arXiv ScienceSearch

arXiv subjects

D. Edstrom

Publications and source records attributed to D. Edstrom.

10 recordsLinked to original sources

Experimental demonstration of OSC at IOTA: IOTA Run #3 Report

Optical Stochastic Cooling (OSC) is an optical-bandwidth extension of Stochastic Cooling that could advance the state-of-the-art cooling rate in beam cooling by three to four orders of magnitude [1-3]. The concept of OSC was first suggested in the early 1990s by Zolotorev, Zholents and Mikhailichenko, and replaced the microwave hardware of SC with optical analogs, such as wigglers and optical amplifiers. A number of variations on the original OSC concept have been proposed, and while a variety of proof-of-principle demonstrations and operational uses have been considered, the concept was not experimentally demonstrated up to now [4-9]. An OSC R&D program has been underway at IOTA for the past several years [4]. Run #3 of the IOTA ring, which began in Nov. 2020 and concluded in Aug. 2021, was focused on the worlds first experimental demonstration of OSC. The experimental program was successful in demonstrating and characterizing the OSC physics with the major outcomes including strong cooling in one, two and three dimensions, validation of the theoretical models of OSC and the demonstration of OSC with a single electron. This report briefly describes the activities and major milestones of the OSC program during Run #3. Detailed descriptions of the OSC theory, conceptual design and hardware elements can be found in reference [4].

physics.acc-ph

First Experimental Demonstration of Optical Stochastic Cooling

Particle accelerators and storage rings have been transformative instruments of discovery, and, for many applications, innovations in particle-beam cooling have been a principal driver of that success1. Beam cooling reduces the spread in particle positions and momenta, while keeping the number of particles constant, and combats diffusive effects, thereby enabling particle accumulation and the production and preservation of intense beams. In the case of particle colliders, cooling increases the likelihood of observing rare physics events. One of the most important conceptual and technological advances in this area was stochastic cooling (SC), which was instrumental in the discovery of the W and Z bosons at CERN and the top quark at Fermilab2-6. SC reduces the random motion of the beam particles through granular sampling and correction of the beams phase-space structure, thus bearing resemblance to a Maxwells demon. The extension of SC from the microwave regime up to optical frequencies and bandwidths has long been pursued as it could increase the achievable cooling rates by three to four orders of magnitude and provide a powerful new tool for future accelerators. First proposed nearly thirty years ago, Optical Stochastic Cooling (OSC) replaces the conventional microwave elements of SC with optical-frequency analogs and is, in principle, compatible with any species of charged-particle beam7,8. Here we describe the first experimental demonstration of OSC in a proof-of-principle experiment9 at the Fermi National Accelerator Laboratorys Integrable Optics Test Accelerator10.

physics.acc-ph

Submacropulse electron-beam dynamics correlated with higher-order modes in a Tesla-type cryomodule

Experiments were performed at the Fermilab Accelerator Science and Technology (FAST) facility to elucidate the effects of long-range wakefields (LRWs) in TESLA-type superconducting rf cavities. In particular, we investigated the higher-order modes (HOMs) generated in the eight cavities of a cryomodule (CM) due to off-axis steering with correctors located ~4 m upstream of the CM. We have observed correlated submacropulse centroid slews of a few-hundred microns and centroid oscillations at ~240 kHz in the rf BPM data after the CM. The entrance energy into the CM was 25 MeV, and the exit energy was 100 MeV with 125 pC/b and 400 pC/b in 50-bunch pulse trains. These experimental results were evaluated for machine learning training aspects which will be used to inform the commissioning plan for the Linac Coherent Light Source-II injector CM.

physics.acc-ph

Photoinjector Generation of High-Charge Magnetized Beams for Electron-Cooling Applications

Electron-cooling offers a relatively simple scheme to enable high-luminosity collisions in future electron-ion and hadron colliders. Contemplated TeV-energy hadron colliders require relativistic (sub 100 MeV) high-charge [${\cal O}(\mbox{nC})$] electron beams with a specific transverse eigenemittance partition. This paper discusses the generation of high-charge ($Q\le 3.2$~nC) 40 MeV electron bunches with eigenemittance partition consistent with requirements associated with electron-cooling option for future electron-ion colliders. The supporting experiment was performed at the FAST facility at FermiLab. The data are compared with numerical simulations and the results discussed in the context of beam requirement for future electron-ion colliders.

