arXiv subjects

Ahmad Awada

Publications and source records attributed to Ahmad Awada.

11 recordsLinked to original sources

arXiv2024

RACH-less Handover with Early Timing Advance Acquisition for Outage Reduction

For fifth-generation (5G) and 5G-Advanced networks, outage reduction within the context of reliability is a key objective since outage denotes the time period when a user equipment (UE) cannot communicate with the network. Earlier studies have shown that in the experimental high mobility scenario considered, outage is dominated by the interruption time that stems from the random access channel (RACH)-based handover process from the serving cell to the target cell. A handover by itself is a necessary mobility process to prevent mobility failures and their associated outage. This paper proposes a RACH-less handover signaling scheme for the 3rd Generation Partnership Project (3GPP) conditional handover (CHO) mechanism. The proposed scheme exploits the decoupling between the CHO preparation and execution phases to establish initial synchronization between the UE and the target cell through an early acquisition of the timing advance. This significantly curtails the RACH process and therefore the handover interruption time. Results based on a system-level simulation-based mobility study have shown that the proposed scheme significantly reduces the outage and its constituent handover interruption time relatively by 18.7% and 43.2%, respectively.

cs.NI↗

arXiv2023

Mobility Performance Analysis of RACH Optimization Based on Decision Tree Supervised Learning for Conditional Handover in 5G Beamformed Networks

In 5G cellular networks, frequency range 2 (FR2) introduces higher frequencies that cause rapid signal degradation and challenge user mobility. In recent studies, a conditional handover procedure has been adopted as an enhancement to baseline handover to enhance user mobility robustness. In this article, the mobility performance of conditional handover is analyzed for a 5G mm-wave network in FR2 that employs beamforming. In addition, a resource-efficient random access procedure is proposed that increases the probability of contention-free random access during a handover. Moreover, a simple yet effective decision tree-based supervised learning method is proposed to minimize the handover failures that are caused by the beam preparation phase of the random access procedure. Results have shown that a tradeoff exists between contention-free random access and handover failures. It is also seen that the optimum operation point of random access is achievable with the proposed learning algorithm for conditional handover. Moreover, a mobility performance comparison of conditional handover with baseline handover is also carried out. Results have shown that while baseline handover causes fewer handover failures than conditional handover, the total number of mobility failures in the latter is less due to the decoupling of the handover preparation and execution phases.

cs.NI↗

arXiv2023

Conditional Handover Modelling for Increased Contention Free Resource Use in 5G-Advanced

This paper elaborates on Conditional Handover (CHO) modelling, aimed at maximizing the use of contention free random access (CFRA) during mobility. This is a desirable behavior as CFRA increases the chance of fast and successful handover. In CHO this may be especially challenging as the time between the preparation and the actual cell change can be significantly longer in comparison to non-conditional handover. Thus, new means to mitigate this issue need to be defined. We present the scheme where beam-specific measurement reporting can lead to CFRA resource updating prior to CHO execution. We have run system level simulations to confirm that the proposed solution increases the ratio of CFRA attempts during CHO. In the best-case scenario, we observe a gain exceeding 13%. We also show how the average delay of completing the handover is reduced. To provide the entire perspective, we present at what expense these gains can be achieved by analyzing the increased signaling overhead for updating the random access resources. The study has been conducted for various network settings and considering higher frequency ranges at which the user communicates with the network. Finally, we provide an outlook on future extensions of the investigated solution.

cs.NI↗

arXiv2022

On The Modelling and Performance Analysis of Lower Layer Mobility in 5G-Advanced

One of upcoming mobility enhancements in 5G-Advanced networks is to execute handover based on Layer 1 (L1) measurements using the so called lower layer mobility procedure. In this paper, we provide a system model for lower layer mobility procedure and we evaluate it against existing higher layer mobility procedures, such as baseline and conditional handover, using system level simulations. The benefits and drawbacks of lower layer mobility procedure are analyzed and compared against higher layer handover mechanisms using the relevant mobility key performance indicators. It has been shown that lower layer mobility procedure outperforms the existing handover mechanisms with respect to radio communication reliability at the expense of higher number of handovers and ping-pongs. To tackle these drawbacks, additional filtering for the L1 measurements used in handover decision is introduced to reduce the fluctuations caused by fast fading and measurement errors. Moreover, lower layer mobility procedure is enhanced with dynamic switching mechanism enabling the UE to change cells without being reconfigured by the network. The evaluations have shown that the introduction of such techniques is beneficial in reducing the number of ping-pongs and signaling overhead at the expense of an increase in the delay to react to rapid signal degradation and resource reservation overhead, respectively.

