arXiv subjects

J. Tan

Publications and source records attributed to J. Tan.

8 recordsLinked to original sources

arXiv2024

Mitigating calibration errors from mutual coupling with time-domain filtering of 21 cm cosmological radio observations

The 21 cm transition from neutral Hydrogen promises to be the best observational probe of the Epoch of Reionisation (EoR). This has led to the construction of low-frequency radio interferometric arrays, such as the Hydrogen Epoch of Reionization Array (HERA), aimed at systematically mapping this emission for the first time. Precision calibration, however, is a requirement in 21 cm radio observations. Due to the spatial compactness of HERA, the array is prone to the effects of mutual coupling, which inevitably lead to non-smooth calibration errors that contaminate the data. When unsmooth gains are used in calibration, intrinsically spectrally-smooth foreground emission begins to contaminate the data in a way that can prohibit a clean detection of the cosmological EoR signal. In this paper, we show that the effects of mutual coupling on calibration quality can be reduced by applying custom time-domain filters to the data prior to calibration. We find that more robust calibration solutions are derived when filtering in this way, which reduces the observed foreground power leakage. Specifically, we find a reduction of foreground power leakage by 2 orders of magnitude at k=0.5.

astro-ph.IM↗

arXiv2024

Reflectivity Studies and Production of New Flat Mirrors for the Cherenkov Threshold Detectors at CERN

Cherenkov threshold detectors (XCET) are used for identifying particles in the experimental areas at CERN. These detectors observe Cherenkov light emitted by charged particles travelling inside a pressurized gas vessel. A key component of the XCET detector is the 45-degree flat mirror reflecting the Cherenkov light towards the photomultiplier (PMT). A thorough analysis and optimization was conducted on the design and materials of this mirror, along with the surface coatings and coating techniques. A suitable manufacturing process was selected, and the first mirror prototype was produced, installed, and tested in the East Area at CERN. Experimental data obtained during beam tests is presented to assess the efficiency of the new coating and materials used.

hep-ex↗

arXiv2024

Investigating Mutual Coupling in the Hydrogen Epoch of Reionization Array and Mitigating its Effects on the 21-cm Power Spectrum

Interferometric experiments designed to detect the highly redshifted 21-cm signal from neutral hydrogen are producing increasingly stringent constraints on the 21-cm power spectrum, but some k-modes remain systematics-dominated. Mutual coupling is a major systematic that must be overcome in order to detect the 21-cm signal, and simulations that reproduce effects seen in the data can guide strategies for mitigating mutual coupling. In this paper, we analyse 12 nights of data from the Hydrogen Epoch of Reionization Array and compare the data against simulations that include a computationally efficient and physically motivated semi-analytic treatment of mutual coupling. We find that simulated coupling features qualitatively agree with coupling features in the data; however, coupling features in the data are brighter than the simulated features, indicating the presence of additional coupling mechanisms not captured by our model. We explore the use of fringe-rate filters as mutual coupling mitigation tools and use our simulations to investigate the effects of mutual coupling on a simulated cosmological 21-cm power spectrum in a "worst case" scenario where the foregrounds are particularly bright. We find that mutual coupling contaminates a large portion of the "EoR Window", and the contamination is several orders-of-magnitude larger than our simulated cosmic signal across a wide range of cosmological Fourier modes. While our fiducial fringe-rate filtering strategy reduces mutual coupling by roughly a factor of 100 in power, a non-negligible amount of coupling cannot be excised with fringe-rate filters, so more sophisticated mitigation strategies are required.

astro-ph.CO↗

arXiv2018

The Compact Linear Collider (CLIC) - 2018 Summary Report

The Compact Linear Collider (CLIC) is a TeV-scale high-luminosity linear $e^+e^-$ collider under development at CERN. Following the CLIC conceptual design published in 2012, this report provides an overview of the CLIC project, its current status, and future developments. It presents the CLIC physics potential and reports on design, technology, and implementation aspects of the accelerator and the detector. CLIC is foreseen to be built and operated in stages, at centre-of-mass energies of 380 GeV, 1.5 TeV and 3 TeV, respectively. CLIC uses a two-beam acceleration scheme, in which 12 GHz accelerating structures are powered via a high-current drive beam. For the first stage, an alternative with X-band klystron powering is also considered. CLIC accelerator optimisation, technical developments and system tests have resulted in an increased energy efficiency (power around 170 MW) for the 380 GeV stage, together with a reduced cost estimate at the level of 6 billion CHF. The detector concept has been refined using improved software tools. Significant progress has been made on detector technology developments for the tracking and calorimetry systems. A wide range of CLIC physics studies has been conducted, both through full detector simulations and parametric studies, together providing a broad overview of the CLIC physics potential. Each of the three energy stages adds cornerstones of the full CLIC physics programme, such as Higgs width and couplings, top-quark properties, Higgs self-coupling, direct searches, and many precision electroweak measurements. The interpretation of the combined results gives crucial and accurate insight into new physics, largely complementary to LHC and HL-LHC. The construction of the first CLIC energy stage could start by 2026. First beams would be available by 2035, marking the beginning of a broad CLIC physics programme spanning 25-30 years.

