arXiv Science⌕ Search

arXiv subjects

Jose Repond

Publications and source records attributed to Jose Repond.

16 recordsLinked to original sources
arXiv2021

A Measurement of Proton, Deuteron, Triton and Alpha Particle Emission after Nuclear Muon Capture on Al, Si and Ti with the AlCap Experiment

Heavy charged particles after nuclear muon capture are an important nuclear physics background to the muon-to-electron conversion experiments Mu2e and COMET, which will search for charged lepton flavor violation at an unprecedented level of sensitivity. The AlCap experiment measured the yield and energy spectra of protons, deuterons, tritons, and alpha particles emitted after the nuclear capture of muons stopped in Al, Si, and Ti in the low energy range relevant for the muon-to-electron conversion experiments. Individual charged particle types were identified in layered silicon detector packages and their initial energy distributions were unfolded from the observed energy spectra. Detailed information on yields and energy spectra for all observed nuclei are presented in the paper.

physics.ins-det↗
arXiv2018

Characteristics of fast timing MCP-PMTs in magnetic fields

The motivation of this paper is to explore the parameters that affect the performance of Microchannel Plate Photomultiplier Tubes (MCP-PMTs) in magnetic fields with the goal to guide their design to achieve a high magnetic field tolerance. MCP-PMTs based on two different designs were tested.The magnetic field tolerance of MCP-PMT based on a design providing independently biased voltages showed a significant improvement (up to 0.7 T) compared to the one utilizing an internal resistor chain design (up to 0.1 T), indicating the importance of individually adjustable voltages. The effects of the rotation angle of the MCP-PMT relative to the magnetic field direction and of the bias voltage between the photocathode and the top MCP were extensively investigated using the MCP-PMT based on the independently biased voltage design. It was found that the signal amplitude of the MCP-PMT exhibits an enhanced performance at a tilt angle of $\pm$8$^{\circ}$, due to the 8$^{\circ}$ bias angle of the MCP pores. The maximum signal amplitude was observed at different bias voltages depending on the magnetic field strength.

physics.ins-det↗
arXiv2018

Implementation of Maxwell's equations in the reconstruction of the magnetic field in the $g-2$ storage ring

We present a method for implementing the constraints that are implied by Maxwell's equations in fits to measurements of the magnetic field in the muon storage ring of the $g-2$ experiment. The method that we use makes use of toroidal-harmonic solutions of Laplace's equation. We point out that the fitting problem can be approximated well as a linear-algebra problem. We have devised an efficient algorithm for the linear-algebra problem that makes it possible to find a solution for $10^5$ data points and $10^4$ harmonics in less than an hour on a present-day desktop computer. We illustrate our method by applying it to some preliminary measurements of the magnetic field in the $g-2$ storage ring.

physics.ins-det↗
arXiv2017

Rate capability and magnetic field tolerance measurements of fast timing microchannel plate photodetectors

Microchannel plate photodetectors provide both picosecond time resolution and sub-millimeter position resolution, making them attractive photosensors for particle identification detectors of a future U.S. Electron Ion Collider. We have tested the rate capability and magnetic field tolerance of 6$\times$6 cm$^{2}$ microchannel plate photodetectors fabricated at Argonne National Laboratory. The microchannel plate photodetector is designed as a low-cost all-glass vacuum package with a chevron pair stack of next-generation microchannel plates functionalized by atomic layer deposition. The rate capability test was performed using Fermilab's 120 GeV primary proton beam, and the magnetic field tolerance test was performed using a solenoid magnetic with tunable magnetic field strength up to 4 Tesla. The measured gain of the microchannel plate photodetector is stable up to 75 kHz/cm$^{2}$, and varies depending on the applied magnetic field strength and the rotation angle relative to the magnetic field direction.

physics.ins-det↗
arXiv2014

Resistive Plate Chambers for Imaging Calorimetry - the DHCAL

The DHCAL, the Digital Hadron Calorimeter, is a prototype calorimeter based on Resistive Plate Chambers (RPCs). The design emphasizes the imaging capabilities of the detector in an effort to optimize the calorimeter for the application of Particle Flow Algorithms (PFAs) to the reconstruction of hadronic jet energies in a colliding beam environment. The readout of the chambers is segmented into 1 x 1 cm2 pads, each read out with a 1-bit (single threshold) resolution. The prototype with approximately 500,000 readout channels underwent extensive testing in both the Fermilab and CERN test beams. This talk presents preliminary findings from the analysis of data collected at the test beams.

physics.ins-det↗
arXiv2013

Development of Imaging Calorimetry

This paper will argue for continued effort in developing imaging calorimeters for future colliders and/or upgrades to existing detectors. Imaging calorimeters offer a plethora of advantages beyond their application in conjunction with Particle Flow Algorithms. Further R&D is needed to turn the first generation prototypes into viable detectors for colliding beam experiments.