cs.NI↗

arXiv2022

On the Analysis and Optimization of Fast Conditional Handover with Hand Blockage for Mobility

Although frequency range 2 (FR2) systems are an essential part of 5G-Advanced and future 3GPP releases, the mobility performance of multi-panel user equipment (MPUE) with hand blockage is still an area open for research and standardization. In this article, a comprehensive study on the mobility performance of MPUE with hand blockage is performed for conditional handover (CHO) and its potential enhancement denoted by fast conditional handover (FCHO). In contrast to CHO, in FCHO the MPUE can reuse earlier target cell preparations after each handover to autonomously execute subsequent handovers. This saves both the signaling overhead associated with the reconfiguration and re-preparation of target cells after each handover and reduces mobility failures. Results have shown that FCHO offers considerable mobility performance gains as compared to CHO for different hand blockage cases that are dependent on the hand position around the MPUE. For the worst-case hand blockage scenario, it is seen that mobility failures reduce by 10.5% and 19.3% for the 60 km/h and 120 km/h mobility scenarios, respectively. This gain comes at the expense of reserving the handover resources of an MPUE for a longer time given that the target cell configurations are not necessarily released after each handover. In this article, the longer resource reservation problem in FCHO is analysed and three different resource reservation optimization techniques are introduced. Results have shown that these optimization techniques not only reduce the resource reservation time but also significantly reduce the signaling overhead at the possible expense of a tolerable degradation in mobility performance.

cs.NI↗

arXiv2022

On the Modeling and Analysis of Fast Conditional Handover for 5G-Advanced

Conditional handover (CHO) is a state-of-the-art 3GPP handover mechanism used in 5G networks. Although it improves mobility robustness by reducing mobility failures, the decoupling of the handover preparation and execution phases in CHO significantly increases the signaling overhead. For 5G-Advanced networks, fast CHO (FCHO) is a recent 3GPP proposal that offers a practical solution whereby the user equipment (UE) can reuse earlier target cell preparations after each handover to autonomously execute subsequent handovers. This saves the signaling overhead associated with the reconfiguration and repreparation of target cells after each handover. In this paper, a comprehensive study on the mobility performance of FCHO with respect to mobility failures and signaling overhead in frequency range 2 (FR2) is carried out. In particular, the performance of FCHO is compared with CHO for two different multi-panel UE (MPUE) schemes. Results show that FCHO substantially reduces the signaling overhead of CHO, while at the same time it also reduces mobility failures due to faster triggering of the handover that is achieved by saving the preparation delay.

cs.NI↗

arXiv2022

Conditional Handover in 5G: Principles, Future Use Cases and FR2 Performance

This paper elaborates on Conditional Handover (CHO) - a mobility feature designed in Release 16 of 3rd Generation Partnership Project (3GPP), aimed at improving the reliability of handover in cellular networks. CHO has turned out to be a successful feature and attracted several other areas of mobile networks, where increased reliability is also desirable (e.g. Non-Terrestrial Networks or Integrated Access Backhaul). This paper explains the principles of CHO, describes its future use in vertical areas and provides performance results showing the gains CHO may offer to 5G systems at higher frequency bands. Our simulative analysis was focused on the handover in Frequency Range 2 (FR2) and CHO recovery procedure. Results have shown that also at higher frequencies CHO can substantially reduce the mobility failures compared to baseline handover of Release 15. Moreover, it has been verified that CHO recovery can be a useful means to allow faster reconnection to the network after a failure. In certain scenarios CHO Recovery usage ratio was found to exceed 80%. The paper also outlines the future research and standardization directions in the area of CHO which appears to be a solid candidate for further development in 3GPP Release 18 and beyond.

