arXiv subjects

C. Albert

Publications and source records attributed to C. Albert.

7 recordsLinked to original sources

arXiv2026

Nonequilibrium pulse dynamics and metastable latching in nonlinear kinetic inductance detectors

Microwave kinetic inductance detectors are typically operated at high readout power to raise the detector signal above system noise. At sufficiently large readout power, the current-dependent kinetic inductance couples the detector response to its readout bias. Using a nonlinear resonator framework and time-domain circuit calculations, we show that the amplitude, shape, and relaxation time of the driven detector's response depend on both the absorbed energy and on the readout bias. Strongly driven bias points produce amplified, extended, and non-exponential pulse responses. Qualitative agreement between calculated and measured pulse responses indicates that these effects are dominated by the driven nonlinear resonator dynamics rather than by altered quasiparticle dynamics. Beyond resonance bifurcation, sufficiently large pulse events drive the resonator between stable branches, resulting in a metastable latched state which persists after the quasiparticle transient has decayed. The pulse energy required for branch switching is set by the readout bias, suggesting a mode of triggered detection with an in-situ tunable threshold. Although nonlinear operation requires calibration of the bias- and energy-dependent response, the enhanced pulse amplitude and duration, together with tunable latching and the ability to select these parameters via the readout operating state, are likely to be of interest for single-photon and rare-event experiments, especially those limited by amplifier or system noise.

cond-mat.supr-con↗

arXiv2026

Resolving positive semi-definiteness in physics-informed kernels for scientific machine learning

Many modern machine learning models can be understood as kernel-based function-space models, including Gaussian processes and neural tangent kernels. In scientific machine learning, differential operators are increasingly used to encode physical structure directly into such models. However, it has remained unclear under which conditions these constructions are valid machine learning models, i.e. preserve positive semi-definiteness, and whether observed instabilities arise from ill-posed modeling or numerical effects. Here, we establish a simple and sufficient condition for positive semi-definiteness: for linear differential operators of order m, the base kernel must be m-times continuously differentiable. Crucially, this guarantee holds for operators with non-constant and even discontinuous coefficients. Examples are ubiquitous in physical systems, including diffusion, material elasticity, wave propagation in inhomogeneous media, and quantum systems. We conclude that remaining instabilities are attributable to numerical issues, providing a unifying validity foundation for operator-informed kernel methods.

physics.comp-ph↗

arXiv2023

Fabrication Development for SPT-SLIM, a Superconducting Spectrometer for Line Intensity Mapping

Line Intensity Mapping (LIM) is a new observational technique that uses low-resolution observations of line emission to efficiently trace the large-scale structure of the Universe out to high redshift. Common mm/sub-mm emission lines are accessible from ground-based observatories, and the requirements on the detectors for LIM at mm-wavelengths are well matched to the capabilities of large-format arrays of superconducting sensors. We describe the development of an R = 300 on-chip superconducting filter-bank spectrometer covering the 120--180 GHz band optimized for future mm-LIM experiments, focusing on SPT-SLIM, a pathfinder LIM instrument for the South Pole Telescope. Radiation is coupled from the telescope optical system to the spectrometer chip via an array of feedhorn-coupled orthomode transducers. Superconducting microstrip transmission lines then carry the signal to an array of channelizing half-wavelength resonators, and the output of each spectral channel is sensed by a lumped element kinetic inductance detector (leKID). Key areas of development include incorporating new low-loss dielectrics to improve both the achievable spectral resolution and optical efficiency and development of a robust fabrication process to create a galvanic connection between ultra-pure superconducting thin-films to realize multi-material (hybrid) leKIDs. We provide an overview of the spectrometer design, fabrication process, and prototype devices.

astro-ph.IM↗

arXiv2023

Measurement of Dielectric Loss in Silicon Nitride at Centimeter and Millimeter Wavelengths

