arXiv subjects

B Fang

Publications and source records attributed to B Fang.

3 recordsLinked to original sources

arXiv2025

From Heat Capacity to Coherence in Ultra-Narrow-Linewidth Solid-State Optical Emitters at Sub-Kelvin Temperatures

The coherence properties of optical emitters in crystals are crucial for quantum technologies and optical frequency metrology. Cooling to sub-kelvin temperatures can markedly enhance coherence, making it important to identify the parameters governing emitter and host crystal behavior in this regime. We investigate a Czochralski-grown europium-doped yttrium orthosilicate crystal, reporting measurements of its heat capacity and optical coherence. Heat capacity not only informs thermal noise limits in metrology schemes but can also reveal two-level systems (TLS) arising from crystal imperfections via a linear-in-temperature term. Below 1 K, where phonon contributions are suppressed, TLS can drive decoherence, leading to a linear broadening of the homogeneous linewidth. From our data, we place an upper bound on the TLS contribution. This, together with constant optical linewidths between 300 mK and 2 K measured via photon-echo lifetimes, is consistent with a minimal TLS effects in our sample. A low level of TLS is particularly important for the performance of optical quantum devices based on doped crystals, since their presence could otherwise limit further improvements in coherence at sub-kelvin temperatures.

cond-mat.mtrl-sci↗

arXiv2024

Thermal-noise Limits to the Frequency Stability of Burned Spectral Holes

Techniques in frequency stabilization of lasers to fixed-spacer optical cavities have advanced to the point where the ultimate frequency stabilities are limited by thermal noise in the cavity materials for standard cavity configurations at room temperature. The use of spectral-hole burning (SHB) in laser stabilization has produced promising results in early experiments. In this letter we explore the thermal-noise limits to frequency stability in burned spectral holes. We compile known material parameters for a typical system used in SHB experiments (Eu 3+ doped Y 2 SiO 5 ) to make numerical estimates for the fundamental thermal-noise induced frequency instability in spectral-holes for the liquid-helium temperature and dilution temperature cases. These efforts can guide the design of future SHB experiments and clarify which important material parameters remain to be measured.

cond-mat.mtrl-sci↗

arXiv2024

Homogeneous Linewidth Behaviour of Narrow Optical Emitters at Sub-kelvin Temperatures

We explore the properties of ultra-narrow spectral holes in ensembles of solid-state emitters in crystals over a range of sub-kelvin temperatures, with a focus on their potential application in frequency stabilization schemes as an alternative to ultrastable cavities. We investigate how the parameters used to burn the spectral hole impact its shape, and how these factors determine the minimum achievable linewidth. In addition to the stability of the hole's center frequency, the linewidth and contrast play a crucial role in frequency locking. At sub-kelvin temperatures, the temperaturedependent T^7 broadening from two-phonon Raman scattering is expected to be negligible, and the spectral hole's linewidth should therefore remain constant in this interval. We observe however a linear broadening with increasing temperature, highlighting the need for further investigation into the mechanisms governing the linewidth at ultra-low temperatures.

cond-mat.mes-hall↗