arXiv subjects

C. Simovski

Publications and source records attributed to C. Simovski.

11 recordsLinked to original sources

arXiv2022

On subwavelength resolution granted by dielectric microparticles

In this work we report a theoretical study of the lateral resolution granted by a simple glass microcylinder. In this 2D study, we had in mind the 3D analogue -- a microsphere whose ability to form a deeply subwavelength and strongly magnified image of submicron objects has been known since 2011. Conventionally, the microscope in which such the image is observed is tuned so that to see the areas behind the microsphere. This corresponds to the location of the virtual source formed by the microsphere at a distance longer than the distance of the real source to the miscroscope. Recently, we theoretically found a new scenario of superresolution, when the virtual source is formed in the wave beam transmitted through the microsphere. However, in this work we concentrated on the case when the superresolution is achieved in the impractical imaging system, in which the microscope objective lens is replaced by a microlens located at a distance smaller than the Rayleigh range. The present paper theoretically answers an important question: which scenario of far-field nanoimaging by a microsphere grants the finest spatial at very large distances. We found that the novel scenario (corresponding to higher refractive indices) promises further enhancement of the resolution.

physics.optics↗

arXiv2020

Non-resonant subwavelength imaging by dielectric microparticles

Recently a hypothesis explaining the non-resonant mechanism of subwavelength imaging granted by a dielectric microsphere has been suggested. In accordance to the hypothesis, the far-field image of a subwavelength scatterer strongly coupled to a microsphere by near fields is offered by the scatterer polarization normal to the sphere surface. The radiation of a closely located normally oriented dipole is shaped by the microsphere so that the transmitted wave beam has a practically flat phase front. Then this beam turns out to be imaging -- keeping the subwavelength information about the dipole location. However, this mechanism of subwavelength imaging was only supposed in our previous paper. In this paper, we present a theoretical study which confirms this hypothesis and better explains the underlying physics. In several scenarios of the imaging beam evolution either a flat or a slightly diverging phase front of the hollow wave beam formed by a microsphere enables the deeply subwavelength ($0.1-0.2\lambda$) resolution of two dipole sources. We numerically simulate one of these scenarios -- that one in which the focusing lens is located closer than the Rayleigh diffraction length to the beam-forming microsphere and represents a microsphere itself. In our simulations we replace a 3D microsphere by a 2D "sphere" (microcylinder) so that to use an available electromagnetic solver for dielectric microparticles of very large optical sizes. The physical mechanism of the imaging does not suffer of this replacement.

physics.optics↗

arXiv2020

Spatial Fano resonance of a dielectric microsphere impinged by a Bessel beam

General concept of Fano resonance is considered so that to show the possibility of this resonance in space. Using a recently found solution for a Bessel wave beam impinging a dielectric sphere, we analyze the electromagnetic fields near a microsphere with different optical size and permittivity values. We theoretically reveal a spatial Fano resonance when a resonant mode of the sphere interferes with {an amount of } non-resonant modes. This resonance results in a giant jump of the electric field behind the sphere impinged by the first-order Bessel beam. The local minimum of the electromagnetic field turns out to be noticeably distanced from the rear edge of the microsphere. However, this is a near-field effect and we prove it. We also show that this effect can be utilized for engineering a submicron optical trap with unusual and useful properties.

physics.optics↗

arXiv2020

Subwavelength effects near a dielectric microcylinder illuminated by a diffraction-free beam

Generation of a photonic nanojet by a linearly polarized wave beam or a plane wave impinging a dielectric microcylinder implies partial conversion of the propagating waves into the evanescent ones. This conversion is manifested in nanojet waist of subwavelength effective width. However, this known near-field effect is relatively weak. We theoretically show that the incidence of a wave beam formed by two plane waves enables much stronger near-field effects: a deeply subwavelength focusing of the incident beam and a strong enhancement of the electric field on the whole cylinder surface and near it. The domination of the evanescent waves in the vicinity of the cylinder results from the destructive interference of the propagating spatial harmonics of the scattered field dictated by the incident wave beam.

physics.optics↗

arXiv2015

Electromagnetic characterization of bianisotropic metasurfaces on refractive substrates: General theoretical framework

We present a general methodology for electromagnetic homogenization and characterization of bianisotropic metasurfaces formed by regular or random arrangements of small arbitrary inclusions at the interface of two different isotropic media. These topologies can provide the most general electric and magnetic surface-bound dipolar responses to incident electromagnetic waves. The approach unites and generalizes the earlier theories developed independently by two research groups: the joint group of profs. Holloway and Kuester and the joint group of profs. Simovski and Tretyakov. We demonstrate the use of both formalisms in several example cases and discuss the differences between the two approaches. Furthermore, we generalize the known theories for the bianisotropic metasurfaces located at interfaces between two different media or on a substrate. The generalized framework allows characterization of both periodical or amorphous metasurfaces. The developed analytical theory can be used in the analysis and synthesis of metasurfaces for a wide variety of applications.

