arXiv Science⌕ Search

arXiv · 2610.00145

Movable-Element STAR-RIS for Integrated Sensing and Communication: Architectures, Opportunities, and Practical Challenges

Abstract

Simultaneously transmitting and reflecting reconfigurable intelligent surfaces (STAR-RISs) extend conventional reflecting-only surfaces by enabling controllable full-space propagation. Yet, once deployed, the physical locations of their elements remain fixed, leaving the surface geometry unable to adapt to users, sensing targets, blockage, or near-field focusing conditions. This article develops a system-level perspective on movable-element STAR-RIS (ME--STAR--RIS) for integrated sensing and communication (ISAC), where the surface jointly reconfigures its electromagnetic response and the physical positions of its elements. We explain how geometric reconfiguration can reshape the effective aperture, spatial correlation, interference nulls, and sensing illumination while preserving STAR-RIS full-space operation. A two-timescale control architecture separates relatively slow element motion from fast beamforming and transmission/reflection control. A 100-realization illustrative case study compares ME--STAR--RIS with an otherwise identical fixed STAR-RIS under a passive coupled transmission/reflection response. The results show a substantially improved sampled communication--sensing tradeoff and, importantly, a rapid saturation of the rate gain with modest element travel. We conclude with representative use cases, implementation constraints, and a research roadmap covering mobility overhead, channel acquisition, mutual coupling, near-field operation, hardware impairments, and learning-assisted predictive control.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Wali Ullah Khan, Muhammad Adil. 2026-09-10. Movable-Element STAR-RIS for Integrated Sensing and Communication: Architectures, Opportunities, and Practical Challenges. https://arxiv.science/abs/2610.00145

Citations retain the original authors and DOI and include this site’s record URL. If this discovery service contributed to your research, you can also cite arXiv Science by Indiciae: BibTeX · RIS.

KEEP EXPLORING

Related papers

MASQ: Measurement-Adaptive Sampling for Near-Clifford Quantum Error Correction Circuits

Classical sampling of quantum error correction (QEC) circuits supports fault-tolerant protocol evaluation, but estimating rare logical failures requires many independent shots. Frame-active-state simulators isolate non-stabilizer information in a dense active-state vector, yet dense-state processing remains exponential in the active width. This paper presents MASQ, an exact measurement-adaptive sampler for near-Clifford QEC circuits based on selective materialization of non-Clifford rotations. At each measurement boundary, MASQ materializes only rotations in a measurement-relevant closure capturing direct and indirect non-commuting dependencies, deferring the rest to limit active-state expansion. Stabilizer-assisted elimination further removes rotations certified to be invisible to all future measurements. A circuit-dependent schedule is computed once and shared across shots, while adaptive caching of conditional Born probabilities and batched execution reduce repeated sampling work while preserving the measurement-record distribution. Across 19 QEC benchmarks, MASQ reduces peak active width by up to 40 active virtual qubits and achieves up to 8,098-fold CPU throughput speedup over Clifft on multi-round circuits.

cs.ET↗

Automated-Truck Penetration Shapes Human Drivers' Car-Following Margins Near Motorway Ramps: A Driving-Simulator Study

Automated-vehicle dedicated lanes (AVDLs) are proposed as transitional infrastructure for mixed traffic, but their effect near ramps, and that of automated trucks, on the human drivers sharing the road has rarely been observed. In a mixed-design driving-simulator experiment, 63 drivers were assigned to one of four layouts (an AVDL extending beyond, coinciding with, or ending inside a 1.5-km ramp weaving section, or no AVDL) and drove at four automated-truck penetration levels from 20% to 80%. Linear mixed-effects models with participant random effects and multiplicity control were used. Higher penetration reduced the share of car-following time at gaps below 1.5 s from 28.5% to 18.1% (Holm-adjusted p = .006). This was explained by leader composition: drivers spent 8% of following time behind a truck at 20% penetration and 48% at 80%, kept longer gaps behind trucks, and did not change their gaps within leader type. AVDL layout had no detectable effect on safety margins, rear-end conflict rates, travel time or speed (differences bounded within plus or minus 5 s per section) and no significant effect on workload. Between-driver differences accounted for 52% to 77% of the variance in the main outcomes. Mixed-traffic models should therefore represent human car-following as leader-type-dependent and heterogeneous.

cs.ET↗

Countering Anion Inhibition of Laccase Electron Transfer: Electrostatic Design, Charge-Transfer Dynamics on a Superconducting Quantum Processor, and Its Limits

Hydroxide at neutral-to-alkaline pH and halides inhibit fungal laccases and limit their use in wastewater treatment. From GFN2-xTB cluster models of Trametes versicolor laccase (PDB 1GYC) we build a four-site Hubbard model of the His454-T3A-T3B-His452 junction of the trinuclear copper cluster and execute its charge-transfer dynamics on the Euro-Q-Exa quantum computer (IQM, 8 qubits, Trotterized circuits with Pauli twirling; 726 jobs). The charge-transfer frequency is measured to 3-5 meV, reproducibly over nine days and across changes of the device qubit map: hydroxide raises the charge-transfer energy of the crystal-geometry model by 92.0 +/- 2.2 meV (exact 87) and exceeds fluoride by 10.1 +/- 1.8 meV. A screen of charged probes in three dielectric models identifies Y116E; in the probe model the hardware resolves a reduction of the hydroxide penalty by 74 +/- 7 meV and of the halide penalty by 64 +/- 5 meV, acting on the site-energy gap rather than on the coupling. A real Glu116 (five conformers) with PROPKA protonation states and the coupled Asp456 gives a realistic reduction of 10-30 meV, with the same sign in 28 of 28 model combinations; the direction and ordering are the prediction, rate factors only an illustration. Scanning the on-site repulsion reverses the sign of the hydroxide effect, and a one-electron Hartree model reproduces the reversal: the measured dynamics is effectively single-particle. On a Fermi-Hubbard benchmark the hardware does not resolve electron correlation; it would need a contrast loss below 0.13 percent per CZ gate instead of the measured 0.34-0.54 percent.

cs.ET↗