arXiv subjects

Mark Barnet

Publications and source records attributed to Mark Barnet.

3 recordsLinked to original sources

arXiv2026

LUVCam: A high-performance, low-cost, UV/optical camera for the future of astronomy in space

Astronomy-grade cameras with robust performance and heritage in the space environment have long been costly, substantially limiting capacity for space-based astronomy and creating a resource barrier to access. Additionally, ultraviolet observations have historically been limited by the low quantum efficiency of most sensors in this wavelength range. The LUVCam program is designed to address both issues by providing a high-performance, low-cost, UV/optical camera system sufficiently capable to support a wide-array of space-based astronomy missions. LUVCam features a large format, low-noise, large pixel, and high quantum efficiency, commercial-off-the-shelf back(front)-side illuminated CMOS sensor, packaged with custom built readout electronics, firmware, and thermomechanical structure to provide both superlative science capability and precision on-sensor guidance at fast cadence to allow for stable high-resolution imaging. LUVCam is ITAR-free and cheap to fabricate, opening up new opportunities for access to space telescopes. Here we introduce LUVCam, describe its performance characteristics, and the rapid implementation of a technology demonstration for flight. LUVCam, coupled with a small aperture custom-built UV telescope, has been on orbit since July 2024 and has achieved Technology Readiness Level (TRL) 7. LUVCam is manifested for several more near-term orbital missions, including a second technology demonstration CubeSat for launch in 2026, and will provide both focal plane cameras for QUVIK, a two-channel UV transient astronomy mission.

astro-ph.IM↗

arXiv2026

GRBAlpha, VZLUSAT-2 and GRBBeta -- GRB observations with CubeSats

Results from GRBAlpha, VZLUSAT-2 and GRBBeta CubeSats and their on-board gamma-ray detectors for monitoring transients are summarised in this article. GRBAlpha was a 1U CubeSat launched in March 2021 to a 550 km altitude polar orbit carrying a CsI(Tl) scintillator gamma-ray burst (GRB) detector with a sensitive range of approximately 30-900 keV. It successfully operated for over four years until June 2025 when it de-orbited. VZLUSAT-2 was a 3U CubeSat launched in January 2022 to a 535 km altitude polar orbit and de-orbited in November 2025 after almost four years of smooth operation. It carried on board two GRB detectors very similar to the one used on GRBAlpha. Both missions have detected about 360 gamma-ray transients, including over 170 long and short gamma-ray bursts (GRBs), and including the most intense GRB ever recorded GRB 221009A and the second brightest GRB 230307A. The new family member, GRBBeta 2U CubeSat, integrated at Masaryk University, was launched in July 2024 to a 580 km altitude, 62 degree inclination orbit. It has been detecting GRBs since its launch without any trouble. Gamma-ray detectors on these nanosatellites are based on CsI(Tl) scintillator readout by silicon photomultipliers (SiPMs). These missions also provide a unique opportunity to study the radiation damage of SiPMs in the low Earth orbit environment and monitor the radiation belts. We have demonstrated that CubeSats can be used in missions lasting beyond three years and routinely detect GRBs.

astro-ph.HE↗

arXiv2024

Experimental demonstration of photonic phase correctors based on grating coupler arrays and thermo-optic shifters

In ground-based astronomy, the ability to couple light into single-mode fibers (SMFs) is limited by atmospheric turbulence, which prohibits the use of many astrophotonic instruments. We propose a silicon-on-insulator photonic chip capable of coherently coupling the out-of-phase beamlets from the subapertures of a telescope pupil into an SMF. The photonic integrated circuit (PIC) consists of an array of grating couplers that are used to inject light from free space into single-mode waveguides on the chip. Metallic heaters modulate the refractive index of a coiled section of the waveguides, facilitating the co-phasing of the propagating modes. The phased beamlets can then be coherently combined to efficiently deliver the light to an output SMF. In an adaptive optics (AO) system, the phase corrector acts as a deformable mirror (DM) commanded by a controller that takes phase measurements from a wavefront sensor (WFS). We present experimental results for the PIC tested on an AO testbed and compare the performance to simulations.

astro-ph.IM↗