arXiv subjects

Jack R. C. King

Publications and source records attributed to Jack R. C. King.

2 recordsLinked to original sources

arXiv2026

Direct Numerical Simulation of Thermoacoustically Unstable Flames Via Non-Drifting Acoustic Delay Characteristic Boundary Conditions

Thermoacoustic instability in premixed flames results from the coupling between the flame's heat release, as determined by combustion parameters, and surrounding acoustics, as determined by combustor geometry. A primary instability results in flame flattening as intrinsic flame instability modes are stabilised. Secondary thermoacoustic instability results in a parametric flame instability and drastic growth of acoustic amplitudes. Due to their relative expense, numerical simulations of these phenomena remain scarce. In this work, Direct Numerical Simulations (DNS) of thermoacoustically unstable idealised premixed flames in a tube with acoustically closed upstream and open downstream ends are presented. Results herein demonstrate nonlinear saturation of the primary instability as the flame flattens as well as an oscillating flame fingering characteristic of the unsteady Rayleigh-Taylor effect. To reduce computational cost, we perform DNS only on the region surrounding the flame. Acoustics at in- and outflows are described using the Navier-Stokes Characteristic Boundary Condition (NSCBC) method to model their delayed reentry into the domain in a formulation referred to as the Acoustic Delay Characteristic Boundary Condition (ADCBC) method. A new Averaged Proportional and Integral Linear Relaxation (APILR) method is also introduced, which modifies the Classic Linear Relaxation (CLR) method to maintain time-averaged values of inflow velocity and outflow pressure. Here, an integral control term is used to remove non-zero equilibrium time-averaged inflow velocities which impinge control over flame position. Both new methods demonstrate their capability in inert and counterflow flames test cases. These methods enable the numerical simulation of combustion instabilities at significantly reduced computational expense.

physics.flu-dyn↗

arXiv2026

Learning Spectral-Like Mesh-Free Discretisations

Meshfree methods such as smoothed particle hydrodynamics (SPH) with kernel corrections, radial basis function-generated finite differences (RBF-FD), and the local anisotropic basis function method (LABFM) construct discrete differential operators by imposing polynomial consistency on a local stencil. For stencils containing more nodes than there are consistency constraints, the resulting linear system is underdetermined, and the remaining degrees of freedom are fixed implicitly by the choice of kernel, basis preconditioning, or a minimum-norm condition. Polynomial consistency constrains the operator only in the low-wavenumber limit, and no part of the construction selects for accuracy at the wavenumbers where fine-scale content resides. We introduce Spectral-like Neural Discretisation (SpeND), in which the choice of those degrees of freedom is cast as a learning problem: stencil weights are parametrised by a neural network conditioned on the local node geometry, trained to approximate the modal response of a spectral operator over the resolvable band. A hard-constrained projection layer maps the network output onto the affine subspace of consistent weights, so that polynomial consistency holds exactly by construction rather than as a penalty. Training is self-supervised and physics-agnostic, requiring no reference solutions; the objective minimises dispersion and dissipation error over a prescribed band-limited function space. Modal analysis on disordered two-dimensional node distributions shows that the learned fourth-order operator follows the exact response over a substantially wider band than either explicit LABFM at equal stencil size or fourth-order finite differences on a structured grid, whilst recovering the expected fourth-order convergence rate under refinement.

physics.comp-ph↗