arXiv subjects

B. Scheid

Publications and source records attributed to B. Scheid.

4 recordsLinked to original sources

arXiv2026

Sudden expansion stability thresholds modified by lateral flows

We study the flow in a symmetric three-dimensional confined sudden expansion with lateral inflow at Reynolds number below 300 and varying lateral-to-central flow rate ratio, using experiments, linear stability analysis, weakly nonlinear theory, and direct numerical simulations. Three distinct flow regimes are identified. Outside an intermediate band of lateral-to-central flow rate ratio, the flow undergoes a steady symmetry-breaking bifurcation above a critical Reynolds number, deflecting the central jet toward one side wall; weakly nonlinear analysis shows this bifurcation to be supercritical, excepting a very narrow parametric range. Within the intermediate band, no such critical Reynolds number exists and direct numerical simulations confirm that residual velocity asymmetries reflect the imposed geometric imperfections rather than intrinsic amplification. Fluctuations observed experimentally in the intermediate band of lateral-to-central flow rate ratio remain unexplained and warrant further investigation.

physics.flu-dyn↗

arXiv2020

Dynamics of the Jet Wiping Process via Integral Models

The jet wiping process is a cost-effective coating technique that uses impinging gas jets to control the thickness of a liquid layer dragged along a moving strip. This process is fundamental in various coating industries (mainly in hot-dip galvanizing) and is characterized by an unstable interaction between the gas jet and the liquid film that results in wavy final coating films. To understand the dynamics of the wave formation, we extend classic laminar boundary layer models for falling films to the jet wiping problem, including the self-similar integral boundary layer (IBL) and the weighted integral boundary layer (WIBL) models. Moreover, we propose a transition and turbulence model (TTBL) to explore modelling extensions to larger Reynolds numbers and to analyze the impact of the modelling strategy on the liquid film dynamics. The validity of the long-wave formulation was first analyzed on a simpler problem, consisting of a liquid film falling over an upward-moving wall, using Volume Of Fluid (VOF) simulations. This validation proved the robustness of the integral formulation in conditions that are well outside their theoretical limits of validity. Finally, the three models were used to study the response of the liquid coat to harmonic and non-harmonic oscillations and pulsations in the impinging jet. The impact of these disturbances on the average coating thickness and wave amplitude is analyzed, and the range of dimensionless frequencies yielding maximum disturbance amplification is presented.

physics.flu-dyn↗

arXiv2019

Natural break-up and satellite formation regimes of surfactant-laden liquid threads

We report a numerical analysis of the unforced break-up of free cylindrical threads of viscous Newtonian liquid whose interface is coated with insoluble surfactants, focusing on the formation of satellite droplets. The initial conditions are harmonic disturbances of the cylindrical shape with a small amplitude $\epsilon$, and whose wavelength is the most unstable one deduced from linear stability theory. We demonstrate that, in the limit $\epsilon \to 0$, the problem depends on two dimensionless parameters, namely the Laplace number, $La=\rho \sigma_0 \bar{R}/\mu^2$, and the elasticity parameter, $\beta=E/\sigma_0$, where $\rho$, $\mu$ and $\sigma_0$ are the liquid density, viscosity and initial surface tension, respectively, $E$ is the Gibbs elasticity and $\bar{R}$ is the unperturbed thread radius. A parametric study is presented to quantify the influence of $La$ and $\beta$ on two key quantities: the satellite droplet volume and the mass of surfactant trapped at the satellite's surface just prior to pinch-off, $V_{sat}$ and $\Sigma_{sat}$, respectively. We identify a weak-elasticity regime, $\beta \lesssim 0.05$, in which the satellite volume and the associated mass of surfactant obey the scaling law $V_{sat} = \Sigma_{sat} = 0.0042 La^{1.64}$ for $La \lesssim 2$. For $La \gtrsim 10$, $V_{sat}$ and $\Sigma_{sat}$ reach a plateau of about $3 \%$ and $2.9 \%$ respectively, $V_{sat}$ being in close agreement with previous experiments of low-viscosity threads with clean interfaces. For $La<7.5$, we reveal the existence of a discontinuous transition at a critical elasticity $\beta_c (La)$, with $\beta_c \to 0.98$ for $La \lesssim 0.2$, such that $V_{sat}$ and $\Sigma_{sat}$ abruptly increase. The jumps experienced by both quantities reach a plateau when $La \lesssim 0.2$, while they decrease monotonically as $La$ increases up to $La = 7.5$, where both become zero.

physics.flu-dyn↗

arXiv2018

Bubbles determine the amount of alcohol in Mezcal

Mezcal is a traditional alcoholic Mexican spirit distilled from fermented agave juices that has been produced for centuries. Its preparation and testing involves an artisanal method to determine the alcohol content based on pouring a stream of the liquid into a small vessel: if the alcohol content is correct, stable bubbles, known as pearls, form at the surface and remain floating for some time. It has been hypothesized that an increase in bubble lifetime results from a decrease in surface tension due to added surfactants. However, the precise mechanism for extended lifetime remains unexplained. By conducting experiments and numerical simulations, we studied the extended lifetime of pearls. It was found that both changes in fluid properties (resulting from mixing ethanol and water) and the presence of surfactants are needed to observe pearls with a long lifetime. Moreover, we found that the dimensionless lifetime of a bubble first increases with the Bond number, until reaching a maximum at $Bo\approx 1$, and then continuously decreases. Our findings on bubble stability in Mezcal not only explain the effectiveness of the artisanal method, but it also provides insight to other fields where floating bubbles are relevant such as in oceanic foam, bio-foams, froth flotation and magma flows.

physics.flu-dyn↗