits combine conventional aluminum-based Josephson junctions with parallel-plate capacitors composed of crystalline layers of superconducting niobium diselenide (NbSe$_2$) and insulating hexagonal-boron nitride (hBN). We measure a vdW transmon $T_1$ relaxation time of 1.06 $\mu$s, which demonstrates a path to achieve high-qubit-density quantum processors with long coherence times, and illustrates the broad utility of layered heterostructures in low-loss, high-coherence quantum devices.

quant-ph↗

arXiv2021

Characterizing mid-circuit measurements on a superconducting qubit using gate set tomography

Measurements that occur within the internal layers of a quantum circuit -- mid-circuit measurements -- are an important quantum computing primitive, most notably for quantum error correction. Mid-circuit measurements have both classical and quantum outputs, so they can be subject to error modes that do not exist for measurements that terminate quantum circuits. Here we show how to characterize mid-circuit measurements, modelled by quantum instruments, using a technique that we call quantum instrument linear gate set tomography (QILGST). We then apply this technique to characterize a dispersive measurement on a superconducting transmon qubit within a multiqubit system. By varying the delay time between the measurement pulse and subsequent gates, we explore the impact of residual cavity photon population on measurement error. QILGST can resolve different error modes and quantify the total error from a measurement; in our experiment, for delay times above 1000 ns we measured a total error rate (i.e., half diamond distance) of $\epsilon_{\diamond} = 8.1 \pm 1.4 \%$, a readout fidelity of $97.0 \pm 0.3\%$, and output quantum state fidelities of $96.7 \pm 0.6\%$ and $93.7 \pm 0.7\%$ when measuring $0$ and $1$, respectively.

quant-ph↗

arXiv2021

Deep Neural Network Discrimination of Multiplexed Superconducting Qubit States

Demonstrating a quantum computational advantage will require high-fidelity control and readout of multi-qubit systems. As system size increases, multiplexed qubit readout becomes a practical necessity to limit the growth of resource overhead. Many contemporary qubit-state discriminators presume single-qubit operating conditions or require considerable computational effort, limiting their potential extensibility. Here, we present multi-qubit readout using neural networks as state discriminators. We compare our approach to contemporary methods employed on a quantum device with five superconducting qubits and frequency-multiplexed readout. We find that fully-connected feedforward neural networks increase the qubit-state-assignment fidelity for our system. Relative to contemporary discriminators, the assignment error rate is reduced by up to 25% due to the compensation of system-dependent nonidealities such as readout crosstalk which is reduced by up to one order of magnitude. Our work demonstrates a potentially extensible building block for high-fidelity readout relevant to both near-term devices and future fault-tolerant systems.

quant-ph↗

arXiv2019

Cross-resonance interactions between superconducting qubits with variable detuning

Cross-resonance interactions are a promising way to implement all-microwave two-qubit gates with fixed-frequency qubits. In this work, we study the dependence of the cross-resonance interaction rate on qubit-qubit detuning and compare with a model that includes the higher levels of a transmon system. To carry out this study we employ two transmon qubits--one fixed frequency and the other flux tunable--to allow us to vary the detuning between qubits. We find that the interaction closely follows a three-level model of the transmon, thus confirming the presence of an optimal regime for cross-resonance gates.

quant-ph↗

arXiv2018

Experimental demonstration of Pauli-frame randomization on a superconducting qubit

The promise of quantum computing with imperfect qubits relies on the ability of a quantum computing system to scale cheaply through error correction and fault-tolerance. While fault-tolerance requires relatively mild assumptions about the nature of qubit errors, the overhead associated with coherent and non-Markovian errors can be orders of magnitude larger than the overhead associated with purely stochastic Markovian errors. One proposal to address this challenge is to randomize the circuits of interest, shaping the errors to be stochastic Pauli errors but leaving the aggregate computation unaffected. The randomization technique can also suppress couplings to slow degrees of freedom associated with non-Markovian evolution. Here we demonstrate the implementation of Pauli-frame randomization in a superconducting circuit system, exploiting a flexible programming and control infrastructure to achieve this with low effort. We use high-accuracy gate-set tomography to characterize in detail the properties of the circuit error, with and without the randomization procedure, which allows us to make rigorous statements about Markovianity as well as the nature of the observed errors. We demonstrate that randomization suppresses signatures of non-Markovian evolution to statistically insignificant levels, from a Markovian model violation ranging from $43\sigma$ to $1987\sigma$, down to violations between $0.3\sigma$ and $2.7\sigma$ under randomization. Moreover, we demonstrate that, under randomization, the experimental errors are well described by a Pauli error model, with model violations that are similarly insignificant (between $0.8\sigma$ and $2.7\sigma$). Importantly, all these improvements in the model accuracy were obtained without degradation to fidelity, and with some improvements to error rates as quantified by the diamond norm.

