arXiv Science⌕ Search

arXiv subjects

Felix M. Thiel

Publications and source records attributed to Felix M. Thiel.

4 recordsLinked to original sources

Prospects for submillimeter VLBI of black hole photon rings with a stratospheric balloon-borne telescope

Submillimeter very long baseline interferometry (VLBI) achieves higher angular resolution and probes more optically thin emission near supermassive black holes, with less interstellar scattering toward Sgr A$^*$. Above 345 GHz, however, the atmosphere confines ground-based VLBI to a few high, dry sites. Using 2012-2022 weather, we forecast what a 2.5 m telescope floating at 35-40 km, a successor to the 22 GHz Balloon-borne VLBI Experiment (BVEX) pathfinder, would add to ground-VLBI arrays at 345-690 GHz. The balloon adds little baseline length but reaches higher frequencies, where a fixed baseline is longer in wavelengths. On an ALMA-balloon baseline, Sgr A$^*$ at 460 GHz is at the detection threshold, with ten or more 20 s detections on about half of the simulated April days. These detections lie beyond the polarimetric photon ring transition, where the $n=1$ ring dominates the polarized visibility amplitudes. M87$^*$ at 460 GHz would need frequency phase transfer from a 230 GHz reference to be detected. With phase transfer, most Sgr A$^*$ detections beyond the transition at 460 GHz are on balloon baselines, whose thermal noise meets the linear-polarization threshold within one 300 s scan. At 690 GHz such detections require phase transfer that stays coherent at three times the reference frequency. In Fisher forecasts, a 460 GHz ring-geometry constraint requires balloons but is weaker than at 345 GHz, where balloons add little improvement. High-resolution 460 GHz VLBI science would require a 32 GHz bandwidth backend, submillimeter receivers, and simultaneous 230 GHz reference recording at every station.

astro-ph.IM↗

Studying the Near-horizon Jet of M87 using Millimeter Balloon-borne VLBI stations

In this paper we present synthetic Very Long Baseline Interferometry (VLBI) observations of M87 between a near-future configuration of the Event Horizon Telescope (EHT) and one or multiple 2.5 m-class balloon-borne VLBI stations on a northern transatlantic flight trajectory launching from Kiruna, Sweden. These balloon-borne VLBI stations have the advantage of operating above 99.5% of the atmosphere and their motion allows for efficient sampling of the uv-plane. Assuming frequency phase transfer between 230 and 86 GHz we run these simulations using a modified version of the ngehtsim software package. Our simulations demonstrate the ability of such a VLBI array to probe M87 at the jet base adding baselines down to 0.2 G$λ$ for a single balloon-VLBI station and 0.07 G$λ$ for three balloon VLBI stations. Using the Bayesian imaging software Comrade.jl, we demonstrate the recovery of jet structures up to 150 $μ$as in size for a single balloon and up to 300 $μ$as in size with three balloons. Finally, we test the improvement in jet image fidelity by computing the normalized cross-correlation (NXCOR) and normalized-root-mean-square error (NRMSE) between the image reconstruction and ground truth. We find a factor of 1.2 improvement in the jet NRMSE for a single balloon and a factor of 1.3 improvement for 3 balloons as compared to EHT-only simulations.

astro-ph.IM↗

An RFSoC-based Backend and Timing System for the Balloon-borne Very Long Baseline Interferometry Experiment

We present the design and performance characterization of the digital backend and precision-timing system for the Balloon-borne Very Long Baseline Interferometry Experiment (BVEX), a pathfinder for high-frequency stratospheric VLBI at 22 GHz. The backend uses one of the four 14-bit analog-to-digital converter inputs on an AMD-Xilinx RFSoC 4x2. Although the converters support sampling rates up to 5 GSPS, the flight configuration digitizes the 2-4 GHz intermediate frequency at 4.096 GSPS. CASPER firmware provides both a high-resolution spectrometer for pointing and receiver verification, and a VLBI acquisition chain with two-bit requantization that records at a rate of about 8.2 Gbps. The timestamped data packets are sent over 100 Gigabit Ethernet (GbE) to a 16 TB NVMe array in a storage computer that draws approximately 70-80 W. The timing chain uses a Rakon oven-controlled crystal oscillator as a timing reference while a time-interval counter measures its drift relative to a GPS reference with approximately 60 ps resolution. This is the first deployment of an RFSoC-based VLBI backend and precision-timing system on a stratospheric balloon. Ground tests validated the backend, spectrometer, and timing chain. The August 2025 CSA STRATOS flight ended before reaching the target float altitude because of a balloon failure, and as a result no science observations were obtained. For the planned 2027 reflight, we are developing a conduction-cooled data storage computer with 24 TB of NVMe capacity and a direct data path from the 100 GbE interface to the NVMe array.

astro-ph.IM↗

The Balloon-borne VLBI Experiment (BVEX) Radio Telescope and Position Tracking System

Very Long Baseline Interferometry (VLBI) is a technique in radio astronomy that vastly increases the diffraction limited angular resolution of radio observations by correlating simultaneous observations of radio telescopes separated by thousands of kilometers. Ground-based high-frequency VLBI is limited in baseline length by the diameter of the Earth and in sensitivity by molecular absorption of the Earth's atmosphere. One of the ways to improve VLBI is with balloon telescopes, which are much cheaper than space VLBI telescopes. In addition balloon-VLBI stations could also improve image quality due to increased uv-coverage. As a first step to achieving VLBI from a balloon-borne platform we present the Balloon-borne VLBI Experiment (BVEX). This is a novel, first-generation balloon-borne VLBI station observing at K-band (22 GHz) which launched as part of the Canadian Space Agency (CSA) STRATOS campaign from Timmins, Ontario, Canada in August 2025, with the aim to demonstrate VLBI from a balloon-borne platform by correlating with a large ground based telescope. We discuss the design of the 36 inch (91 cm) radio telescope and receiver with a 2 GHz bandwidth built from commercial-off-the-shelf (COTS) components as well as the telescope pointing system capable of interfacing with the CSA's CARMENCITA gondola. We also present a novel high precision position tracking system built from COTS components giving <1 mm precision on 1 s time scales which is required for achieving phase tracking at 22 GHz. We further show on-the-ground testing results from the 2025 Timmins campaign. The 2025 flight from Timmins was not successful due to a leak in the balloon preventing the payload from reaching its target altitude where accurate gondola pointing is possible. We therefore wrap up by presenting plans to upgrade the telescope for a potential next flight opportunity from Palmas, Tocantins, Brazil in 2027.

astro-ph.IM↗