arXiv subjects

M. Ge

Publications and source records attributed to M. Ge.

12 recordsLinked to original sources

arXiv2025

Einstein Probe discovery of the short period intermediate polar EP J115415.8-501810

The X-ray transient source EP240309a/EP\,J115415.8$-$501810 was first detected by the Wide-Field X-ray Telescope (WXT) on board Einstein Probe (EP) during the commissioning phase. Subsequent optical observations confirmed it as a Cataclysmic Variable of the intermediate polar type with a 238.2\,s spinning white dwarf in a $\sim$3.76\,hr orbit. We report on the source discovery and follow-up studies made with the Follow-up X-ray Telescope (FXT) of EP. A periodic variation of 231\,s is detected in the 0.3$-$2\,keV band, while no obvious pulsation appears in the 2$-$10\,keV band. The spectral analysis shows that the X-ray emission could be described by an absorbed bremsstrahlung model with $kT$\textgreater\,11\,keV. The partial covering absorption, with an hydrogen column density $N_H$ = 2.0$\times 10^{22}\,\rm cm^{-2}$ and covering fraction around 0.9, is much larger than the interstellar absorption along the line of sight. According to the distance $d = 309.5$\,pc obtained from Gaia parallax, we estimate that the luminosity of this source in the 0.3$-$10\,keV range is $\sim 2\times10^{32}$\,erg\,s$^{-1}$. In addition, phase-resolved spectral analysis reveals that the detected periodic variation is mainly caused by the change in the absorption column density. In this scenario the spin modulation arises due to absorption from the pre-shock accretion flow of the X-ray emitting pole, while the optical radiation is modulated at the orbital side band ($\omega_{\rm spin} - \Omega_{\rm orbit}$) due to reprocessing in regions within the binary system. Due to its unusual transient behaviour for an intermediate polar, we have also searched for radio signals similar to those observed in the new class of long period transients. We derived upper limits with ASKAP (200--300\,$\mu$Jy\,beam$^{-1}$ between 800--1500 MHz) and MWA (40--90\,mJy\,beam$^{-1}$ between 80--300 MHz).

astro-ph.HE↗

arXiv2023

Simultaneous and panchromatic observations of the Fast Radio Burst FRB 20180916B

Aims. Fast Radio Bursts are bright radio transients whose origin has not yet explained. The search for a multi-wavelength counterpart of those events can put a tight constrain on the emission mechanism and the progenitor source. Methods. We conducted a multi-wavelength observational campaign on FRB 20180916B between October 2020 and August 2021 during eight activity cycles of the source. Observations were led in the radio band by the SRT both at 336 MHz and 1547 MHz and the uGMRT at 400 MHz. Simultaneous observations have been conducted by the optical telescopes Asiago (Galileo and Copernico), CMO SAI MSU, CAHA 2.2m, RTT-150 and TNG, and X/Gamma-ray detectors on board the AGILE, Insight-HXMT, INTEGRAL and Swift satellites. Results. We present the detection of 14 new bursts detected with the SRT at 336 MHz and seven new bursts with the uGMRT from this source. We provide the deepest prompt upper limits in the optical band fro FRB 20180916B to date. In fact, the TNG/SiFAP2 observation simultaneous to a burst detection by uGMRT gives an upper limit E_optical / E_radio < 1.3 x 10^2. Another burst detected by the SRT at 336 MHz was also co-observed by Insight-HMXT. The non-detection in the X-rays yields an upper limit (1-30 keV band) of E_X-ray / E_radio in the range of (0.9-1.3) x 10^7, depending on which model is considered for the X-ray emission.

astro-ph.HE↗

arXiv2018

Planar Hall effect in type-II Weyl semimetal WTe2

Adler-Bell-Jackiw chiral anomaly is a representative feature arising from the topological nature in topological semimetal. We report the first experimental observation of giant planar Hall effect in type-II Weyl semimetal WTe2. Our comprehensive analyes of the experimental data demonstrate that the detected planar Hall effect is originated from the chiral anomaly of Weyl fermions. Unlike the somewhat elusive negative magnetoresistance, the planar Hall effect is robust and easy to be detected in type-II Weyl semimetal. This work reveals that the planar Hall effect is an effective transport probe to determine the topological nature of topological semimetals, especially in type-II Weyl semimetals.

cond-mat.mtrl-sci↗

arXiv2017

Non-stoichiometry effects on the extreme magnetoresistance in Weyl semimetal WTe2

