arXiv subjects

Franco Fuschini

Publications and source records attributed to Franco Fuschini.

6 recordsLinked to original sources

arXiv2026

A Ray-Based Characterization of Satellite-to-Urban Propagation

The evolution toward 6G communication systems is expected to rely on integrated three-dimensional network architectures where terrestrial infrastructures coexist with non-terrestrial stations such as satellites, enabling ubiquitous connectivity and service continuity. In this context, accurate channel models for satellite-to-ground propagation in urban environments are essential, particularly for user equipment located at street level where obstruction and multipath effects are significant. This work investigates satellite-to-urban propagation through deterministic ray-tracing simulations. Three representative urban layouts are considered, namely dense urban, urban, and suburban. Multiple use cases are investigated, including handheld devices, vehicular terminals, and fixed rooftop receivers operating across several frequency bands. The analysis focuses on the relative importance of competing propagation mechanisms and on two key channel parameters, namely the Rician K-factor and the delay spread, which are relevant for the calibration of channel models to be used in link- and system-level simulations. Results highlight the strong - and in some cases unconventional - dependence of channel dispersion and fading characteristics on satellite elevation, antenna placement, and urban morphology.

eess.SP↗

arXiv2022

A Study on mm-wave Propagation in and around Buildings

mm-waves are envisaged as key enabler for 5G and 6G wireless communications, thanks to the wider bandwidth and to the possibility of implementing large-scale antenna arrays and new advanced transmission techniques, such as massive MIMO and beamforming, that can take advantage of the multidimensional properties of the wireless channel. In order to further study the mm-wave wireless channel, where propagation shows different characteristics compared to the sub-6 GHz band, a joint measurement and simulation campaigns in indoor and outdoor microcellular environments has been carried out. The investigation highlights that the traditional assumption that mm-wave NLoS propagation is problematic is not true since significant reflections, scattering and even transmission mechanisms provide good NLoS coverage in most indoor and outdoor scenarios. This also reflects in the limited angle-spread differences between LoS and NLoS locations in some cases. Finally, the contribution of different propagation mechanisms (reflection, diffraction, scattering and combination of them) to the received power is analyzed in the paper with the help of ray tracing simulations.

eess.SP↗

arXiv2022

A Reciprocal Heuristic Model for Diffuse Scattering from Walls and Surfaces

Diffuse scattering of electromagnetic waves from natural and artificial surfaces has been extensively studied in various disciplines, including radio wave propagation, and several diffuse scattering models based on different approaches have been proposed over the years, two of the most popular ones being Kirchhoff Theory and the so-called Effective Roughness heuristic model. The latter, although less rigorous than the former, is more flexible and applicable to a wider range of real-world cases, including non-Gaussian surfaces, surfaces with electrically small correlation lengths and scattering from material inhomogeneities that are often present under the surface. Unfortunately, the Effective Roughness model, with the exception of its Lambertian version, does not satisfy reciprocity, which is an important physical-soundness requirement for any propagation model. In the present work, without compromising its effectiveness and its simple and yet sound power-balance approach, we propose a reciprocal version of the Effective Roughness model, which can be easily implemented and replaced to the old version in ray-based propagation models. The new model is analyzed and compared to the old one and to other popular models. Once properly calibrated, it is shown to yield similar - if not better - performance with respect to the old one when checked vs. measurements.

eess.SP↗

arXiv2021

Characterizing the UAV-to-Machine UWB Radio Channel in Smart Factories

In this work, the results of Ultra-Wideband air-to-ground measurements carried out in a real-world factory environment are presented and discussed. With intelligent in-dustrial deployments in mind, we envision a scenario where the Unmanned Aerial Vehicle can be used as a supplementary tool for factory operation, optimization and control. Measurements address narrow band and wide band characterization of the wireless radio channel, and can be used for link budget calculation, interference studies and time dispersion assessment in real factories, without the usual limitation for both radio terminals to be close to ground. The measurements are performed at different locations and different heights over the 3.1-5.3 GHz band. Some fundamental propagation parameters values are determined vs. distance, height and propagation conditions. The measurements are complemented with, and compared to, conventional ground-to-ground measurements with the same setup. The conducted measurement campaign gives an insight for realizing wireless applications in smart connected factories, including UAV-assisted applications.

eess.SP↗

arXiv2021

An UAV-based Experimental Setup for Propagation Characterization in Urban Environment

A measurement setup made of millimeter-wave and ultra wideband transceivers mounted on both a customized UAV and a ground station for full 3D wireless propagation analysis is described in this work. The developed system represents a flexible solution for the characterization of wireless channels and especially of urban propagation, as the drone might be easily located almost anywhere from ground level to the buildings rooftop and beyond. The double directional properties of the channel can be achieved by rotating directive antennas at the link ends. Other possible applications in urban contexts include above ground level propagation, outdoor-to-indoor penetration, line-of-sight to non-line-of-sight transition, scattering from buildings and air-to-ground channel characterization for UAV-assisted wireless communications.

eess.SP↗

arXiv2021

Experimental Characterization of Air-to-ground Propagation at mm-Wave Frequencies in Dense Urban Environment

In the present study, a measurement setup utilizing mm-wave transceivers with steerable directive antennas, mounted on both a customized UAV and a ground station has been used to study Air-to-Ground (A2G) radio links and, more generally, full-3D mm-wave propagation in urban environment. We evaluate the double-directional characteristics of the channel by rotating the antennas, deriving Power-Angle Profiles at both link ends. Preliminary results provide useful understanding of A2G propagation, e.g. the influence of the antenna tilt angles, or the mechanisms allowing for the signal to propagate from street canyons to the air.

eess.SP↗