arXiv ScienceSearch

arXiv subjects

F. Scuri

Publications and source records attributed to F. Scuri.

8 recordsLinked to original sources

Study of the Radiation Hardness of the ATLAS Tile Calorimeter Optical Instrumentation with Run 2 data

This paper presents a study of the radiation hardness of the hadronic Tile Calorimeter of the ATLAS experiment in the LHC Run 2. Both the plastic scintillators constituting the detector active media and the wavelength-shifting optical fibres collecting the scintillation light into the photodetector readout are elements susceptible to radiation damage. The dedicated calibration and monitoring systems of the detector (caesium radioactive sources, laser and minimum bias integrator) allow to assess the response of these optical components. Data collected with these systems between 2015 and 2018 are analysed to measure the degradation of the optical instrumentation across Run 2. Moreover, a simulation of the total ionising dose in the calorimeter is employed to study and model the degradation profile as a function of the exposure conditions, both integrated dose and dose rate. The measurement of the relative light output loss in Run 2 is presented and extrapolations to future scenarios are drawn based on current data. The impact of radiation damage on the cell response uniformity is also analysed.

physics.ins-det

Laser calibration of the ATLAS Tile Calorimeter during LHC Run 2

This article reports the laser calibration of the hadronic Tile Calorimeter of the ATLAS experiment in the LHC Run 2 data campaign. The upgraded Laser II calibration system is described. The system was commissioned during the first LHC Long Shutdown, exhibiting a stability better than 0.8% for the laser light monitoring. The methods employed to derive the detector calibration factors with data from the laser calibration runs are also detailed. These allowed to correct for the response fluctuations of the 9852 photomultiplier tubes of the Tile Calorimeter with a total uncertainty of 0.5% plus a luminosity-dependent sub-dominant term. Finally, we report the regular monitoring and performance studies using laser events in both standalone runs and during proton collisions. These studies include channel timing and quality inspection, and photomultiplier linearity and response dependence on anode current.

physics.ins-det

Hadron detection with a dual-readout fiber calorimeter

In this paper, we describe measurements of the response functions of a fiber-based dual- readout calorimeter for pions, protons and multiparticle "jets" with energies in the range from 10 to 180 GeV. The calorimeter uses lead as absorber material and has a total mass of 1350 kg. It is complemented by leakage counters made of scintillating plastic, with a total mass of 500 kg. The effects of these leakage counters on the calorimeter performance are studied as well. In a separate section, we investigate and compare different methods to measure the energy resolution of a calorimeter. Using only the signals provided by the calorimeter, we demonstrate that our dual-readout calorimeter, calibrated with electrons, is able to reconstruct the energy of proton and pion beam particles to within a few percent at all energies. The fractional widths of the signal distributions for these particles (sigma/E) scale with the beam energy as 30%/sqrt(E), without any additional contributing terms.

physics.ins-det

Study of the process e+e- -> omega p0 with the KLOE detector

Using ~600 pb-1 collected with the KLOE detector at DAPhiNE, we have studied the production cross section of pi+ pi- pi0 pi0 and p0p0 gamma final states in e+e- collisions at center of mass energies between 1000 and 1030 MeV. By fitting the observed interference pattern around Mphi for both final states, we extract a measurement (preliminary) for the ratio Gamma(omega -> pi0 gamma)/Gamma(omega -> pi+ pi- pi0) = 0.0934 +- 0.0022. Since these two final states represent the 98% of the omega decay channels, we use unitarity to derive BR(omega -> pi+pi-pi0)= (89.94 +- 0.23)% and BR(omega -> pi0 gamma) = (8.40 +- 0.19)%. Moreover, the parameters describing the e+e- -> pi+ pi- pi0 pi0 reaction around Mphi are used to extract the branching fraction for the OZI and G-parity violating phi -> omega pi0 decay: BR(phi -> omega pi0) = (5.63 +- 0.70) x 10^-5.

hep-ex

Measurement of the slope parameter αfor the η\to 3π^0 decay at KLOE

We report a preliminary measurement of the slope parameter $α$ for the $η\to 3\piz$ decay carried out with KLOE at DA$Φ$NE; where $α$ is the parameter describing the energy dependence of the square of the matrix element for this decay. By fitting the event density in the Dalitz plot with a collected statistic of 420 pb$^{-1}$ we determine $α= -0.027 \pm 0.004 (stat) ^{+0.004}_{-0.006} (syst)$. This result is consistent with current chiral perturbation theory calculations within the unitary approach.

hep-ex

Determination of the η\toπ^+π^-π^0 Dalitz Plot slopes and asymmetries with the KLOE detector

We have studied, with the KLOE detector at the DA$Φ$NE $Φ$-Factory, the dynamics of the decay $η\toπ^+π^-π^0$ using data from the radiative $ϕ\toηγ$ decay for an integrated luminosity $L = 450 \textrm{pb^{-1}}$. From a fit to the Dalitz plot density distribution we obtain a precise measurement of the slope parameters. This should allow to improve the knowledge of the decay amplitude which is sensitive to the u-d quark mass difference. We also present new best results on the C-violating asymmetries in the $η\toπ^+π^-π^0$ decay.

hep-ex

Charged kaon lifetime at KLOE

Preliminary result on the charged kaon lifetime, obtained by the KLOE experiment operating at DA$\Phi$NE, the Frascati $\phi$-factory, is presented

hep-ex

eta Physics and phi Radiative Decays at Kloe

Here we present KLOE results on the phi meson decays in pi0 pi0 gamma, pi+ pi- gamma and eta pi0 gamma, the measurement of the ratio Br(phi to eta' gamma)/Br(phi to eta gamma) with the estimate of the eta' gluonium content and the measurement of the eta mass.

hep-ex