arXiv subjects

Geonho Han

Publications and source records attributed to Geonho Han.

6 recordsLinked to original sources

arXiv2026

Evolution of UE in Massive MIMO Systems for 6G: From Passive to Active

As wireless networks continue to evolve, stringent latency and reliability requirements and highly dynamic channels expose fundamental limitations of gNB-centric massive multiple-input multiple-output (mMIMO) architectures, motivating a rethinking of the user equipment (UE) role. In response, the UE is transitioning from a passive transceiver into an active entity that directly contributes to system-level performance. In this context, this article examines the evolving role of the UE in mMIMO systems during the transition from fifth-generation (5G) to sixth-generation (6G), bridging third generation partnership project (3GPP) standardization, device implementation, and architectural innovation. Through a chronological review of 3GPP Releases 15 to 19, we highlight the progression of UE functionalities from basic channel state information (CSI) reporting to artificial intelligence (AI) and machine learning (ML)-based CSI enhancement and UE-initiated beam management. We further examine key implementation challenges, including multi-panel UE (MPUE) architectures, on-device intelligent processing, and energy-efficient operation, and then discuss corresponding architectural innovations under practical constraints. Using digital-twin-based evaluations, we validate the impact of emerging UE-centric functionalities, illustrating that UE-initiated beam reporting improves throughput in realistic mobility scenarios, while a multi-panel architecture enhances link robustness compared with a single-panel UE.

cs.IT↗

arXiv2025

Multi-User SLNR-Based Precoding With Gold Nanoparticles in Vehicular VLC Systems

Visible spectrum is an emerging frontier in wireless communications for enhancing connectivity and safety in vehicular environments. The vehicular visible light communication (VVLC) system is a key feature in leveraging existing infrastructures, but it still has several critical challenges. Especially, VVLC channels are highly correlated due to the small gap between light emitting diodes (LEDs) in each headlight, making it difficult to increase data rates by spatial multiplexing. In this paper, we exploit recently synthesized gold nanoparticles (GNPs) to reduce the correlation between LEDs, i.e., the chiroptical properties of GNPs for differential absorption depending on the azimuth angle of incident light are used to mitigate the LED correlation. In addition, we adopt a signal-to-leakage-plus-noise ratio (SLNR)-based precoder to support multiple users. The ratio of RGB light sources in each LED also needs to be optimized to maximize the sum SLNR satisfying a white light constraint for illumination since the GNPs can vary the color of transmitted light by the differential absorption across wavelength. The nonconvex optimization problems for precoders and RGB ratios can be solved by the generalized Rayleigh quotient with the approximated shot noise and successive convex approximation (SCA). The simulation results show that the SLNR-based precoder with the optimized RGB ratios significantly improves the sum rate in a multi-user vehicular environment and the secrecy rate in a wiretapping scenario. The proposed SLNR-based precoding verifies that the decorrelation between LEDs and the RGB ratio optimization are essential to enhance the VVLC performance.

cs.IT↗

arXiv2022

On the Physical Layer Security of Visible Light Communications Empowered by Gold Nanoparticles

Visible light is a proper spectrum for secure wireless communications because of its high directivity and impermeability in indoor scenarios. However, if an eavesdropper is located very close to a legitimate receiver, secure communications become highly risky. In this paper, to further increase the level of security of visible light communication (VLC) and increase its resilience against to malicious attacks, we propose to capitalize on the recently synthesized gold nanoparticles (GNPs) with chiroptical properties for circularly polarized light resulting the phase retardation that interacts with the linear polarizer angle. GNP plates made by judiciously stacking many GNPs perform as physical secret keys. Transmitters send both the intended symbol and artificial noise to exploit the channel variation effect by the GNP plates, which is highly effective when an eavesdropper is closely located to the legitimate receiver. A new VLC channel model is first developed by representing the effect of GNP plates and linear polarizers in the circular polarization domain. Based on the new channel model, the angles of linear polarizers at the transmitters and legitimate receiver are optimized considering the effect of GNP plates to increase the secrecy rate in wiretapping scenarios. Simulations verify that when the transmitters are equipped with GNP plates, even if the eavesdropper is located right next to the legitimate receiver, insightful results on the physical layer security metrics are gained as follows: 1) the secrecy rate is significantly improved and 2) the symbol error rate gap between the legitimate receiver and eavesdropper becomes much larger due to the chiroptical properties of GNP plates.

cs.IT↗

arXiv2022

Radar Imaging Based on IEEE 802.11ad Waveform in V2I Communications

Since most of vehicular radar systems are already exploiting millimeter-wave (mmWave) spectra, it would become much more feasible to implement a joint radar and communication system by extending communication frequencies into the mmWave band. In this paper, an IEEE 802.11ad waveform-based radar imaging technique is proposed for vehicular settings. A roadside unit (RSU) transmits the IEEE 802.11ad waveform to a vehicle for communications while the RSU also listens to the echoes of transmitted waveform to perform inverse synthetic aperture radar (ISAR) imaging. To obtain high-resolution images of the vehicle, the RSU needs to accurately estimate round-trip delays, Doppler shifts, and velocity of vehicle. The proposed ISAR imaging first estimates the round-trip delays using a good correlation property of Golay complementary sequences in the IEEE 802.11ad preamble. The Doppler shifts are then obtained using least square estimation from the echo signals and refined to compensate phase wrapping caused by phase rotation. The velocity of vehicle is determined using an equation of motion and the estimated Doppler shifts. Simulation results verify that the proposed technique is able to form high-resolution ISAR images from point scatterer models of realistic vehicular settings with different viewpoints. The proposed ISAR imaging technique can be used for various vehicular applications, e.g., traffic condition analyses or advanced collision warning systems.

cs.IT↗

arXiv2021

Multi-Vehicle Velocity Estimation Using IEEE 802.11ad Waveform

Wireless communication systems are to use millimeter-wave (mmWave) spectra, which can enable extra radar functionalities. In this paper, we propose a multi-target velocity estimation technique using IEEE 802.11ad waveform in a vehicle-to-vehicle (V2V) scenario. We form a wide beam to consider multiple target vehicles. The Doppler shift of each vehicle is estimated from least square estimation (LSE) using the round-trip delay obtained from the auto-correlation property of Golay complementary sequences in IEEE 802.11ad waveform, and the phase wrapping is compensated by the Doppler shift estimates of proper two frames. Finally, the velocities of target vehicles are obtained from the estimated Doppler shifts. Simulation results show the proposed velocity estimation technique can achieve significantly high accuracy even for short coherent processing interval (CPI).

cs.IT↗

arXiv2020

Radar Imaging Based on IEEE 802.11ad Waveform

The extension to millimeter-wave (mmWave) spectrum of communication frequency band makes it easy to implement a joint radar and communication system using single hardware. In this paper, we propose radar imaging based on the IEEE 802.11ad waveform for a vehicular setting. The necessary parameters to be estimated for inverse synthetic aperture radar (ISAR) imaging are sampled version of round-trip delay, Doppler shift, and vehicular velocity. The delay is estimated using the correlation property of Golay complementary sequences embedded on the IEEE 802.11ad preamble. The Doppler shift is first obtained from least square estimation using radar return signals and refined by correcting the phase uncertainty of Doppler shift by phase rotation. The vehicular velocity is determined from the estimated Doppler shifts and an equation of motion. Finally, an ISAR image is formed with the acquired parameters. Simulation results show that it is possible to obtain recognizable ISAR image from a point scatterer model of a realistic vehicular setting.

cs.IT↗