Reflected Iron Line From a Source Above a Kerr Black Hole Accretion Disc

Abstract

In this paper we present a fully relativistic approach to modelling both the continuum emission and the reflected fluorescent iron line from a primary X-ray source near a Kerr black hole. The X-ray source is located above an accretion disc orbiting around the black hole. The source is assumed to be a static point source located on an arbitrary position above the disc, on or off the axis of rotation. We carry out Monte Carlo simulations in order to estimate the iron line spectrum as well as its equivalent width. Because of the gravitational lensing effect, an enhancement of the iron line is expected when the primary source is located close to the central black hole. We find that for a source located on the axis of rotation the enhancement is relatively modest. An observer at inclination 30 degrees would measure an equivalent width of ~300eV in the extreme case of a maximally rotating black hole and a source located at height 1.5 gravitational radius from the centre. This corresponds to an equivalent width enhancement factor of about 2 compared to the classical value where no lensing effect comes into play. However, when allowing the source to be located off the axis of rotation, much stronger enhancement can be obtained. In the extreme case of a maximally rotating black hole and a source located just above the approaching side of the disc, an observer at inclination 30d egrees could measure an equivalent width as high as ~1.5 keV (i.e. ~10 times the classical value). We also find that observers located at high inclination angles observe a stronger line than observers at low inclination angles.