Non-stoichiometry effect on the extreme magnetoresistance is systematically investigated for the Weyl semimetal WTe2. Magnetoresistance and Hall resistivity are measured for the as-grown samples with a slight difference in Te vacancies and the annealed samples with increased Te vacancies. The fittings to a two-carrier model show that the magnetoresistance is strongly dependent on the residual resistivity ratio (i.e., the degree of non-stoichiometry), which is eventually understood in terms of electron doping which not only breaks the balance between electron-type and hole-type carrier densities but also reduces the average carrier mobility. Thus, compensation effect and ultrahigh mobility are probably the main driving force of the extreme magnetoresistance in WTe2.

cond-mat.mtrl-sci↗

arXiv2017

CBETA Design Report, Cornell-BNL ERL Test Accelerator

This design report describes the construction plans for the world's first multi-pass SRF ERL. It is a 4-pass recirculating linac that recovers the beam's energy by 4 additional, decelerating passes. All beams are returned for deceleration in a single beam pipe with a large-momentum-aperture permanent magnet FFAG optics. Cornell University has been pioneering a new class of accelerators, Energy Recovery Linacs (ERLs), with a new characteristic set of beam parameters. Technology has been prototyped that is essential for any high brightness electron ERL. This includes a DC electron source and an SRF injector Linac with world-record current and normalized brightness in a bunch train, a high-current linac cryomodule, and a high-power beam stop, and several diagnostics tools for high-current and high-brightness beams. All these are now being used to construct a novel one-cryomodule ERL in Cornell's Wilson Lab. Brookhaven National Laboratory (BNL) has designed a multi-turn ERL for eRHIC, where beam is transported more than 20 times around the 4km long RHIC tunnel. The number of transport lines is minimized by using two arcs with strongly-focusing permanent magnets that can control many beams of different energies. A collaboration between BNL and Cornell has been formed to investigate this multi-turn eRHIC ERL design by building a 4-turn, one-cryomodule ERL at Cornell. It also has a return loop built with strongly focusing permanent magnets and is meant to accelerate 40mA beam to 150MeV. This high-brightness beam will have applications beyond accelerator research, in industry, in nuclear physics, and in X-ray science.

physics.acc-ph↗

arXiv2015

A temperature-mapping system for multi-cell SRF accelerating cavities

A Temperature mapping (T-map) system for Superconducting Radio Frequency (SRF) cavities consists of a thermometer array positioned precisely on an exterior cavity wall, capable of detecting small increases in temperature; therefore it is a powerful tool for research on the quality factor (Q0) of SRF cavities. A new multi-cell T-mapping system is has been developed at Cornell University. The system has nearly two thousand thermometers to cover 7-cell SRF cavities for Cornell ERL project. A new multiplexing scheme was adopted to reduce number of wires. A 1mK resolution of the temperature increase Delta T is achieved. A 9-cell cavity of TESLA geometry was tested with the T-map system. By converting Delta T to power loss and quality factor, it has been found that for this cavity, most surface losses were generated by the first cell when the accelerating gradient is increased above 15MV/m. The comparison of Q-value between with and without hotspots shows the heating on cavity wall degraded cavity Q0 about 1.65 times. The power loss on the hotspots is about 40% of the total power. Effective and intuitive ways of displaying surface properties of the cavity interior, e.g. the residual resistivity, will be shown.

physics.acc-ph↗

arXiv2015

Field-dependent surface resistance of a superconducting RF cavity caused by surface impurity

Q-slope issue, which is caused by the field dependent surface resistance, puzzled people for a long time in SRF fields. In this paper, we related the Q-slope with surface treatments; and proposed a surface-impurity model to explain the field-dependent of surface resistance of SRF cavities. Eighteen cavity-test results have been analyzed to examine the model. These cavities were treated by different recipes: Nitrogen-doping; BCP and HF-rinsing; EP with 120{\deg}C baking; and EP without 120{\deg}C baking. The performance of these cavities, which is normally represented by cavity quality factor versus accelerating gradient or surface magnetic field curves (Q0 vs. Eacc or Q0 vs. B), has included all types of Q-slope, such as Low-field Q-slope, Medium-field Q-slope, and Anti-Q-slope. The data fittings are quite successful; the fitting results will be shown. The model can be used to evaluate the effectiveness of the surface treatments. At last, the paper discussed the way to build a high-Q high-gradient SRF cavity.

physics.acc-ph↗

arXiv2014

Extracting superconducting parameters from surface resistivity by using inside temperatures of SRF cavities

