arXiv subjects

Alessandro Cardini

Publications and source records attributed to Alessandro Cardini.

7 recordsLinked to original sources

arXiv2026

The impact of seasonality over the sensitivity of Einstein Telescope and the SNR of CBC signals at the Sardinia candidate site

This work presents the first investigation of the impact of seasonal variations in seismic noise on the low-frequency performance of the Einstein Telescope (ET) at the Sardinia candidate site, focusing on their effect on compact binary coalescence signals. Using seismic data collected between 2022 and 2025 from a deep borehole, we characterize the seasonal variability of the seismic noise and identify the months of July and December as representative best- and worst-case conditions. The measured seismic spectra are used to estimate the Newtonian noise contribution in the 2--10 Hz frequency range and to derive corresponding modifications to the ET design sensitivity. These sensitivity curves are then used in simulations of binary neutron star and intermediate-mass black hole signals in the triangular ET configuration to quantify the resulting changes in signal-to-noise ratio. We find that median seasonal conditions produce only minor changes in the expected SNR, with deviations from the design case typically below 2$\%$. Larger effects are found for the upper tail of the December noise distribution, where the average SNR loss reaches approximately 20--25$\%$. These results indicate that seasonal seismic variability at the Sardinia candidate site has a limited impact on the low-frequency performance of ET under typical conditions.

gr-qc↗

arXiv2025

The impact of local noise recorded at the ET candidate sites on the signal to noise ratio of CBC gravitational wave signals for the ET triangle configuration

We present an evaluation of how site dependent noise can affect the signal to noise ratio (SNR) of compact binary coalescence (CBC) signals in the future 3rd generation gravitational wave (GW) detector Einstein Telescope (ET). The design of ET is currently pushing the scientific community to study its scientific potential with respect to known, and possibly unexpected, GW signals using its design sensitivity curves. However, local ambient noise may have an impact on the ET sensitivity at low frequency and therefore affect the SNR of CBC signals at low frequency. Therefore, we study the impact of ambient noise on the ET sensitivity curve at the two sites candidate to host ET - Sardinia, in Italy, and the Euregio Meuse-Rhine (EMR) at the Netherlands-Belgium border - and infer the impact on the ET sensitivity curve and how the SNR of CBC signals at low frequencies is affected. We find that Sardinia shows results which are on par, if not better, than the design case. On the other hand, ambient noise for the current EMR sensitivity curve in Terziet causes a higher degradation of the SNR performances.

gr-qc↗

arXiv2024

Correlated 0.01Hz-40Hz seismic and Newtonian noise and its impact on future gravitational-wave detectors

We report correlations in underground seismic measurements with horizontal separations of several hundreds of meters to a few kilometers in the frequency range 0.01Hz to 40Hz. These seismic correlations could threaten science goals of planned interferometric gravitational-wave detectors such as the Einstein Telescope as well as atom interferometers such as MIGA and ELGAR. We use seismic measurements from four different sites, i.e. the former Homestake mine (USA) as well as two candidate sites for the Einstein Telescope, Sos Enattos (IT) and Euregio Maas-Rhein (NL-BE-DE) and the site housing the MIGA detector, LSBB (FR). At all sites, we observe significant coherence for at least 50% of the time in the majority of the frequency region of interest. Based on the observed correlations in the seismic fields, we predict levels of correlated Newtonian noise from body waves. We project the effect of correlated Newtonian noise from body waves on the capabilities of the triangular design of the Einstein Telescope's to observe an isotropic gravitational-wave background (GWB) and find that, even in case of the most quiet site, its sensitivity will be affected up to $\sim$20Hz. The resolvable amplitude of a GWB signal with a negatively sloped power-law behaviour would be reduced by several orders of magnitude. However, the resolvability of a power-law signal with a slope of e.g. $\alpha=0$ ($\alpha=2/3$) would be more moderately affected by a factor $\sim$ 6-9 ($\sim$3-4) in case of a low noise environment. Furthermore, we bolster confidence in our results by showing that transient noise features have a limited impact on the presented results.

gr-qc↗

arXiv2021

Accurate modelling of 3D-trench silicon sensor with enhanced timing performance and comparison with test beam measurements

This paper presents the detailed simulation of a double-pixel structure for charged particle detection based on the 3D-trench silicon sensor developed for the TIMESPOT project and a comparison of the simulation results with measurements performed at $\pi-$M1 beam at PSI laboratory. The simulation is based on the combined use of several software tools (TCAD, GEANT4, TCoDe and TFBoost) which allow to fully design and simulate the device physics response in very short computational time, O(1-100 s) per simulated signal, by exploiting parallel computation using single or multi-thread processors. This allowed to produce large samples of simulated signals, perform detailed studies of the sensor characteristics and make precise comparisons with experimental results.

physics.ins-det↗

arXiv2020

Muon identification for LHCb Run 3

Muon identification is of paramount importance for the physics programme of LHCb. In the upgrade phase, starting from Run 3 of the LHC, the trigger of the experiment will be solely based on software. The luminosity increase to $2\times10^{33}$ cm$^{-2}$s$^{-1}$ will require an improvement of the muon identification criteria, aiming at performances equal or better than those of Run 2, but in a much more challenging environment. In this paper, two new muon identification algorithms developed in view of the LHCb upgrade are presented, and their performance in terms of signal efficiency versus background reduction is shown.

hep-ex↗

arXiv2020

Intrinsic time resolution of 3D-trench silicon pixels for charged particle detection

In the last years, high-resolution time tagging has emerged as the tool to tackle the problem of high-track density in the detectors of the next generation of experiments at particle colliders. Time resolutions below 50ps and event average repetition rates of tens of MHz on sensor pixels having a pitch of 50$\mu$m are typical minimum requirements. This poses an important scientific and technological challenge on the development of particle sensors and processing electronics. The TIMESPOT initiative (which stands for TIME and SPace real-time Operating Tracker) aims at the development of a full prototype detection system suitable for the particle trackers of the next-to-come particle physics experiments. This paper describes the results obtained on the first batch of TIMESPOT silicon sensors, based on a novel 3D MEMS (micro electro-mechanical systems) design. Following this approach, the performance of other ongoing silicon sensor developments has been matched and overcome, while using a technology which is known to be robust against radiation degradation. A time resolution of the order of 20ps has been measured at room temperature suggesting also possible improvements after further optimisations of the front-end electronics processing stage.

physics.ins-det↗

arXiv1999

Kalman Filter Track Fits and Track Breakpoint Analysis

We give an overview of track fitting using the Kalman filter method in the NOMAD detector at CERN, and emphasize how the wealth of by-product information can be used to analyze track breakpoints (discontinuities in track parameters caused by scattering, decay, etc.). After reviewing how this information has been previously exploited by others, we describe extensions which add power to breakpoint detection and characterization. We show how complete fits to the entire track, with breakpoint parameters added, can be easily obtained from the information from unbroken fits. Tests inspired by the Fisher F-test can then be used to judge breakpoints. Signed quantities (such as change in momentum at the breakpoint) can supplement unsigned quantities such as the various chisquares. We illustrate the method with electrons from real data, and with Monte Carlo simulations of pion decays.

physics.data-an↗