arXiv subjects
Publications and source records attributed to David Winter.
We demonstrate continuous distributed acoustic sensing over a 4400km long undersea cable. Bi-directional operation improves the strain signal-to-noise rate by >20dB, enabling 88000 50-m-spaced measurement points at a nominal telecom launch power.
We detect the recent M8.8 mega-earthquake in Eastern Russia, on a 4400km long active telecom cable in the Pacific Ocean. The resolution achieved 100m represents the highest spatial resolution, the largest number of ocean-bottom sensors, and the first fiber-optic deep-ocean observation of a tsunami wave.
We report tele-seismic waves detection from multiple earthquakes on an operational subsea cable from Iceland to Ireland. Using per-span laser interferometry with 100km spacing, we report clear detection of S-, P- and surface waves from multiple world-wide earthquakes, enabling seismic analysis for early warning applications.
Results from Monte Carlo simulations of wall-attached droplets in the three-dimensional Ising lattice gas model and in a symmetric binary Lennard-Jones fluid, confined by antisymmetric walls, are analyzed, with the aim to estimate the dependence of the contact angle $(\Theta)$ on the droplet radius $(R)$ of curvature. Sphere-cap shape of the wall-attached droplets is assumed throughout. An approach, based purely on "thermodynamic" observables, e.g., chemical potential, excess density due to the droplet, etc., is used, to avoid ambiguities in the decision which particles belong (or do not belong, respectively) to the droplet. It is found that the results are compatible with a variation $[\Theta(R)-\Theta_{\infty}] \propto 1/R$, $\Theta_{\infty}$ being the contact angle in the thermodynamic limit ($R=\infty$). The possibility to use such results to estimate the excess free energy related to the contact line of the droplet, namely the line tension, at the wall, is discussed. Various problems that hamper this approach and were not fully recognized in previous attempts to extract the line tension are identified. It is also found that the dependence of wall tensions on the difference of chemical potential of the droplet from that at the bulk coexistence provides effectively a change of the contact angle of similar magnitude. The simulation approach yields precise estimates for the excess density due to wall-attached droplets and the corresponding free energy excess, relative to a system without a droplet at the same chemical potential. It is shown that this information suffices to estimate nucleation barriers, not affected by ambiguities on droplet shape, contact angle and line tension.
Excess contributions to the free energy due to interfaces occur for many problems encountered in the statistical physics of condensed matter when coexistence between different phases is possible (e.g. wetting phenomena, nucleation, crystal growth, etc.). This article reviews two methods to estimate both interfacial free energies and line tensions by Monte Carlo simulations of simple models, (e.g. the Ising model, a symmetrical binary Lennard-Jones fluid exhibiting a miscibility gap, and a simple Lennard-Jones fluid). One method is based on thermodynamic integration. This method is useful to study flat and inclined interfaces for Ising lattices, allowing also the estimation of line tensions of three-phase contact lines, when the interfaces meet walls (where "surface fields" may act). A generalization to off-lattice systems is described as well. The second method is based on the sampling of the order parameter distribution of the system throughout the two-phase coexistence region of the model. Both the interface free energies of flat interfaces and of (spherical or cylindrical) droplets (or bubbles) can be estimated, including also systems with walls, where sphere-cap shaped wall-attached droplets occur. The curvature-dependence of the interfacial free energy is discussed, and estimates for the line tensions are compared to results from the thermodynamic integration method. Basic limitations of all these methods are critically discussed, and an outlook on other approaches is given.
During the past several years, experiments at RHIC have established that a dense partonic medium is produced in Au+Au collisions at sqrt(s)=200 GeV. Subsequently, a primary goal of analysis has been to understand and characterize the dynamics underlying this new form of matter. Among the many probes available, the measurements with respect to the reaction plane has proven to be crucial to our understanding of a wide range of topics, from the hydrodynamics of the initial expansion of the collision region to high-pt jet quenching phenomena. Few tools have the ability to shed light on such a wide variety of observables as the reacion plane. In this article, we discuss recent PHENIX measurements with respect to the reaction plane, and the implications for understanding the underlying physics of RHIC collisions.
Flat walls facilitate the condensation of a supersaturated vapor: Classical theory of heterogeneous nucleation predicts that the free energy barrier $ΔF_{\rm het}^*$ which needs to be overcome for the formation of sphere-cap shaped nucleation seeds is smaller than the barrier $ΔF^*_{\rm hom}$ for spherical droplets in the bulk by a factor $0<f(θ)<1$, which only depends on the contact angle $θ$. In this letter we compute both $ΔF^*_{\rm hom}$ and $ΔF^*_{\rm het}$ from Monte Carlo simulations and test the theory for the lattice gas model (for which $θ$ can be readily controlled). Even though the theory is only based on macroscopic arguments, it is shown to hold for experimentally relevant nanoscopic nucleation seeds ($20\leqΔF^*_{\rm hom}/k_BT\leq 200)$ if (independently estimated) line tension effects are considered.
In relativistic heavy-ion collisions, studying jet correlations and their dependence on the angle of emission with respect to the reaction plane can be used to shed light on the path length dependence of the energy lost by the jet. In this paper, we present recent PHENIX results on jet correlations versus reaction plane, as a function of centrality and transverse momentum.
It has been established that "hard probes", observables involving high-momentum transfer, provide useful tools for studying the hot, dense medium created in nucleus-nucleus collisions at RHIC. The nuclear modification factor, azimuthal correlations, direct photon production, as well as the dependence of the nuclear modificaton factor on centrality and angle with respect to the reaction plane are critical for understanding the early dynamics of such heavy-ion collisions. We will review recent results from PHENIX for particle production at high-pT and discuss their implications.
The origin of the azimuthal anisotropy in particle yields at high pT (pT > 5 GeV/c) in RHIC collisions remains an intriguing puzzle. Traditional flow and parton energy loss models have failed to completely explain the large v2 observed at high pT. Measurement of this parameter at high pT will help to gain an understanding of the interplay between flow, recombination and energy loss, and the role they play in the transition from soft to hard physics. Neutral mesons measured in the PHENIX experiment provide an ideal observable for such studies. We present recent measurements of \piz yields with respect to the reaction plane, and discuss the impact current models have on our understanding of these mechanisms.
The PHENIX Run4 data-set provides a powerful opportunity for exploring the angular anisotropy of identified particle yields at high pT. Complementing traditional v2 measurements, we present pi0 yields as a function of emission angle with respect to the reaction plane in Au+Au collisions at sqrt(s) = 200 GeV/c. The centrality dependence of the angular anisotropy allows us to probe the density and path-length dependence of the energy loss of hard-scattered partons.
The PHENIX Run 4 Au+Au dataset provides a powerful opportunity for exploring the angular anisotropy of identified particle yields at high pT. Complementing traditional v2 measurements, we present pi0 yields as a function of angle with reaction plane, up to pT 10 GeV/c. The centrality dependence of the angular anisotropy allows us to probe the density and path-length dependence of the energy loss of hard-scattered partons. We will discuss various mechanisms for particle production in this high pT region.