arXiv subjects

Alokmay Datta

Publications and source records attributed to Alokmay Datta.

11 recordsLinked to original sources

arXiv2024

Presence of a Spatially Varying Electric Field at Lipid-Water Interface with Na/K ratio in Water

The ion-lipid interface in Langmuir monolayers of Dipalmitoylphosphatidylcholine (DPPC) on pure water and 10 mM solutions of Na+ and K+ at different [K+]/[Na+] (a), atom/atom ratios, were studied initially by Surface Pressure (p) versus Specific Molecular Area (A) isotherms. The values of a were chosen as 0 (no K+), 0.43 ([K+]:[Na+] = 30:70) and 1.0 ([K+]:[Na+] = 50:50) These monolayers were studied through X-Ray Reflectivity (XRR) and Near Edge X-ray Absorption Fine Structure (NEXAFS) spectroscopy at the O K-edge. The two-dimensional rigidity of the monolayer was found to increase with Na+ ions with respect to the pristine monolayer but fall drastically and non-linearly below the pristine value with introduction of the K+ ions, as a was increased. Analysis of the XRR profiles provided the thickness, average electron density (aed) and the interfacial roughness of the phosphatidylcholine head group and the two hydrocarbon tails of the monolayers on Si (001), from which the angle (f) between the head and the tails was determined. This was also follow the same as former one. From NEXAFS, it was found that a linear increase in the cation ratio towards K led to a nonlinear variation in the P=O bond energy and a weakening of the P-O bond energy, the latter becoming more pronounced with K ions, consistent with Fajans rule. Also a split in the C=O p-bond peak was observed at a = 1.0. These results cannot be explained with the model of a uniform electric field due to the cations, which would fall linearly with increase in the K+ proportion, and rather suggest a structured field due a spatial variation in charge density in an interfacial layer of high ion concentration assembled by the counterionic attraction of the phosphatidylcholine head groups. Our results have important implications for the cell membrane, where such mixtures at high concentrations constitute the norm.

physics.bio-ph↗

arXiv2023

Investigating Lipid Bilayer Self-Assembly and Formation of Ripple Phase: Insights from a Coarse-Grained Implicit Solvent Model

In this study, we present a comprehensive exploration of formation of different phases in lipid molecules using a coarse-grained implicit solvent model, where each lipid molecule is represented as a rigid, three-bead rod-like structure. Our study not only successfully replicates the spontaneous self-assembly of lipid bilayers but also elucidates the intricate phase transitions between the gel phase, liquid phase, and the elusive ripple phase(Pbeta). Specifically, we uncover the pivotal role of molecular rigidity in promoting the formation of the ripple phase. The significance of our findings lies in their potential to reshape our understanding of lipid bilayer dynamics and phase transitions. By shedding light on the ripple phase, a phase previously difficult to simulate convincingly, the insights gained from this study have the potential to guide future investigations into the behavior of biological membranes and their role in cellular processes.

cond-mat.soft↗

arXiv2023

Phase Transitions In An Implicit Solvent Minimal Model Of Lipids: Role Of Head-Tail Size Ratio

We present Monte Carlo simulations under constant NVT conditions on a minimal three beads coarse grained implicit solvent model of lipid molecules, with the hydrophilic head represented by one bead and the hydrophobic tail represented by two beads. We consider two lipids, one with the head and tail bead sizes equal and the other with the tail beads smaller than the head. When cooled to the ambient temperature from an initial isotropic phase at high temperature, the first lipid transforms spontaneously to a lamellar phase while the second lipid transforms to a micellar phase, showing the crucial role of the head and tail size ratio on lipid phases.

cond-mat.soft↗

arXiv2016

Counterion Effects on Nano-confined Metal-Drug-DNA Complexes

We have explored morphology of DNA molecules bound with Cu-complexes of piroxicam molecules, a non-steroidal anti-inflammatory drug (NSAID), under one-dimensional confinement of thin films and have studied the effect of counterions present in a buffer. X-ray reflectivity at and away from the Cu K absorption edge and atomic force microscopy studies reveal that confinement segregates the drug molecules preferentially in a top layer of the DNA film, and counterions enhance this segregation.

cond-mat.soft↗

arXiv2014

Lipophilic Force Driven Dynamics in Langmuir monolayers: In-plane Coalescence and Out-of-plane Diffusion

While monolayer area fraction versus time ($A_{n}-t$) curves obtained from surface pressure-area ($π-A$) isotherms for desorption-dominated (DD) processes in Langmuir monolayers of fatty acids represent continuous loss, those from Brewster Angle Microscopy (BAM) also show a 2D coalescence. For nucleation-dominated (ND) processes both techniques suggest competing processes, with BAM showing 2D coalescence alongside multilayer formation. $π$ enhances both DD and ND with a lower cut-off for ND, while temperature has a lower cut-off for DD but negligible effect on ND. Hydrocarbon chain length has the strongest effect, causing a cross-over from DD to ND dynamics. Imaging Ellipsometry (IE) of horizontally transferred films onto Si(100) shows Stranski-Krastanov (SK) like growth for ND process in arachidic acid monolayer resulting in succesive stages of monolayer, trilayer, multilayer islands, ridges from lateral island-coalescence and shallow wavelike structures from ridge-coalescence on the film surface. These studies show that lipophilic attraction between hydrocarbon chains is the driving force at all stages of long term monolayer dynamics.

cond-mat.soft↗

arXiv2014

Effects of Counterions on Nano-confined DNA Thin Films

DNA molecules spin-coated on amorphous quartz substrates are shown to form stable films. Electron density profiles (EDPs) along the film depth show that film prepared from aqueous solution of DNA exhibits layering of the molecules in three stacks parallel to the substrate whereas film prepared from counterion added solution does not have layering but have smaller thickness and enhanced surface roughness, although both films have 'liquid-like' height-height correlations. We explain these results by a model of film of a 'liquid' comprising of rod-like molecules where the counterion concentration in the liquid determines the rod length.