physics.acc-ph↗

arXiv2017

On varying coefficients of spatial inhomogeneous nonlinear Schr\"odinger equation

A nonlinear evolution equation for wave packet surface gravity waves with variation in topography is revisited in this article. The equation is modeled by a spatial inhomogeneous nonlinear Schr\"odinger (NLS) equation with varying coefficients, derived by Djordjevi\'c and Redekopp (1978) and the nonlinear coefficient is later corrected by Dingemans and Otta (2001). We show analytically and qualitatively that the nonlinear coefficient and the corresponding averaging value, stated but not derived, by Benilov, Flanagan and Howlin (2005) and Benilov and Howlin (2006) are inaccurate. For a particular choice of topography and wave characteristics, the NLS equation alternates between focusing and defocusing case and hence, it does not admit the formation of a classical soliton, neither bright nor dark one.

nlin.PS↗

arXiv2016

Updated baseline for a staged Compact Linear Collider

The Compact Linear Collider (CLIC) is a multi-TeV high-luminosity linear e+e- collider under development. For an optimal exploitation of its physics potential, CLIC is foreseen to be built and operated in a staged approach with three centre-of-mass energy stages ranging from a few hundred GeV up to 3 TeV. The first stage will focus on precision Standard Model physics, in particular Higgs and top-quark measurements. Subsequent stages will focus on measurements of rare Higgs processes, as well as searches for new physics processes and precision measurements of new states, e.g. states previously discovered at LHC or at CLIC itself. In the 2012 CLIC Conceptual Design Report, a fully optimised 3 TeV collider was presented, while the proposed lower energy stages were not studied to the same level of detail. This report presents an updated baseline staging scenario for CLIC. The scenario is the result of a comprehensive study addressing the performance, cost and power of the CLIC accelerator complex as a function of centre-of-mass energy and it targets optimal physics output based on the current physics landscape. The optimised staging scenario foresees three main centre-of-mass energy stages at 380 GeV, 1.5 TeV and 3 TeV for a full CLIC programme spanning 22 years. For the first stage, an alternative to the CLIC drive beam scheme is presented in which the main linac power is produced using X-band klystrons.

physics.acc-ph↗

arXiv2016

Effect of aging-induced disorder on the quantum transport properties of atomically thin WTe$_{2}$

Atomically thin layers of transition-metal dicalcogenides (TMDCs) are often known to be metastable in the ambient atmosphere. Understanding the mechanism of degradation is essential for their future applications in nanoelectronics, and thus has attracted intensive interest recently. Here, we demonstrate a systematic study of atomically thin WTe$_{2}$ in its low temperature quantum electronic transport properties. Strikingly, while the temperature dependence of few layered WTe$_{2}$ showed clear metallic tendency in the fresh state, degraded devices first exhibited a re-entrant insulating behavior, and finally entered a fully insulating state. Correspondingly, a crossover from parabolic to linear magnetoresistance, and finally to weak anti-localization was seen. Real-time Raman scattering measurement, together with transmission electron microscopy studies done before and after air degradation of atomically thin WTe$_{2}$ further confirmed that the material gradually form amorphous islands. It thus leads to localized electronic states and explains the low temperature Coulomb gap observed in transport measurements. Our study reveals for the first time the correlation between the unusual magnetotransport and disorder in few-layered WTe$_{2}$, which is indispensable in providing guidance on its future devices application.

cond-mat.mes-hall↗

arXiv2013

Correlation between Internal States and Strength in Bulk Metallic Glass

The internal states or local structures of bulk metallic glass (BMGs) can be well reflected from the changes of density, structural relaxation as well as the elastic constants. With the increasing free volume (FV) content, more local atomic clusters are capable of simultaneous plastic shear at different sites in the metallic glasses, inducing large plasticity. In this work, we report a close correlation between the internal states and strength in a BMG and discover that the yield strength can be changed by varying of the casting current, revealing that the yielding strength of BMGs is not only intrinsically associated with the glass transition, but also with the internal states, such as free volume and elastic properties. Such results may have some implications for understanding the correlations between the internal states and mechanical properties of BMGs.

cond-mat.mtrl-sci↗