Lingda Yu | arXiv Science

arXiv2026

Status report towards implementation of a Compton polarimeter at BEPCII

Precision beam polarization measurements based on Compton polarimeters are essential for the physics program of future high-energy colliders. In order to prepare for these and to extend the scope of physics measurements of the BESIII experiment at the BEPCII, a diagnostic of electron beam transverse polarization at BEPCII is of interest. The design and status report of the commissioning, until July 2025, of this device is reported in this paper. We report unambiguous observation of Compton interaction, discuss current limitations of the experimental setup and draw prospects for improvements and actual measurement of electron beam polarization in the near future.

physics.acc-ph↗

arXiv2017

Commissioning of te China-ADS injector-I testing facility

The 10 MeV accelerator-driven subcritical system (ADS) Injector-I test stand at Institute of High Energy Physics (IHEP) is a testing facility dedicated to demonstrate one of the two injector design schemes [Injector Scheme-I, which works at 325 MHz], for the ADS project in China. The Injector adopted a four vane copper structure RFQ with output energy of 3.2 MeV and a superconducting (SC) section accommodating fourteen \b{eta}g=0.12 single spoke cavities, fourteen SC solenoids and fourteen cold BPMs. The ion source was installed since April of 2014, periods of commissioning are regularly scheduled between installation phases of the rest of the injector. Continuous wave (CW) beam was shooting through the injector and 10 MeV CW proton beam with average beam current around 2 mA was obtained recently. This contribution describe the results achieved so far and the difficulties encountered in CW commissioning.

physics.acc-ph↗