quant-ph↗

arXiv2015

Transient dynamics of a superconducting nonlinear oscillator

We investigate the transient dynamics of a lumped-element oscillator based on a dc superconducting quantum interference device (SQUID). The SQUID is shunted with a capacitor forming a nonlinear oscillator with resonance frequency in the range of several GHz. The resonance frequency is varied by tuning the Josephson inductance of the SQUID with on-chip flux lines. We report measurements of decaying oscillations in the time domain following a brief excitation with a microwave pulse. The nonlinearity of the SQUID oscillator is probed by observing the ringdown response for different excitation amplitudes while the SQUID potential is varied by adjusting the flux bias. Simulations are performed on a model circuit by numerically solving the corresponding Langevin equations incorporating the SQUID potential at the experimental temperature and using parameters obtained from separate measurements characterizing the SQUID oscillator. Simulations are in good agreement with the experimental observations of the ringdowns as a function of applied magnetic flux and pulse amplitude. We observe a crossover between the occurrence of ringdowns close to resonance and adiabatic following at larger detuning from the resonance. We also discuss the occurrence of phase jumps at large amplitude drive. Finally, we briefly outline prospects for a readout scheme for superconducting flux qubits based on the discrimination between ringdown signals for different levels of magnetic flux coupled to the SQUID.

cond-mat.supr-con↗

arXiv2014

Copper waveguide cavities with reduced surface loss for coupling to superconducting qubits

Significant improvements in superconducting qubit coherence times have been achieved recently with three-dimensional microwave waveguide cavities coupled to transmon qubits. While many of the measurements in this direction have utilized superconducting aluminum cavities, other recent work has involved qubits coupled to copper cavities with coherence times approaching 0.1 ms. The copper provides a good path for thermalizing the cavity walls and qubit chip, although the substantial cavity loss makes conventional dispersive qubit measurements challenging. We are exploring various approaches for improving the quality factor of three-dimensional copper cavities, including electropolishing and coating with superconducting layers of tin. We have characterized these cavities on multiple cooldowns and found the tin-plating to be robust. In addition, we have performed coherence measurements on transmon qubits in these cavities and observed promising performance.

cond-mat.supr-con↗

arXiv2013

First-order sideband transitions with flux-driven asymmetric transmon qubits

We demonstrate rapid, first-order sideband transitions between a superconducting resonator and a frequency-modulated transmon qubit. The qubit contains a substantial asymmetry between its Josephson junctions leading to a linear portion of the energy band near the resonator frequency. The sideband transitions are driven with a magnetic flux signal of a few hundred MHz coupled to the qubit. This modulates the qubit splitting at a frequency near the detuning between the dressed qubit and resonator frequencies, leading to rates up to 85 MHz for exchanging quanta between the qubit and resonator.

cond-mat.supr-con↗

arXiv2012

Process verification of two-qubit quantum gates by randomized benchmarking

We implement a complete randomized benchmarking protocol on a system of two superconducting qubits. The protocol consists of randomizing over gates in the Clifford group, which experimentally are generated via an improved two-qubit cross-resonance gate implementation and single-qubit unitaries. From this we extract an optimal average error per Clifford of 0.0936. We also perform an interleaved experiment, alternating our optimal two-qubit gate with random two-qubit Clifford gates, to obtain a two-qubit gate error of 0.0653. We compare these values with a two-qubit gate error of ~0.12 obtained from quantum process tomography, which is likely limited by state preparation and measurement errors.

quant-ph↗