arXiv subjects

Alberto Nardi

Publications and source records attributed to Alberto Nardi.

5 recordsLinked to original sources

arXiv2024

An ultra-broadband photonic-chip-based traveling-wave parametric amplifier

Optical amplification, crucial for modern communication and data center interconnects, primarily relies on erbium-doped fiber amplifiers (EDFAs) to enhance signals without distortion. While EDFAs were historically decisive for the introduction of dense wavelength-division multiplexing, they only cover a portion of the low-loss spectrum of optical fibers. Pioneering work on optical traveling-wave parametric amplifiers (TWPAs) utilizing intrinsic third-order optical nonlinearity has led to demonstrations of increased channel capacity and performance. TWPAs are unidirectional, offer high gain, and can reach the 3-dB quantum limit for phase-preserving amplifiers. Despite the use of highly nonlinear fibers or bulk waveguides, their power requirements and technical complexity have impeded adoption. In contrast, TWPAs based on photonic integrated circuits (PICs) offer the advantages of substantially increased mode confinement and optical nonlinearity but have been limited in bandwidth because of the trade-off with maintaining low propagation loss. We overcome this challenge by using low-loss gallium phosphide-on-silicon dioxide PICs and attain up to 35~dB of parametric gain with waveguides only a few centimeters long in a compact footprint of 0.25 square millimeters. Fiber-to-fiber net gain exceeding 10 dB across a bandwidth of approximately 140 nm is achieved, surpassing the gain window of a standard C-band EDFA. We furthermore demonstrate the capability to handle weak signals; input powers can range over six orders of magnitude while maintaining a low noise figure. We exploit these performance characteristics to amplify both optical frequency combs and coherent communication signals. This marks the first ultra-broadband, high-gain, continuous-wave amplification in a PIC, opening up new capabilities for next-generation optical communication, metrology, and sensing.

physics.optics↗

arXiv2023

Soliton Microcomb Generation in a III-V Photonic Crystal Cavity

Photonic crystals, material structures in which the dielectric function varies periodically in one, two, or three dimensions, can provide exquisite control over the propagation and confinement of light. By tailoring their band structure, exceptional optical effects can be achieved, such as slow light propagation or, through the creation of photonic bandgaps, optical cavities with both a high quality factor and a small mode volume. Photonic crystal cavities have been used to realize compact nano-lasers and achieve strong coupling to quantum emitters, such as semiconductor quantum dots, color centers, or cold atoms. A useful attribute of photonic crystals is the ability to create chirped mirrors. Chirping has underpinned advances in ultra-fast lasers based on bulk mirrors, but has yet to be fully exploited in integrated photonics, where it could provide a means to engineer otherwise unattainable dispersion profiles for a range of nonlinear optical applications, including soliton frequency comb generation. The vast majority of integrated resonators for frequency combs make use of microring geometries, where only waveguide width and height are varied to engineer dispersion. Generation of frequency combs has been demonstrated with one-dimensional photonic crystal cavities made of silicon nitride, but the low index contrast prevents formation of broad soliton combs. We overcome these challenges by using a photonic-crystal Fabry-Pérot resonator made of gallium phosphide, a material with a high refractive index and a Kerr nonlinearity 200 times larger than that of silicon nitride. We employ chirped photonic crystal mirrors to provide anomalous dispersion. With subharmonic pulsed pumping at an average power of 23.6 mW, we are able to access stable dissipative Kerr frequency combs. We demonstrate soliton formation with a 3-dB bandwidth of 3.0 THz, corresponding to a pulse duration of 60 fs.

physics.optics↗

arXiv2022

Electron Emission Regimes of Planar Nano Vacuum Emitters

Recent advancements in nanofabrication have enabled the creation of vacuum electronic devices with nanoscale free space gaps. These nanoelectronic devices promise the benefits of cold-field emission and transport through free-space, such as high nonlinearity and relative insensitivity to temperature and ionizing radiation, all the while drastically reducing the footprint, increasing the operating bandwidth and reducing the power consumption of each device. Furthermore, planarized vacuum nanoelectronics could easily be integrated at scale similar to typical micro and nanoscale semiconductor electronics. However, the interplay between different electron emission mechanisms from these devices are not well understood, and inconsistencies with pure Fowler-Nordheim emission have been noted by others. In this work, we systematically study the current-voltage characteristics of planar vacuum nano-diodes having few-nanometer radii of curvature and free-space gaps between the emitter and collector. By investigating the current-voltage characteristics of nearly identical diodes fabricated from two different materials and under various environmental conditions, such as temperature and atmospheric pressure, we were able to clearly isolate three distinct emission regimes within a single device: Schottky, Fowler-Nordheim, and saturation. Our work will enable robust and accurate modeling of vacuum nanoelectronics which will be critical for future applications requiring high-speed and low-power electronics capable of operation in extreme conditions.

physics.app-ph↗

arXiv2020

Refractory doped titanium nitride nanoscale field emitters

Refractory materials exhibit high damage tolerance, which is attractive for the creation of nanoscale field-emission electronics and optoelectronics applications that require operation at high peak current densities and optical intensities. Recent results have demonstrated that the optical properties of titanium nitride, a refractory and CMOS-compatible plasmonic material, can be tuned by adding silicon and oxygen dopants. However, to fully leverage the potential of titanium (silicon oxy)nitride, a reliable and scalable fabrication process with few-nm precision is needed. In this work, we developed a fabrication process for producing engineered nanostructures with gaps between 10 and 15 nm, aspect ratios larger than 5 with almost 90° steep sidewalls. Using this process, we fabricated large-scale arrays of electrically-connected bow-tie nanoantennas with few-nm free-space gaps. We measured a typical variation of 4 nm in the average gap size. Using applied DC voltages and optical illumination, we tested the electronic and optoelectronic response of the devices, demonstrating sub-10-V tunneling operation across the free-space gaps, and quantum efficiency of up to 1E-3 at 1.2 μm, which is comparable to a bulk silicon photodiode at the same wavelength. Tests demonstrated that the titanium silicon oxynitride nanostructures did not significantly degrade, exhibiting less than 5 nm of shrinking of the average gap dimensions over few-μm^2 areas after roughly 6 hours of operation. Our results will be useful for developing the next generation of robust and CMOS-compatible nanoscale devices for high-speed and low-power field-emission electronics and optoelectronics applications.

physics.app-ph↗

arXiv2019

Light Phase Detection with On-Chip Petahertz Electronic Networks

Ultrafast light-matter interactions lead to optical-field-driven photocurrents with an attosecond-level temporal response. These photocurrents can be used to detect the carrier-envelope-phase (CEP) of short optical pulses, and could be utilized to create optical-frequency, petahertz (PHz) electronics for information processing. Despite recent reports on optical-field-driven photocurrents in various nanoscale solid-state materials, little has been done in examining the large-scale integration of these devices. In this work, we demonstrate enhanced, on-chip CEP detection via optical-field-driven photocurrent in a monolithic array of electrically-connected plasmonic bow-tie nanoantennas that are contained within an area of hundreds of square microns. The technique is scalable and could potentially be used for shot-to-shot CEP tagging applications requiring orders of magnitude less pulse energy compared to alternative ionization-based techniques. Our results open new avenues for compact time-domain, on-chip CEP detection, and inform the development of integrated circuits for PHz electronics as well as integrated platforms for attosecond and strong-field science.

physics.optics↗