arXiv Science⌕ Search

arXiv subjects

G. Margutti

Publications and source records attributed to G. Margutti.

2 recordsLinked to original sources

Development and characterization of monolithic sensors with internal gain in a 110 nm CMOS process

This paper presents the optimization and characterization of a Monolithic Active Pixel Sensor with internal gain implemented in the 110 nm CMOS process from LFoundry. This work, carried out within the framework of the latest ARCADIA production run, reports on the characterization of sensors with an optimized gain layer. Improvements over earlier prototypes, including substrate current reduction via guard-ring connection, are briefly discussed. Both laboratory and in-beam measurements are presented. Using soft X-rays from a 55Fe source, both the pixel response and the noise performance are analyzed. In addition, laser measurements demonstrate an electronic jitter ranging from 20 to 40 ps for a signal amplitude corresponding to one minimum ionizing particle (MIP). Finally, the results from several test beam campaigns are described, showing the signal amplitude, gain and time resolution of sensors with different doping profiles of the gain layer evaluated with MIPs. A time resolution of about 78 ps was measured in the optimal condition of bias voltage and electronics configuration. The results demonstrate that monolithic CMOS sensors with internal gain can achieve promising timing performance at ambient temperature, highlighting their strong potential for next-generation precision timing applications.

physics.ins-det↗

First results on monolithic CMOS detector with internal gain

In this paper we report on a set of characterisations carried out on the first monolithic LGAD prototype integrated in a customised 110 nm CMOS process having a depleted active volume thickness of 48 $μ$m. This prototype is formed by a pixel array where each pixel has a total size of 100 $μ$m $\times$ 250 $μ$m and includes a high-speed front-end amplifier. After describing the sensor and the electronics architecture, both laboratory and in-beam measurements are reported and described. Optical characterisations performed with an IR pulsed laser setup have shown a sensor internal gain of about 2.5. With the same experimental setup, the electronic jitter was found to be between 50 ps and 150 ps, depending on the signal amplitude. Moreover, the analysis of a test beam performed at the Proton Synchrotron (PS) T10 facility of CERN with 10 GeV/c protons and pions indicated that the overall detector time resolution is in the range of 234 ps to 244 ps. Further TCAD investigations, based on the doping profile extracted from $C(V)$ measurements, confirmed the multiplication gain measured on the test devices. Finally, TCAD simulations were used to tune the future doping concentration of the gain layer implant, targeting sensors with a higher avalanche gain. This adjustment is expected to enhance the timing performance of the sensors of the future productions, in order to cope with the high event rate expected in most of the near future high-energy and high-luminosity physics experiments, where the time resolution will be essential to disentangle overlapping events and it will also be crucial for Particle IDentification (PID).

physics.ins-det↗