arXiv subjects

Divya Jain

Publications and source records attributed to Divya Jain.

4 recordsLinked to original sources

arXiv2026

EMT Assessment of SCR and X/R Effects on Current-Priority-Dependent LVRT Response of a Grid-Following BESS

Low-voltage ride-through (LVRT) forces a grid-following inverter to allocate finite converter current between active- and reactive-current objectives. This paper uses a PSCAD electromagnetic-transient (EMT) representation of an aggregated battery energy storage system (BESS) to quantify how short-circuit ratio (SCR) and grid impedance X/R ratio alter that tradeoff. Active-current priority and reactive-current priority are compared for five paired grid conditions under the same 150-ms balanced three-phase fault, with pre-fault active power approximately 0.84 pu, POI reactive-power exchange near 0 pu, and a 1.0-pu dq-current limit. Fundamental positive-sequence voltage and power are reconstructed from 100-$μ$s three-phase EMT outputs. Across the fixed-fault SCR sweep, the Q-priority late-fault voltage advantage increases from 0.046 pu in the strongest tested grid to 0.129 pu in the weakest; the weakest P-priority case also shows active-power reversal and a pronounced controller-frequency excursion. At fixed SCR, changing X/R produces a smaller increase from 0.092 to 0.112 pu, mainly through reduced P-priority voltage support. Because the common physical fault also deepens the passive retained-voltage condition as SCR decreases, the SCR result is interpreted as a fixed-fault grid-strength sensitivity rather than a constant-sag comparison. Grid strength is the larger sensitivity in the tested matrix, while X/R remains an additional modifier under the studied fault conditions.

eess.SY↗

arXiv2026

Control-Layer Interpretation of Reactive Power Recovery Limits in EMT-RMS Model Benchmarking of Inverter-Based Resources

EMT--RMS benchmarking is widely used to verify cross-platform consistency of inverter-based resource (IBR) dynamic models. This paper examines a 200 MW anonymized IBR represented in PSCAD and PSS/E. The EMT model separates inverter electrical capability from a plant-level power plant controller (PPC) recovery target, whereas the RMS model represents these functions through REECC and REPCA parameters. Directly assigning the PPC target of $\pm 0.2764$ pu to REPCA hard reactive limits is initialization-inconsistent at the original lagging operating point because the initial reactive command is 0.396273 pu. A second, near-unity-power-factor operating point initializes successfully with the same diagnostic limit, demonstrating that the conflict is operating-point dependent. Using the non-conflicting capability mapping removes the original hard-limit conflict, but the benchmark still shows 18.5--30.2 MVAr post-event POI reactive-power differences from PSCAD. A one-at-a-time REPCA $K_c$ sensitivity under matched benchmark initial conditions further shows that RMS recovery is parameter- and limit-dependent: at $K_c=0.05$ and 0.10 the aggregate machine reactive output reaches the configured capability bounds, while $K_c=0.15$ moves VDOWN, VUP, and HVRT off those bounds and changes their settled POI reactive power by 8.94, 18.00, and 3.17 MVAr, respectively. Machine-to-POI accounting further shows why machine-side saturation need not reproduce the POI-level PPC recovery magnitude. The results distinguish initialization feasibility from recovery equivalence and provide a control-layer diagnostic workflow beyond waveform comparison.

eess.SY↗

arXiv2025

Bridging the Regulatory Divide: Ensuring Safety and Equity in Wearable Health Technologies

As wearable health technologies have grown more sophisticated, the distinction between "wellness" and "medical" devices has become increasingly blurred. While some features undergo formal U.S. Food and Drug Administration (FDA) review, many over-the-counter tools operate in a regulatory grey zone, leveraging health-related data and outputs without clinical validation. Further complicating the issue is the widespread repurposing of wellness devices for medical uses, which can introduce safety risks beyond the reach of current oversight. Drawing on legal analysis, case studies, and ethical considerations, we propose an approach emphasizing distributed risk, patient-centered outcomes, and iterative reform. Without a more pluralistic and evolving framework, the promise of wearable health technology risks being undermined by growing inequities, misuse, and eroded public trust.

cs.CY↗

arXiv2018

A Multi-Modal Approach to Infer Image Affect

The group affect or emotion in an image of people can be inferred by extracting features about both the people in the picture and the overall makeup of the scene. The state-of-the-art on this problem investigates a combination of facial features, scene extraction and even audio tonality. This paper combines three additional modalities, namely, human pose, text-based tagging and CNN extracted features / predictions. To the best of our knowledge, this is the first time all of the modalities were extracted using deep neural networks. We evaluate the performance of our approach against baselines and identify insights throughout this paper.

cs.CV↗