arXiv subjects

Jack Rolph

Publications and source records attributed to Jack Rolph.

3 recordsLinked to original sources

arXiv2026

SiPM non-linearity studies in beam tests with scintillating crystals

High-granularity homogeneous electromagnetic calorimeters based on scintillating crystals and silicon photomultipliers (SiPMs) are a promising option for future $e^{+}e^{-}$ Higgs factories, where both excellent energy resolution and a very large dynamic range are required. In this work, the non-linear response of high-pixel-density SiPMs with pixel pitches of 6--10~$\mu$m coupled to BGO and BSO crystals is studied under realistic beam conditions. A dual-end readout scheme with an attenuated reference SiPM was employed to precisely calibrate the deposited energy and the corresponding number of photoelectrons over a wide dynamic range. Beam tests were carried out at the CERN SPS H2 beamline using high-energy electrons, with a tungsten pre-shower and variable incident angles to enhance energy deposition. The measurements directly quantify the non-linear response of SiPMs to scintillation light over an extended dynamic range. For BGO-coupled Hamamatsu SiPMs, deviations from linearity of about 20\% are observed at $5\times10^{5}$ photoelectrons, while larger deviations are measured for the tested NDL devices and for configurations with faster BSO scintillation.

physics.ins-det↗

arXiv2025

Simulation Studies of the Effect of SiPM Dark Noise on the Performance of a Highly Granular Crystal ECAL

A proposal for the CEPC ECAL is a highly-granular scintillating crystal design that uses SiPMs to measure physics signals from photons. Radiation damage to the silicon will impair the performance of the calorimeter due to dark noise, which will affect the reconstruction capabilities of the calorimeter system. This paper presents a simulation study assessing the effect of radiation damage of SiPM dark noise on the response from calorimeter to electrons due to changing fluence and temperature. It was observed that dark noise significantly degrades the linearity of response, with up to 45% error in reconstructed energy for a 1 GeV shower at a fluence of $1 \times 10^{10}\mathrm{cm}^{-2}$. The stochastic and noise resolution terms was observed to remain stable, increasing only by 0.2% and 1% respectively in the range $1 \times 10^{7}-1 \times 10^{10}\mathrm{cm}^{-2}$ fluence. Under the assumption of no irradiation, the influence of dark noise with temperature in the normal operating range of the calorimeter system was estimated to be negligible.

physics.ins-det↗

arXiv2023

PeakOTron: A Python Module for Fitting Charge Spectra of Silicon Photomultipliers

A Python program has been developed which fits a published detector-response model to SiPM charge spectra to characterise SiPMs. Spectra for SiPMs illuminated by low intensity pulsed light with Poisson-distributed number of photons and a time spread of order nanoseconds or less, can be analysed. The entire charge spectra, including the intervals in-between the photoelectron peaks, are fitted, which allows determining, in addition to the mean number of detected photons, gain, gain spread, prompt cross-talk, pedestal, and electronics noise, the dark-count rate as well as the probability and time constant of after-pulses. The starting values of the fit parameters are extracted from the charge spectra. The program performance has been evaluated using simulated charge spectra with the different SiPM parameters varied in a wide range. By analysing 100 simulated spectra for every parameter set, the biases and statistical uncertainties of the individual parameters have been determined. It is found that the parameters are precisely determined and that the entire spectra are well described, in most cases with a $χ^2$/NDF close to 1. In addition, measured spectra for two types of SiPMs for a wide range of over-voltages have been analysed. The program achieves mostly a good description of the spectra, and the parameters determined agree with the values from the producers and expectations. The program can be used for detailed analyses of single spectra, but, as it is compatible with the native \texttt{Python} multiprocessing module, also for the automatic characterisation of large samples of SiPMs.

physics.ins-det↗