arXiv Science⌕ Search

arXiv subjects

Chunyang Ding

Publications and source records attributed to Chunyang Ding.

6 recordsLinked to original sources

Resolving and Suppressing Temporally Correlated Noise in Quantum Error Correction

Scaling fault-tolerant quantum error correction (QEC) requires suppressing errors in both space and time, yet standard logical memory experiments primarily probe spatial faults. Here, we use a 105-qubit Willow superconducting quantum processor to realize and scale the surface code stability experiment, which is alternatively sensitive to temporal error chains. Scaling from patch sizes of $3 \times 3$ to $7 \times 7$, we realize a timelike block suppression factor of $μ_T = 1.47 \pm 0.25$, demonstrating the ability to maintain temporal error suppression as the number of qubits increases. By extending the stability experiment for many cycles, we uncover a sum-of-exponentials behavior in error suppression caused by a temporally correlated error: data-qubit heating to the third excited state $|3\rangle$. We fully capture this effect with a parameter-free, device-level leakage model incorporating higher-state transport during syndrome extraction cycles. To suppress this error, we develop and realize a walking stability circuit, reaching a logical error probability floor of $\le 3.20\times 10^{-8}$ at 60 cycles---two orders of magnitude below the standard construction---and limited by ionizing radiation error bursts. Finally, by adaptively terminating syndrome extraction based on decoder confidence in an offline analysis, we reduce spacetime logical error by 38% and time overhead by 34% compared to the optimal fixed-cycle strategy.

quant-ph↗

Active isolation of transmon readout with a tunable inductive bridge

Scalable superconducting quantum computation requires fast, high-fidelity readout. Currently, this is assisted through cryogenic amplification of the readout signal. In traditional dispersive readout schemes, the amplifiers that are used to provide high signal-to-noise ratio also generate thermal noise that can decohere the qubits, demanding additional ferrite-based isolators to suppress this noise. Here, we integrate a chip-scale microwave switch, the tunable inductive bridge, into the readout chain of a fixed-frequency transmon. Flux-pulsing the switch, such that it transmits only during the readout, did not make a discernable difference to qubit coherence, residual excited-state population, or readout fidelity metrics. By injecting broadband noise that mimics amplifier thermal photons, we show that the switch suppresses the resulting qubit dephasing by more than $30$~dB, consistent with its independently measured on-off ratio, establishing it as a potential chip-based integrated replacement for readout-chain isolators.

quant-ph↗

Experimental advances with the QICK (Quantum Instrumentation Control Kit) for superconducting quantum hardware

The QICK is a standalone open source qubit controller that was first introduced in 2022. In this follow-up work, we present recent experimental use cases that the QICK uniquely enabled for superconducting qubit systems. These include multiplexed signal generation and readout, mixer-free readout, pre-distorted fast flux pulses, and phase-coherent pulses for parametric operations, including high-fidelity parametric entangling gates. We explain in detail how the QICK was used to enable these experiments.

quant-ph↗

Tunable inductive coupler for high fidelity gates between fluxonium qubits

The fluxonium qubit is a promising candidate for quantum computation due to its long coherence times and large anharmonicity. We present a tunable coupler that realizes strong inductive coupling between two heavy-fluxonium qubits, each with $\sim50$MHz frequencies and $\sim5$ GHz anharmonicities. The coupler enables the qubits to have a large tuning range of $\textit{XX}$ coupling strengths ($-35$ to $75$ MHz). The $\textit{ZZ}$ coupling strength is $<3$kHz across the entire coupler bias range, and $<100$Hz at the coupler off-position. These qualities lead to fast, high-fidelity single- and two-qubit gates. By driving at the difference frequency of the two qubits, we realize a $\sqrt{i\mathrm{SWAP}}$ gate in $258$ns with fidelity $99.72\%$, and by driving at the sum frequency of the two qubits, we achieve a $\sqrt{b\mathrm{SWAP}}$ gate in $102$ns with fidelity $99.91\%$. This latter gate is only 5 qubit Larmor periods in length. We run cross-entropy benchmarking for over $20$ consecutive hours and measure stable gate fidelities, with $\sqrt{b\mathrm{SWAP}}$ drift ($2 σ$) $< 0.02\%$ and $\sqrt{i\mathrm{SWAP}}$ drift $< 0.08\%$.

quant-ph↗

Fast high-fidelity gates for galvanically-coupled fluxonium qubits using strong flux modulation

Long coherence times, large anharmonicity and robust charge-noise insensitivity render fluxonium qubits an interesting alternative to transmons. Recent experiments have demonstrated record coherence times for low-frequency fluxonia. Here, we propose a galvanic-coupling scheme with flux-tunable $\textit{XX}$ coupling. To implement a high-fidelity entangling $\sqrt{i\mathrm{SWAP}}$ gate, we modulate the strength of this coupling and devise variable-time identity gates to synchronize required single-qubit operations. Both types of gates are implemented using strong ac flux drives, lasting for only a few drive periods. We employ a theoretical framework capable of capturing qubit dynamics beyond the rotating-wave approximation (RWA) as required for such strong drives. We predict an open-system fidelity of $F>0.999$ for the $\sqrt{i\mathrm{SWAP}}$ gate under realistic conditions.

quant-ph↗

The QICK (Quantum Instrumentation Control Kit): Readout and control for qubits and detectors

We introduce a Xilinx RFSoC-based qubit controller (called the Quantum Instrumentation Control Kit, or QICK for short) which supports the direct synthesis of control pulses with carrier frequencies of up to 6 GHz. The QICK can control multiple qubits or other quantum devices. The QICK consists of a digital board hosting an RFSoC (RF System-on-Chip) FPGA \cite{zcu111}, custom firmware and software and an optional companion custom-designed analog front-end board. We characterize the analog performance of the system, as well as its digital latency, important for quantum error correction and feedback protocols. We benchmark the controller by performing standard characterizations of a transmon qubit. We achieve an average Clifford gate fidelity of $\mathcal{F}_{avg}=99.93\%$. All of the schematics, firmware, and software are open-source \cite{QICKrepo}.

quant-ph↗