This work presents a suite of measurement techniques for characterizing the dielectric loss tangent across a wide frequency range from $\sim$1 GHz to 150 GHz using the same test chip. In the first method, we fit data from a microwave resonator at different temperatures to a model that captures the two-level system (TLS) response to extract and characterize both the real and imaginary components of the dielectric loss. The inverse of the internal quality factor is a second measure of the overall loss of the resonator, where TLS loss through the dielectric material is typically the dominant source. The third technique is a differential optical measurement at 150 GHz. The same antenna feeds two microstrip lines with different lengths that terminate in two microwave kinetic inductance detectors (MKIDs). The difference in the detector response is used to estimate the loss per unit length of the microstrip line. Our results suggest a larger loss for SiN$_x$ at 150 GHz of ${\mathrm{\tan \delta\sim 4\times10^{-3}}}$ compared to ${\mathrm{2.0\times10^{-3}}}$ and ${\mathrm{\gtrsim 1\times10^{-3}}}$ measured at $\sim$1 GHz using the other two methods. {These measurement techniques can be applied to other dielectrics by adjusting the microstrip lengths to provide enough optical efficiency contrast and other mm/sub-mm frequency ranges by tuning the antenna and feedhorn accordingly.

astro-ph.IM↗

arXiv2022

Strategies for reducing frequency scatter in large arrays of superconducting resonators

Superconducting resonators are now found in a broad range of applications that require high-fidelity measurement of low-energy signals. A common feature across almost all of these applications is the need for increased numbers of resonators to further improve sensitivity, and the ability to read out large numbers of resonators without the need for additional cryogenic complexity is a primary motivation. One of the major limitations of current resonator arrays is the observed scatter in the resonator frequencies when compared to the initial design. Here we present recent progress toward identifying one of the dominant underlying causes of resonator scatter, inductor line width fluctuation. We designed and fabricated an array of lumped-element resonators with inductor line width changing from 1.8um to 2.2um in step of 0.1um defined with electron-beam lithography to probe and quantify the systematic variation of resonance frequency across a 6-inch wafer. The resonators showed a linear frequency shift of 20MHz (140FWHM) and 30MHz (214FWHM), respectively, as they are connected to two different capacitors. This linear relationship matches our theoretical prediction. The widely used MLA photon lithography facility for MKID fabrication has a resolution on the order of 600nm, which could cause frequency fluctuation on the order of 100MHz or 710FWHM.

cond-mat.supr-con↗

arXiv2021

A quasi-continuous exhaust scenario for a fusion reactor: the renaissance of small edge localized modes

Tokamak operational regimes with small edge localized modes (ELMs) could be a solution to the problem of large transient heat loads in future fusion reactors because they provide quasi-continuous exhaust while keeping a good plasma confinement. A ballooning mode mechanism near the last closed flux surface (LCFS) governed by an interplay of the pressure gradient and the magnetic shear there has been proposed for small ELMs in high density ASDEX Upgrade and TCV discharges. In this manuscript we explore different factors relevant for plasma edge stability in a wide range of edge safety factors by changing the connection length between the good and the bad curvature side. Simultaneously this influences the stabilizing effect of the local magnetic shear close to the LCFS as well as the $E \times B$ flow shear. Ideal ballooning stability calculations with the HELENA code reveal that small ELM plasmas are indeed unstable against ballooning modes very close to the LCFS but can exhibit second ballooning stability in the steep gradient region which correlates with enhanced confinement. We also present first non-linear simulations of small ELM regimes with the JOREK code including the $E \times B$ shear which indeed develop ballooning like fluctuations in the high triangularity limit. In the region where the small ELMs originate the dimensionless parameters are very similar in our investigated discharges and in a reactor, making this regime the ideal exhaust scenario for a future reactor.

physics.plasm-ph↗

arXiv2005

Magnetism and the Weiss Exchange Field - A Theoretical Analysis Inspired by Recent Experiments

The huge spin precession frequency observed in recent experiments with spin-polarized beams of hot electrons shot through magnetized films is interpreted as being caused by Zeeman coupling of the electron spins to the so-called Weiss exchange field in the film. A "Stern-Gerlach experiment" for electrons moving through an inhomogeneous exchange field is proposed. The microscopic origin of exchange interactions and of large mean exchange fields, leading to different types of magnetic order, is elucidated. A microscopic derivation of the equations of motion of the Weiss exchange field is presented. Novel proofs of the existence of phase transitions in quantum XY-models and antiferromagnets, based on an analysis of the statistical distribution of the exchange field, are outlined.

cond-mat.str-el↗