physics.acc-ph

Submacropulse Electron-Beam Dynamics Correlated With Higher-Order Modes In Tesla-Type Superconducting RF Cavities

We report the direct observations of sub-macropulse beam centroid oscillations correlated with higher order modes (HOMs) which were generated by off-axis electron beam steering in TESLA-type superconducting RF cavities. The experiments were performed at the Fermilab Accelerator Science and Technology (FAST) facility using its unique configuration of a photocathode rf gun injecting beam into two separated 9-cell cavities in series with corrector magnets and beam position monitors (BPMs) located before, between, and after them. Oscillations of ~100 kHz in the vertical plane and ~380 kHz in the horizontal plane with up to 600-{\mu}m amplitudes were observed in a 3-MHz micropulse repetition rate beam with charges of 100, 300, 500, and 1000 pC/b. However, the effects were much reduced at 100 pC/b. The measurements were based on HOM detector circuitry targeting the first and second dipole passbands, rf BPM bunch-by-bunch array data, imaging cameras, and a framing camera. Calculations reproduced the oscillation frequencies of the phenomena in the vertical case. In principle, these fundamental results may be scaled to cryomodule configurations of major accelerator facilities.

physics.acc-ph

Linear Lattice and Trajectory Reconstruction and Correction at FAST Linear Accelerator

The low energy part of the FAST linear accelerator based on 1.3 GHz superconducting RF cavities was successfully commissioned. During commissioning, beam based model dependent methods were used to correct linear lattice and trajectory. Lattice correction algorithm is based on analysis of beam shape from profile monitors and trajectory responses to dipole correctors. Trajectory responses to field gradient variations in quadrupoles and phase variations in superconducting RF cavities were used to correct bunch offsets in quadrupoles and accelerating cavities relative to their magnetic axes. Details of used methods and experimental results are presented.

physics.acc-ph

Analysis and Measurement of the Transfer Matrix of a 9-cell 1.3-GHz Superconducting Cavity

Superconducting linacs are capable of producing intense, stable, high-quality electron beams that have found widespread applications in science and industry. The 9-cell 1.3-GHz superconducting standing-wave accelerating RF cavity originally developed for $e^+/e^-$ linear-collider applications [B. Aunes, {\em et al.} Phys. Rev. ST Accel. Beams {\bf 3}, 092001 (2000)] has been broadly employed in various superconducting-linac designs. In this paper we discuss the transfer matrix of such a cavity and present its measurement performed at the Fermilab Accelerator Science and Technology (FAST) facility. The experimental results are found to be in agreement with analytical calculations and numerical simulations.

physics.acc-ph

Neural Networks for Modeling and Control of Particle Accelerators

We describe some of the challenges of particle accelerator control, highlight recent advances in neural network techniques, discuss some promising avenues for incorporating neural networks into particle accelerator control systems, and describe a neural network-based control system that is being developed for resonance control of an RF electron gun at the Fermilab Accelerator Science and Technology (FAST) facility, including initial experimental results from a benchmark controller.

physics.acc-ph

Microlens Array Laser Transverse Shaping Technique for Photoemission Electron Source

A common issue encountered in photoemission electron sources used in electron accelerators is distortion of the laser spot due to non ideal conditions at all stages of the amplification. Such a laser spot at the cathode may produce asymmetric charged beams that will result in degradation of the beam quality due to space charge at early stages of acceleration and fail to optimally utilize the cathode surface. In this note we study the possibility of using microlens arrays to dramatically improve the transverse uniformity of the drive laser pulse on UV photocathodes at both Fermilab Accelerator Science \& Technology (FAST) facility and Argonne Wakefield Accelerator (AWA). In particular, we discuss the experimental characterization of the homogeneity and periodic patterned formation at the photocathode. Finally, we compare the experimental results with the paraxial analysis, ray tracing and wavefront propagation software.

physics.acc-ph

Test Results of Tesla-Style Cryomodules at Fermilab

Commissioning and operation of the first Tesla-style Cryomodule (CM-1) at Fermilab was concluded in recent months. A second Tesla Type III+ module, RFCA002, will be replacing it. CM-1 is the first 8-cavity ILC style cryomodule to be built at Fermilab and also the first accelerating cryomodule of the Advanced Superconducting Test Accelerator (ASTA). We report on the operating results of both of these cryomodules.

physics.acc-ph