David Bold | arXiv Science

arXiv2026

Numerical methods for stellarator simulations in BOUT++

Modeling the Scape-off layer (SOL) of stellarator fusion devices is challenging due to the complicated magnetic topology, requiring numerical tools to solve transport equations for realistic geometries. Previously the flux coordinate independent (FCI) method has been successfully applied to model the SOL in simplified geometries. The current work presents some of the recent improvements for the BOUT++ modeling implemented to simulate the SOL in realistic geometries with the example of Wendelstein 7-X. The changes include improvements for the grid generation tool, the physics model as well as the BOUT++ library itself. A short outlook is given on current modeling work using the new features.

physics.plasm-ph↗

arXiv2024

Impact of spatially varying transport coefficients in EMC3-Eirene simulations of W7-X and assessment of drifts

Modelling the scrape-off layer of a stellarator is challenging due to the complex magnetic 3D geometry. The here presented study analyses simulations of the scrape-off layer (SOL) of the stellarator Wendelstein 7-X (W7-X) using spatially varying diffusion coefficients for the magnetic standard configuration, extending our previous study. Comparing the EMC3-Eirene simulations with experimental observations, an inconsistency between the strike-line width (SLW) and the upstream parameters was observed. While to match the experimental SLW a particle diffusion coefficient $D \approx 0.2$ is needed, $D \approx 1$ is needed to get experimental separatrix temperatures of 50\,eV at the given experimental heating power. We asses the impact of physically motivated spatially varying transport coeffients. Agreement with experimental data can be improved, but various differences remain. We show that drifts are expected to help overcome the discrepancies and, thus, the development of SOL transport models including drifts is a necessary next step to study the SOL transport of the W7-X stellarator.

physics.plasm-ph↗

arXiv2024

Global fluid turbulence simulations in the SOL of a stellarator island divertor

Isothermal fluid turbulence simulations have been performed in the edge and scrape-off-layer (SOL) of an analytic stellarator configuration with an island divertor, thereby providing numerical insight into edge turbulence in regions around islands in a stellarator. The steady-state transport follows the 1/R curvature drive toward the outboard side, but large fluctuations are present throughout the island divertor region, with the average wavelength of similar size to the island width. The system exhibits a prominent m=2, n=5 mode, although other modes are present. The amplitude and radial extent of the density fluctuations are similar throughout the edge and SOL, but can decrease near island O-points. The fluctuations exhibit a predominantly positive skewness on the outboard midplane, indicating blob-like perturbations for the transport into the outer SOL. It is determined that a point on the separatrix is generally more correlated with regions outside of the SOL than a nearby reference point which does not lie on the separatrix.

physics.plasm-ph↗

arXiv2022

Parametrisation of target heat flux distribution and study of transport parameters for boundary modelling in W7-X

Modelling the scrape-off layer of a stellarator is challenging due to the complex magnetic 3D geometry. The here presented study analyses simulations of the scrape-off layer (SOL) of the stellarator Wendelstein 7-X (W7-X) using the EMC3-EIRENE code for the magnetic standard configuration. Comparing with experimental observations, the transport model is validated. Based on the experimentally observed strike line width, the anomalous transport coefficients, used as input to the code are determined to around $0.2\,$m$^2/$s. This is however in disagreement with upstream measurements, where such small cross-field transport leads to temperatures higher than measured experimentally.

physics.plasm-ph↗