Graphene Transfer for Vertical Amorphous-Selenium Photodetectors: Fabrication, Optical Transmission and Operation at 77 K
Graphene can serve as a VUV transparent electrode in vertical photodetector devices. Using an optically transparent graphene as a top-electrode of amorphous selenium (a-Se) photoconductor requires transfer process compatible with the thermal and chemical sensitivities of a-Se thin films. The baking and polymer-removal steps of conventional commercial Trivial Transfer graphene procedures are undesirable because heating can promote selenium crystallization and prolonged solvent exposure can cause delamination. We implement two alternatives: PMMA-free transfer of nominal 50-layer graphene and transfer of nominal 10-layer graphene using an approximately 80 nm PMMA support removed in acetone at 40C. Raman G and 2D bands identify graphene after transfer. Separate graphene/MgF2 specimens are characterized by dark-corrected transmission measurements over 120-325 nm and compared with earlier single-layer and nominal 6-8-layer Trivial Transfer spectra. The completed graphene/a-Se/Cr devices produce bias-dependent voltage transients under pulsed 415 nm illumination at 293 K and 77 K. These results establish an a-Se-compatible fabrication route for graphene-electrode devices and demonstrate vertical device operation at both room and cryogenic temperatures. The completed devices provide a platform for detection-efficiency studies, and direct VUV photoresponse measurements now underway.