arXiv Science⌕ Search

arXiv subjects

Jeries Mattar

Publications and source records attributed to Jeries Mattar.

3 recordsLinked to original sources

Power Scaling Across Link Utilization with GPAM-4 Signaling and Event-Driven Reception

This work highlights the potential of combining event-based signaling with event-driven reception to achieve receiver power scaling across link utilization, without requiring wake-up, locking, or data-rate reconfiguration. The approach is demonstrated using the proposed four-level Gaussian pulse-amplitude modulation (GPAM-4) scheme and a corresponding event-driven receiver. By employing a resettable ring voltage-controlled oscillator (RRVCO) as its front end, the receiver achieves inherently event-driven symbol measurement, initiated directly by each received pulse. Symbols are decoded directly from the final RRVCO phase state, eliminating a counter-based back end. Simulated in 28-nm CMOS, the receiver power is evaluated across a $100\times$ range of effective data rates---from 0.15 mW at the peak rate of 8 Gb/s, down to 2.5 $μ$W under active/idle operation and 1.6 $μ$W under data rate change at 80 Mb/s. The receiver thus achieves power reductions of $59.5\times$ and $90.0\times$, while its energy per bit increases by only $1.68\times$ and $1.11\times$, respectively.

cs.ET↗

A FeFET Voltage-to-Time Converter with Offset Trim by Programmed Multilevel State in 28-nm CMOS

The offset and gain of voltage-to-time converters (VTCs) in time-domain circuits vary with process, supply, and temperature. This work presents a VTC whose nonvolatile input-referred offset trim is the programmed multilevel state of the ferroelectric field-effect transistor (FeFET) that converts the input. Fabricated in 28-nm CMOS, the 6.07-$μ$m$^2$ VTC consists of a current-starved inverter with the FeFET and a parallel NMOS leaker in its tail, a capacitor bank, and a following inverter. The programmed state shifts the transfer curve onto the input range, leaving the gain to the capacitor bank and the leaker bias. Measured at 10~MS/s, centered states weaken the second harmonic from $-$12.5~dB in the low-threshold state to $-$32.2~dB and lower the static integral nonlinearity (INL) at 5~bit from 2.42 to 0.92~LSB. Post-layout simulations indicate that the proposed VTC can operate at 500~MS/s, drawing 2.0~$μ$W from a 0.9-V supply, with nearly unchanged distortion and gain up to 700~MS/s. Across simulated process corners and $\pm$10\,\% supply variation, the input-referred offset is calibrated to within 10~mV and the gain to within 4\,\% of nominal by adjusting the programmed state and leaker bias.

cs.ET↗

A Reconfigurable Time-Domain In-Memory Computing Macro using FeFET-Based CAM with Multilevel Delay Calibration in 28 nm CMOS

Time-domain nonvolatile in-memory computing (TD-nvIMC) offers a promising pathway to reduce data movement and improve energy efficiency by encoding computation in delay rather than voltage or current. This work presents a fully integrated and reconfigurable TD-nvIMC macro, fabricated in 28 nm CMOS, that combines a ferroelectric FET (FeFET)-based content-addressable memory array, a cascaded delay element chain, and a time-to-digital converter. The architecture supports binary multiply-and-accumulate (MAC) operations using XOR- and AND-based matching, as well as in-memory Boolean logic and arithmetic functions. Sub-nanosecond MAC resolution is achieved through experimentally demonstrated 550 ps delay steps, representing a 2000$\times$ improvement over prior FeFET TD-nvIMC work, enabled by multilevel-state calibration with $\leq$ 100 ps resolution. Write-disturb resilience is ensured via isolated triple-well bulks. The proposed macro achieves a measured throughput of 222.2 MOPS/cell and energy efficiency of 1887 TOPS/W at 0.85 V, establishing a viable path toward scalable, energy-efficient TD-nvIMC accelerators.

cs.ET↗