cond-mat.soft↗

arXiv2014

'Coffee-ring' patterns of polymer droplets: chain entanglement effect

Dried droplets of polymer solutions of different molecular weights and concentrations leave various types of 'coffee-ring' patterns. These patterns are consequence of contact line motion. We have observed for very low molecular weight the droplet periphery part contains spheroidal structures whereas central part contains continuous layer. For higher molecular weight contact line exhibits 'stick-slip' motion. Whereas for very high molecular weight contact line delays enough to start motion and finally moves uninterruptedly leaving a continuous layer of polymer. We have explained this phenomena in terms of chain entanglement which is resultant of molecular weight and solution concentration. Depending on the entanglement chains can exhibit 'granular' and 'collective' behavior even when monomer numbers remain same within the droplets.

cond-mat.soft↗

arXiv2006

Nanoconfined Polystyrene: A New Phase

Transverse layering of molecular gyration spheres in spin-coated atactic polystyrene ($aPS$) films, for film thickness $R \leq$ 4$R_g$ ($R_g$ = unperturbed gyration radius), causes an increase in free energy that does not follow the $(R_g/R)^{-2}$ dependence of planar confinement and is explained by invoking a fixed-range, repulsive, modified Pöschl-Teller intermolecular potential, its strength decreasing with increase in $R$. Vacuum ultraviolet spectroscopy reveals a change in 'physical dimers' of adjacent pendant benzene rings of $aPS$ from 'oblique' to 'head-to-tail' configuration as film thickness goes from 9$R_{g}$ to 2$R_{g}$. This reduces cohesion by reducing dimer dipole moment. Thus a new phase of $aPS$, the nanoconfined phase, ordered but with lower cohesion than bulk, is formed.

cond-mat.soft↗

arXiv2006

Tunable Self-assembly of Au-nanoparticles with Near-Perfect Monodispersity

Au nanoparticles with near perfect monodispersity in shape and size self-assemble, very slowly and at room temperature, on polystyrene films for film thickness < 4R_{g}$, R_{g} being unperturbed polymer gyration radius. Nanoparticle shape and size can be tuned, without sacrificing monodispersity, by changing polymer film thickness. Self-assembly is caused by enhanced two-dimensional diffusion of sputter-deposited Au clusters on a distribution of surface energy variations, sharply defined and with tunable dimensions, corresponding to low cohesion between gyration spheres on film surface. Lowering of cohesion and enhanced surface diffusion are clearly related to confinement-induced gyration sphere layering along film depth.

cond-mat.mtrl-sci↗

arXiv2005

Interface-dominated Growth of a Metastable Novel Alloy Phase

A new \textit{D0$_{23}$} metastable phase of Cu$_3$Au is found to grow at the interfaces of Au/Cu multilayers deposited by magnetron sputtering. The extent of formation of this novel alloy phase depends upon an optimal range of interfacial width primarily governed by the deposition wattage of the dc-magnetron used. Such interfacially confined growth is utilized to grow a $\sim$ 300 nm thick Au/Cu multilayer with thickness of each layer nearly equal to the optimal interfacial width which was obtained from secondary ion mass spectrometry (SIMS) data. This growth technique is observed to enhance the formation of the novel alloy phase to a considerable extent. SIMS depth profile also indicates that the mass fragment corresponding to Cu$_3$Au occupies the whole film while x-ray diffraction (XRD) shows almost all the strong peaks belonging to the \textit{D0$_{23}$} structure. High resolution cross-sectional transmission electron microscopy (HR-XTEM) shows the near perfect growth of the individual layers and also the lattice image of the alloy phase in the interfacial region. Vacuum annealing of the alloy film and XRD studies indicate stabilization of the \textit{D0$_{23}$} phase at $\sim$ 150$^{\circ}$C. The role of interfacial confinement, the interplay between interfacial strain and free energy and the hyperthermal species generated during the sputtering process are discussed.

cond-mat.mtrl-sci↗

arXiv2005

Localization of Excitons by Molecular Layer Formation in a Polymer Film

Atactic polystyrene of two different molecular weights (560900 g.mol-1 and 212400 g.mol-1) have been studied as spin-coated films of thickness varying from ~30 nm to ~250 nm, i.e., ~2Rg to ~12Rg where Rg is the unperturbed radius of gyration of polystyrene, using x-ray reflectivity and transmission UV-spectroscopy. Electron density profiles along depth of the films show formation of layers parallel to the substrate surface, when the film thickness is below 4Rg, with layer spacing ~2Rg. The pure electronic singlet 1A1g -> 1E1u indicates exciton interaction throughout film thickness, as evidenced by the lineshape, drop in extinction coefficient and size-dependent blue shift of the corresponding UV peak. Analysis of the total energy of the exciton as a function of film thickness shows that above the thickness of 4Rg the exciton is delocalized over the film thickness through linear, molecular J-aggregates. The separations between these molecules in the two polystyrene samples match with the respective layer spacing obtained from x-ray reflectivity. Transition dipole moments of the molecules in this aggregate are parallel and each dipole is arranged at an angle of ~43 degrees with the axis of the linear chain. Below a film thickness of 4Rg, as the molecular layers are formed, the exciton becomes localized within these layers. This localization is clearly indicated by the lineshape becoming comparable to isolated molecular bands, and by both the extinction coefficient and blue shift reaching maximum values and becoming size independent. Localization of excitons due to layer formation has been explained as caused by decrease of cohesion between layers.

cond-mat.soft↗