The surface resistance of an RF superconductor depends on the surface temperature, the residual resistance and various superconductor parameters, e.g. the energy gap, and the electron mean free path. These parameters can be determined by measuring the quality factor Q0 of a SRF cavity in helium-baths of different temperatures. The surface resistance can be computed from Q0 for any cavity geometry, but it is not trivial to determine the temperature of the surface when only the temperature of the helium bath is known. Traditionally, it was approximated that the surface temperature on the inner surface of the cavity was the same as the temperature of the helium bath. This is a good approximation at small RF-fields on the surface, but to determine the field dependence of Rs, one cannot be restricted to small field losses. Here we show the following: (1) How computer simulations can be used to determine the inside temperature Tin so that Rs(Tin) can then be used to extract the superconducting parameters. The computer code combines the well-known programs, the HEAT code and the SRIMP code. (2) How large an error is created when assuming the surface temperature is same as the temperature of the helium bath? It turns out that this error is at least 10% at high RF-fields in typical cases.

physics.acc-ph↗

arXiv2012

Investigations of surface quality and SRF cavity performance

Magnetic field enhancement has been studied in the past through replica and cavity cutting. Considerable progress of niobium cavity manufacturing and processing has been made since then. Wide variety of single cell cavities has been analyzed through replica technique. Their RF performances were compared in corresponding to geometric RF surface quality. It is concluded that the surface roughness affects cavity performance mostly in secondary role. The other factors must have played primary role in cavity performance limitations.

physics.acc-ph↗

arXiv2011

Lattice-Driven Magnetoresistivity and Metal-Insulator Transition in Single-Layered Iridates

Sr2IrO4 exhibits a novel insulating state driven by spin-orbit interactions. We report two novel phenomena, namely a large magnetoresistivity in Sr2IrO4 that is extremely sensitive to the orientation of magnetic field but exhibits no apparent correlation with the magnetization, and a robust metallic state that is induced by dilute electron (La3+) or hole (K+) doping for Sr2+ ions in Sr2IrO4. Our structural, transport and magnetic data reveal that a strong spin-orbit interaction alters the balance between the competing energies so profoundly that (1) the spin degree of freedom alone is no longer a dominant force; (2) underlying transport properties delicately hinge on the Ir-O-Ir bond angle via a strong magnetoelastic coupling; and (3) a highly insulating state in Sr2IrO4 is proximate to a metallic state, and the transition is governed by lattice distortions. This work suggests that a novel class of lattice-driven electronic materials can be developed for applications.

cond-mat.str-el↗

arXiv2010

Giant Magnetoelectric Effect in Antiferromagnetic BaMnO3-\delta and Its Derivatives

Hexagonal perovskite 15R-BaMnO2.99 with a ratio of cubic to hexagonal layers of 1/5 in the unit cell is an antiferromagnetic insulator that orders at a N\'eel temperature TN = 220 K. Here we report structural, magnetic, dielectric and thermal properties of single crystal BaMnO2.99 and its derivatives BaMn0.97Li0.03O3 and Ba0.97K0.03MnO3. The central findings of this work are: (1) these materials possess a usually large, high-temperature magnetoelectric effect that amplifies the dielectric constant by more than an order of magnitude near their respective N\'eel temperature; (2) Li and K doping can readily vary the ratio of cubic to hexagonal layers and cause drastic changes in dielectric and magnetic properties; in particular, a mere 3% Li substitution for Mn significantly weakens the magnetic anisotropy and relaxes the lattice; consequently, the dielectric constant for both the a- and c-axis sharply rises to 2500 near the N\'eel temperature. This lattice softening is also accompanied by weak polarization. These findings provide a new paradigm for developing novel, high-temperature magnetoelectric materials that may eventually contribute to technology.

cond-mat.str-el↗

arXiv2008

Pressure effect on superconductivity and magnetism in FeSex

In this paper, pressure effect on superconductivity and magnetism has been investigated in FeSex (x = 0.80, 0.88). The magnetization curves display anomaly at Ts1 106 K and Ts2 78 K except for the superconducting diamagnetic transition around Tc 8 K. The magnetic anomaly at Ts1 and Ts2 can be related to a ferromagnetic and an antiferromagnetic phase transition, respectively, as revealed by specific heat measurements. The application of pressure not only raises Tc, but also increases both Ts1 and Ts2. This system shows clear evidence that superconductivity arises in a phase with strong magnetic character and the superconductivity coexists with magnetism. In addition, the specific heat anomaly associated with the superconducting transition seems to be absent.

cond-mat.supr-con↗