cond-mat.mtrl-sci↗

arXiv2015

Comment on "Electromagnetic Radiation under Explicit Symmetry Breaking"

Recently published paper [PRL 114, 147701 (2015)] contains several misleading statements and misinterpretations of known facts. The main massage of the paper [PRL 114, 147701 (2015)] is as follows: "We have shown that explicit symmetry breaking in the structural configuration of charges leads to symmetry breaking of the electric field which results in electromagnetic radiation due to non-conservative current within a localized region of space and time" seems to transcend mere empiricism, touching the theoretical foundations of electromagnetism. Moreover, basic mistakes are numerous in this article and its main claim is wrong. Below we prove it citing the paper and arguing against it.

physics.optics↗

arXiv2014

Super-Planckian thermal emission from a hyperlens

We suggest and theoretically explore a possibility to strongly enhance the steady thermal radiation of a small thermal emitter using an infrared hyperlens. The hyperbolic metamaterial of the hyperlens converts emitter's near fields into the propagating waves which are efficiently irradiated from the hyperlens surface. Thus, with the hyperlens, emitter's spectral radiance goes well beyond the black-body limit for the same emitter in free space. Although the hyperlens can be kept at a much lower temperature than the emitter, the whole structure may radiate, in principle, as efficiently as a black body with the same size as that of the hyperlens and the same temperature as that of the emitter. We believe that this study can lead to a breakthrough in radiative cooling at microscale, which is crucial for microlasers and microthermophotovoltaic systems.

physics.optics↗

arXiv2012

Basics of averaging of the Maxwell equations for bulk materials

Volume or statistical averaging of the microscopic Maxwell equations (MEs), i.e. transition from microscopic MEs to their macroscopic counterparts, is one of the main steps in electrodynamics of materials. In spite of the fundamental importance of the averaging procedure, it is quite rarely properly discussed in university courses and respective books; up to now there is no established consensus about how the averaging procedure has to be performed. In this paper we show that there are some basic principles for the averaging procedure (irrespective to what type of material is studied) which have to be satisfied. Any homogenization model has to be consistent with the basic principles. In case of absence of this correlation of a particular model with the basic principles the model could not be accepted as a credible one. Another goal of this paper is to establish the averaging procedure for bulk MM, which is rather close to the case of compound materials but should include magnetic response of the inclusions and their clusters. In the vast majority of cases the consideration of bulk materials means that we consider propagation of an electromagnetic wave far from the interfaces, where the eigenwave in the medium has been already formed and stabilized. In other words, in this paper we consider the possible eigenmodes, which could exist in the equivalent homogenized media, and the necessary math apparatus for an adequate description of these waves. A discussion about boundary conditions and layered MM is a subject of separate publication and will be done elsewhere.

physics.optics↗

arXiv2011

Basics of averaging of the Maxwell equations

Volume or statistical averaging of the microscopic Maxwell equations (MEs), i.e. transition from microscopic MEs to their macroscopic counterparts, is one of the main steps in electrodynamics of materials. In spite of the fundamental importance of the averaging procedure, it is quite rarely properly discussed in university courses and respective books; up to now there is no established consensus about how the averaging procedure has to be performed. In this paper we show that there are some basic principles for the averaging procedure (irrespective to what type of material is studied) which have to be satisfied. Any homogenization model has to be consistent with the basic principles. In case of absence of this correlation of a particular model with the basic principles the model could not be accepted as a credible one. Another goal of this paper is to establish the averaging procedure for metamaterials, which is rather close to the case of compound materials but should include magnetic response of the inclusions and their clusters. We start from the consideration of bulk materials, which means in the vast majority of cases that we consider propagation of an electromagnetic wave far from the interfaces, where the eigenwave in the medium has been already formed and stabilized. A basic structure for discussion about boundary conditions and layered metamaterials is a subject of separate publication and will be done elsewhere.

physics.optics↗

arXiv2011

Multifrequency broadband tapered plasmonic nanoantennas

We suggest a novel multifrequency broadband plasmonic Yagi-Uda-type nanoantenna equipped with an array of tapered directors. Each director can be used for the excitation of the antenna by nanoemitters matched spectrally with the director resonant frequency and placed in the director near-field region. Multifrequency op- eration of nanoantennas provides tremendous opportunities for broadband emission enhancement, spectroscopy and sensing. By the principle of reciprocity, the same tapered nanoantenna architecture can be used both as a transmitter and/or as a receiver, thus being useful for creating a broadband wireless communication system.

physics.optics↗

arXiv2011

Nanostructures for very broadband or multi-frequency transition from wave beams to a subwavelength light distributions

In this paper we suggest and theoretically study a tapered plasmonic nanostructure which connects the incident wave beam with a subwavelength spatial region where the field is locally enhanced in a broad frequency range or for different operation frequencies. This spatial region has a frequency stable location near the contour of the tapered structure. This results from a special waveguide mode which can also exist in the tapered structure. We foresee many possible applications for our structure from prospective near-field scanning optical microscopes to interconnects between conventional optical waveguides and prospective optical nanocircuits.

physics.optics↗