physics.ins-det↗
arXiv2013

Physics at the CLIC e+e- Linear Collider -- Input to the Snowmass process 2013

This paper summarizes the physics potential of the CLIC high-energy e+e- linear collider. It provides input to the Snowmass 2013 process for the energy-frontier working groups on The Higgs Boson (HE1), Precision Study of Electroweak Interactions (HE2), Fully Understanding the Top Quark (HE3), as well as The Path Beyond the Standard Model -- New Particles, Forces, and Dimensions (HE4). It is accompanied by a paper describing the CLIC accelerator study, submitted to the Frontier Capabilities group of the Snowmass process.

hep-ex↗
arXiv2012

Analysis of Muon Events in the DHCAL

The Digital Hadron Calorimeter (DHCAL) is a large prototype of an imaging calorimeter using Resistive Plate Chambers (RPCs) as active media. The readout is segmented into 1\times1 cm2 pads, each with a single bit resolution, hence the denomination of digital. The total channel count is close to 500,000. The DHCAL construction and assembly was completed in fall 2010, followed by a series of test beam campaigns in the FTBF test beam at Fermilab. In this paper we report on the analysis of events collected with the broadband muon beam. These events are utilized to geometrically align the layers horizontally and vertically, to establish the response as function of position on a single readout pad, and to measure the performance characteristics of the RPCs, i.e. the efficiency and average pad multiplicity. The latter were measured in both 'clean' regions of the detector, i.e. away from structures such as the rims of the chambers, and as function of position on the entire vertical plane. In addition, the paper reviews the preliminary measurements of the noise rate in the detector.

physics.ins-det↗
arXiv2011

Development of Particle Flow Calorimetry

This talk reviews the development of imaging calorimeters for the purpose of applying Particle Flow Algorithms (PFAs) to the measurement of hadronic jets at a future lepton collider. After a short introduction, the current status of PFA developments is presented, followed by a review of the major developments in electromagnetic and hadronic calorimetry.

physics.ins-det↗
arXiv2010

Construction of a Digital Hadron Calorimeter

The DHCAL collaboration is assembling a large scale prototype Digital Hadron Calorimeter (DHCAL). The calorimeter utilizes Resistive Plate Chambers (RPCs) as active medium and features of the order of 400,000 1 \times 1 cm2 pads with binary (or digital) electronic readout. The purpose of the prototype is to provide detailed measurements of hadronic showers and to prove the concept of a DHCAL with RPCs as active elements.

physics.ins-det↗
arXiv2010

Tests of a Digital Hadron Calorimeter

In the context of developing a hadron calorimeter with extremely fine granularity for the application of Particle Flow Algorithms to the measurement of jet energies at a future lepton collider, we report on extensive tests of a small scale prototype calorimeter. The calorimeter contained up to 10 layers of Resistive Plate Chambers (RPCs) with 2560 1 \times 1 cm2 readout pads, interleaved with steel absorber plates. The tests included both long-term Cosmic Ray data taking and measurements in particle beams, where the response to broadband muons and to pions and positrons with energies in the range of 1 - 16 GeV was established. Detailed measurements of the chambers efficiency as function of beam intensity have also been performed using 120 GeV protons at varying intensity. The data are compared to simulations based on GEANT4 and to analytical calculations of the rate limitations.

physics.ins-det↗
arXiv2009

Environmental Dependence of the Performance of Resistive Plate Chambers

This paper reports on the performance of Resistive Plate Chambers (RPCs) as function of the gas flow rate through the chambers and of environmental conditions, such as atmospheric pressure, ambient temperature and air humidity. The chambers are read out by pads with an area of 1 x 1 cm2 and a 1-bit resolution per pad. The performance measures include the noise rate as well as the detection efficiency and pad multiplicity for cosmic rays. The measurements extended over a period of almost one year and are sensitive to possible long-term aging effects.

physics.ins-det↗
arXiv2009

Hadron Showers in a Digital Hadron Calorimeter

A small prototype of a finely granulated digital hadron calorimeter with Resistive Plate Chambers as active elements was exposed to positive pions of 1 >. 16 GeV energy from the Fermilab test beam. The event selection separates events with mostly non-interacting particles and events with hadronic showers which initiated in the front part of the calorimeter. The data are compared to a Monte Carlo simulation of the set-up. The paper concludes with predictions for the performance of an extended digital hadron calorimeter.

physics.ins-det↗
arXiv2009

Measurement of Positron Showers with a Digital Hadron Calorimeter

A small prototype of a finely granulated digital hadron calorimeter with Resistive Plate Chambers as active elements was exposed to positrons of 1 . 16 GeV energy from the Fermilab test beam. The response function, energy resolution, as well as measurements of the shape of electromagnetic showers are presented. The data are compared to a Monte Carlo simulation of the set-up.

physics.ins-det↗
arXiv2002

Multi-hadron Final States

This summary aims to highlight major results and insights gained from recent studies of hadronic final states in ep, ppbar, e+e-, as well as relevant theoretical developments, presented in the Multi-hadron final states parallel sessions of the DIS2002 workshop held in Krakow, Poland in May 2002.

hep-ph↗