arXiv Science⌕ Search

arXiv subjects

M. Boukhicha

Publications and source records attributed to M. Boukhicha.

3 recordsLinked to original sources

Graphene Transfer for Vertical Amorphous-Selenium Photodetectors: Fabrication, Optical Transmission and Operation at 77 K

Graphene can serve as a VUV transparent electrode in vertical photodetector devices. Using an optically transparent graphene as a top-electrode of amorphous selenium (a-Se) photoconductor requires transfer process compatible with the thermal and chemical sensitivities of a-Se thin films. The baking and polymer-removal steps of conventional commercial Trivial Transfer graphene procedures are undesirable because heating can promote selenium crystallization and prolonged solvent exposure can cause delamination. We implement two alternatives: PMMA-free transfer of nominal 50-layer graphene and transfer of nominal 10-layer graphene using an approximately 80 nm PMMA support removed in acetone at 40C. Raman G and 2D bands identify graphene after transfer. Separate graphene/MgF2 specimens are characterized by dark-corrected transmission measurements over 120-325 nm and compared with earlier single-layer and nominal 6-8-layer Trivial Transfer spectra. The completed graphene/a-Se/Cr devices produce bias-dependent voltage transients under pulsed 415 nm illumination at 293 K and 77 K. These results establish an a-Se-compatible fabrication route for graphene-electrode devices and demonstrate vertical device operation at both room and cryogenic temperatures. The completed devices provide a platform for detection-efficiency studies, and direct VUV photoresponse measurements now underway.

physics.ins-det↗

Contact gating at GHz frequency in graphene

The paradigm of graphene transistors is based on the gate modulation of the channel carrier density by means of a local channel gate. This standard architecture is subject to the scaling limit of the channel length and further restrictions due to access and contact resistances impeding the device performance. We propose a novel design, overcoming these issues by implementing additional local gates underneath the contact region which allow a full control of the Klein barrier taking place at the contact edge. In particular, our work demonstrates the GHz operation of transistors driven by independent contact gates. We benchmark the standard channel and novel contact gating and report for the later dynamical transconductance levels at the state of the art. Our finding may find applications in electronics and optoelectronics whenever there is need to control independently the Fermi level and the electrostatic potential of electronic sources or to get rid of cumbersome local channel gates.

cond-mat.mes-hall↗

RF-quantum capacitance of the topological insulator Bi2Se3 in the bulk depleted regime for field-effect transistors

A Metal-dielectric-topological insulator capacitor device based on hBN-encapsulated CVD grown Bi2Se3 is realized and investigated in the radio frequency regime. The RF quantum capacitance and device resistance are extracted for frequencies as a high as 10 GHz, and studied as a function of the applied gate voltage. The combination of the superior quality hBN dielectric gate with the optimized transport characteristics of CVD grown Bi2Se3 (n~10^18cm-3 in 8 nm) allow us to attain a bulk depleted regime by dielectric gating. A quantum capacitance minimum is observed revealing a purely Dirac regime, where the Dirac surface state in proximity to the gate reaches charge neutrality, but the bottom surface Dirac cone remains charged, and couples capacitively to the top surface via the insulating bulk. Our work paves the way towards implementation of topological materials in RF devices.

cond-mat.mes-hall↗