cs.NI↗

arXiv2022

Analysis and Performance Evaluation of Mobility for Multi-Panel User Equipment in 5G Networks

Frequency Range 2 (FR2) has become an integral part of 5G networks to fulfill the ever increasing demand for user data throughput. However, radio signals in FR2 experience high path and diffraction loss in mobile environments. To address this issue, multi-panel user equipment (MPUE) is adopted for FR2 whereby multiple antenna panels are placed on the UE body to leverage gains from antenna directivity. In contrast to traditional UEs with isotropic radiation patterns, signal measurements of cells in the network may not be available on all panels simultaneously for MPUE, which may result in outdated signal measurements that affect the reliability of mobility decisions. In this paper, we investigate the mobility performance of two different MPUE schemes following different paradigms for signal measurement and compare their performance with traditional UEs. This performance evaluation is based in multi-beam 5G networks operating in FR2 where there are multiple simultaneously active beams per cell to realize the high throughput requirements. Furthermore, an in-depth analysis of the mobility performance is carried out to determine the best mobility parameter combinations for the different MPUE schemes. Results have shown that both MPUE schemes offer considerable mobility performance gains as compared to traditional UEs. Moreover, it is seen that the MPUE schemes require different mobility parameter settings for the best mobility performance.

cs.NI↗

arXiv2019

RACH Optimization with Decision Tree Based Supervised Learning for Conditional Handover in 5G Beamformed Systems

Higher frequencies that are introduced in 5G networks cause rapid signal degradation and challenge user mobility. In recent studies, a conditional handover procedure has been adopted for 5G networks to enhance user mobility robustness. In this paper, mobility performance of the conditional handover is analysed for 5G mm-Wave systems with beamforming. In addition, a resource efficient random access procedure is proposed that increases the chance of contention-free random access during handover, which reduces signaling and interruption time. Moreover, simple, yet, effective decision tree based supervised learning method is proposed to minimize the handover failures that are caused by beam preparation phase of random access procedure. Results reveal the trade-off between contention free random access and handover failures. It is also shown that the optimum operation point of random access is achievable with proposed learning algorithm for conditional handover.

cs.NI↗

arXiv2019

Low Complexity Channel Model for Mobility Investigations in 5G Networks

Millimeter-wave has become an integral part of 5G networks to meet the ever-increasing demand for user data throughput. Employing higher carrier frequencies introduces new challenges for the propagation channel such as higher path loss and rapid signal degradations. On the other hand, higher frequencies allow deployment of small-sized antenna elements that enable beamforming. To investigate user mobility under these new propagation conditions, a proper model is needed that captures spatial and temporal characteristics of the channel in beamformed networks. Current channel models that have been developed for 5G networks are computationally inefficient and lead to infeasible simulation time for most user mobility simulations. In this paper, we present a simplified channel model that captures the spatial and temporal characteristics of the 5G propagation channel and runs in feasible simulation time. To this end, coherence time and path diversity originating from fully fledged Geometry based Stochastic Channel Model (GSCM) are analyzed and adopted in Jakes channel model. Furthermore, the deviation of multipath beamforming gain from single ray beamforming gain is analyzed and a regression curve is obtained to be used in the system-level simulations. We show through simulations that the proposed simplified channel model leads to mobility results comparable to Jakes model for high path diversity. Moreover, the multi-path beamforming gain increases the interference in the system and in turn number of mobility failures.

cs.NI↗

arXiv2015

SINR Model with Best Server Association for High Availability Studies of Wireless Networks

The signal-to-interference-and-noise ratio (SINR) is of key importance for the analysis and design of wireless networks. For addressing new requirements imposed on wireless communication, in particular high availability, a highly accurate modeling of the SINR is needed. We propose a stochastic model of the SINR distribution where shadow fading is characterized by random variables. Therein, the impact of shadow fading on the user association is incorporated by modification of the distributions involved. The SINR model is capable to describe all parts of the SINR distribution in detail, especially the left tail which is of interest for studies of high availability.

cs.NI↗