arXiv subjects

Harshvardhan Gupta

Publications and source records attributed to Harshvardhan Gupta.

4 recordsLinked to original sources

arXiv2026

High-Velocity Whip-Mode Microresonator in LTOI Unimorph: Measurement Methodology and Large-Signal Characterization

This paper presents the design, characterization, and large-signal measurement methodology of a high-order whip-mode flexural microresonator on a lithium tantalate-on-insulator (LTOI) unimorph platform. A tapered cantilever concentrates kinetic energy at the free tip through a structural velocity amplification effect, with a targeted whip mode at 9.175 MHz exhibiting a measured Q of 691 in air. The results indicate a substantially reduced susceptibility to viscous damping at high modal frequencies. In-air large-signal testing on a separate device confirms tip velocities up to 20 m/s before the reliable measurement range of the laser Doppler vibrometer (LDV) at the tapered tip is exceeded, while the device itself sustains drive levels up to 240 Vpp before failure. Transitioning to vacuum reveals photothermal-induced static bending of the LTOI cantilever under LDV laser illumination, an effect that prohibits direct velocity measurement for these resonators. Hence, it motivates an indirect extraction methodology to be implemented. In this work, a 3.85 times base-to-tip geometric amplification factor, independently calibrated at low drive, is applied to base velocity measurements to infer tip velocity under large-signal conditions. Using this approach with narrowband chirp excitation, a maximum extracted tip velocity of 58.9 m/s is obtained at 192 Vpp, with spectral analysis of the base velocity placing a conservative lower bound of 36.2 m/s on this estimate. Large-signal failure-mode analysis identifies Pt/Au electrode melting at 210 Vpp as the current velocity ceiling. These results suggest that geometric amplification in high-order flexural modes offers a viable pathway toward the high proof-mass velocities targeted for next-generation MEMS inertial sensors.

eess.SP↗

arXiv2026

NEMO: Neural Electro-Mechano-Optic Sensors for Multiplexed Neural Interfaces

We introduce a novel electro-optomechanic neural sensor for realizing ultra-compact neural recording probes that can detect and relay electrophysiology signals from within neural tissue. This technology addresses outstanding challenges faced by existing neural recording technologies, including the resolution trade-off with signal-to-noise-ratio (SNR) due to the high impedances of small electrodes, and lingering stimulation artifacts. The sensor employs a highly miniaturized NEMS (nano-electromechanical systems) electrostatic transducer that modulates a silicon photonic microdisk resonator to convert electrical signals to an optical signal modulation. We have been able to achieve a limit of detection down to 110 microvolts, making the sensor sensitive enough to detect neural signals. This sensitive electro-optomechanic sensor directly detects electrophysiology signals and converts them to optomechanic modulation for effective transmission to outside the brain, which provides the unique potential for massive multiplexing of neural recordings. This design eliminates the need for bulky backend headstages that limit neural recording on awake free-roaming subjects. The ability of the device to record electrophysiological signals has been demonstrated using benchtop characterization and ex-vivo recordings from live neural tissue.

physics.optics↗

arXiv2026

Ultra-sensitive graphene-based electro-optic sensors for optically-multiplexed neural recording

Large-scale neural recording with high spatio-temporal resolution is essential for understanding information processing in brain, yet current neural interfaces fall far short of comprehensively capturing brain activity due to extremely high neuronal density and limited scalability. Although recent advances have miniaturized neural probes and increased channel density, fundamental design constraints still prevent dramatic scaling of simultaneously recorded channels. To address this limitation, we introduce a novel electro-optic sensor that directly converts ultra-low-amplitude neural electrical signals into optical signals with high signal-to-noise ratio. By leveraging the ultra-high bandwidth and intrinsic multiplexing capability of light, this approach offers a scalable path toward massively parallel neural recording beyond the limits of traditional electrical interfaces. The sensor integrates an on-chip photonic microresonator with a graphene layer, enabling direct detection of neural signals without genetically encoded optical indicators or tissue modification, making it suitable for human translation. Neural signals are locally transduced into amplified optical modulations and transmitted through on-chip waveguides, enabling interference-free recording without bulky electromagnetic shielding. Arrays of wavelength-selective sensors can be multiplexed on a single bus waveguide using wavelength-division multiplexing (WDM), greatly improving scalability while maintaining a minimal footprint to reduce tissue damage. We demonstrate detection of evoked neural signals as small as 25 $μ$V with 3 dB SNR from mouse brain tissue and show multiplexed recording from 10 sensors on a single waveguide. These results establish a proof-of-concept for optically multiplexed neural recording and point toward scalable, high-density neural interfaces for neurological research and clinical applications.

physics.optics↗

arXiv2021

An Experimental Study of the Acoustic Field of a Single-Cell Piezoelectric Micromachined Ultrasound Transducer (PMUT)

Piezoelectric micromachined ultrasound transducers (PMUTs) have gained popularity in the past decade as acoustic transmitters and receivers. As these devices usually operate at resonance, they can deliver large output sound pressures with very low power consumption. This paper explores the influence of the transmitter's packaging on the radiated acoustic field in air. We run simplified axisymmetric numerical models to observe the change in the acoustic field and directivity with respect to the device's package dimensions. The simulations demonstrate a notable change in the directivity of transmitter based on the size of the baffle. Experimental measurements are carried out to validate the simulations, which prove useful in designing packages for transmitters to meet application specific requirements.

physics.app-ph↗