arXiv Science⌕ Search

arXiv · 2611.11524

Extreme temperatures characterization of Al0.6Ga0.4N channel HEMT

Abstract

In this work, we fabricate and characterize ultra-wide bandgap Al0.6Ga0.4N channel HEMTs with Pt/Au gate under a wide temperature range of 20 K to 650 K. The devices retained robust modulation capability throughout the measurement, with excellent on/off ratio of 9.7 * 107 and 6.4 * 107 under 20 K and 650 K. The DC output IV measurement was performed, with Id,max of a device with Lsd = 9 μm measured to be 240 mA/mm and 120 mA/mm under 20 K and 650 K. In addition, low drain and leakage were observed in multiple devices, and the device robustness was evaluated under room temperature after the extreme temperature measurement with minimal degradation observed in Id,max and Rsheet. Moreover, transfer I-V characteristics of the Al0.6Ga0.4N channel HEMTs have also been studied, where a relatively small Vth shift was observed. TLM measurement and transconductance analysis both indicate the presence of weak temperature dependent scattering mechanisms in the device channel. The subthreshold swing (SS) was calculated and observed to increase parallelly to SSideal under investigated temperature, indicates a robust gate structure. Finally, the on/off ratio and Ig of the 9 μm Lsd device were benchmarked and compared favorably against other reported results. While the results offer insight into the extreme temperature performance of AlGaN channel HEMT with Al composition higher than 50%, it also establishes AlGaN channel HEMT as a promising candidate for extreme temperature electronic applications.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Shuwen Xie, Jacklyn Zhu, Swarnav Mukhopadhyay, Yi-Chen Liu, Shubhra Pasayat, Savannah Eisner, Chirag Gupta. 2026-11-08. Extreme temperatures characterization of Al0.6Ga0.4N channel HEMT. https://arxiv.science/abs/2611.11524

Citations retain the original authors and DOI and include this site’s record URL. If this discovery service contributed to your research, you can also cite arXiv Science by Indiciae: BibTeX · RIS.

KEEP EXPLORING

Related papers

Terahertz emission from $α$-W/CoFe epitaxial spintronic emitters

We report efficient terahertz (THz) generation in epitaxial $α$-W/Co$_{60}$Fe$_{40}$ spintronic emitters. Two types of emitters have been investigated; epitaxial $α$-W$(110)$/Co$_{60}$Fe$_{40}(110)$ and $α$-W$(001)$/Co$_{60}$Fe$_{40}(001)$ deposited on single crystalline Al$_{2}$O$_{3}$($11\bar{2}0$) and MgO($001$) substrates, respectively. First principle calculations of the electronic band structure at the W$(001)$ surface reveal Dirac-type surface states, similar to that reported previously for the W$(110)$ surface. The generated THz radiation is about $10\%$ larger for $α$-W$(110)$/Co$_{60}$Fe$_{40}(110)$ grown on single crystalline Al$_{2}$O$_{3}$($11\bar{2}0$), which is explained by the fact that the $α$-W$(110)$/Co$_{60}$Fe$_{40}(110)$ interface for this emitter is more transparent to the spin current due to the presence of Ångstr\" om-scale interface intermixing at the W/CoFe interface. Our results also reveal that the generation of THz radiation is larger when pumping with the laser light from the substrate side, which is explained by a larger part of the laser light due to interference effects in the film stack being absorbed in the ferromagnetic Co$_{60}$Fe$_{40}$ layer in this measurement configuration.

physics.app-ph↗

Measurement and Modeling of Structure-Induced Surface Scattering on Terahertz Channel

As terahertz (THz) frequencies emerge as promising candidates for next-generation wireless networks, accurate characterization of propagation mechanisms in indoor/outdoor environments becomes essential for system design and performance optimization. This article presents an experimental and theoretical investigation of structure-induced indoor surface scattering on THz channels, examining how material properties and structural configurations jointly govern channel power and angular distribution. Six representative indoor surfaces are characterized, revealing that intrinsic structural inhomogeneity - particularly the quasi-periodic earlywood-latewood arrangement in pine wood - induces measurable angular scattering whose dominant lobes and angular shifts are reproduced by a beam-propagation modeling (BPM) framework. Material-covered surface configurations are further investigated, demonstrating that thin dielectric covering layers can substantially modify reflection characteristics through thickness- and frequency- dependent thin-film interference effects. Wide-angle bistatic measurements in a conference room show that folded curtains broaden the measured angular distribution of detectable received power. These findings suggest that structure-induced surface scattering mechanisms may provide scattering-assisted propagation opportunities for indoor non-line-of-sight THz scenarios.

physics.app-ph↗

Thermoelectric properties of metal-semiconductor percolation composites

We analyze the thermoelectric response of composite materials comprising homogeneous semiconductor hosts with randomly distributed metallic inclusions. We demonstrate that the properties of such materials are strongly affected by the percolation transition (with background conductivity). We show that in the vicinity of the percolation threshold, the power factor and the thermoelectric figure of merit strongly depend on both the concentration and arrangement of inclusions. Finally, we identify promising regimes for enhancing the power factor in realistic composites.

physics.app-ph↗